LG LASC27, LAS260B User Manual

OWNER’S MANUAL

Sound Bar

Please read this manual carefully before operating
your set and retain it for future reference.

MODELS
LAS260B
LASC27

*MFL69466666*

www.lg.comCopyright © 2016~2017 LG Electronics Inc. All rights reserved.

Getting Started2

Safety Information

1

Getting Started

CAUTION: TO REDUCE THE RISK OF ELECTRIC

SHOCK DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE REFER

SERVICING TO QUALIFIED SERVICE PERSONNEL.

WARNING: This product contains chemicals
knownto the State of California to cause cancer
and birth defects or other reproductive harm. Wash

hands after handling.

WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK
HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN
OR MOISTURE.

CAUTION: The apparatus shall not be exposed to
water (dripping or splashing) and no objects lled
with liquids, such as vases, shall be placed on the
apparatus.

WARNING: Do not install this equipment in a
conned space such as a book case or similar unit.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This lightning ash with arrowhead
symbol within an equilateral
triangle is intended to alert the
user to the presence of uninsulated
dangerous voltage within the
product’s enclosure that may be of
sufcient magnitude to constitute
a risk of electric shock to persons.

The exclamation point within an
equilateral triangle is intended
to alert the user to the presence
of important operating and
maintenance (servicing)
instructions in the literature
accompanying the product.

CAUTION: Do not use high voltage products around
this product. (ex. Electrical swatter) This product may
malfunction due to electrical shock.

CAUTION: No naked ame sources, such as lighted
candles, should be placed on the apparatus.

CAUTION: Do not block any ventilation openings.
Install in accordance with the manufacturer’s
instructions.
Slots and openings in the cabinet are provided
for ventilation and to ensure reliable operation of
the product and to protect it from over heating.
The openings shall be never be blocked by placing
the product on a bed, sofa, rug or other similar
surface. This product shall not be placed in a built­in installation such as a bookcase or rack unless
proper ventilation is provided or the manufacturer’s
instruction has been adhered to.

CAUTION concerning the Power Cord

Check the specication page of this owner’s manual
to be certain of the current requirements. Do not
overload wall outlets. Overloaded wall outlets, loose
or damaged wall outlets, extension cords, frayed
power cords, or damaged or cracked wire insulation
are dangerous. Any of these conditions could result
in electric shock or re. Periodically examine the
cord of your device, and if its appearance indicates
damage or deterioration, unplug it, discontinue use of
the device, and have the cord replaced with an exact
replacement part by an authorized service center.
Protect the power cord from physical or mechanical
abuse, such as being twisted, kinked, pinched, closed
in a door, or walked upon. Pay particular attention
to plugs, wall outlets, and the point where the cord
exits the device. The Power Plug is the disconnecting
device. In case of an emergency, the Power Plug must
remain readily accessible.

This device is equipped with a portable battery or
accumulator.

Safety way to remove the battery from the
equipment: Remove the old battery or battery pack,

follow the steps in reverse order than the assembly.
To prevent contamination of the environment and
bring on possible threat to human and animal health,
the old battery or the battery put it in the appropriate
container at designated collection points. Do not
dispose of batteries or battery together with other
waste. It is recommended that you use local, free
reimbursement systems batteries and accumulators.
The battery should not be exposed to excessive heat
such as sunshine, re or the like.

IMPORTANT SAFETY
INSTRUCTIONS

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this device near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as
radiators, heat registers, stoves, or other device
(including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.

10. Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the device.

11. Only use attachments/accessories specified by
the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the device. When a cart is used, use caution when
moving the cart/device combination to avoid
injury from tip-over.

Getting Started 3

13. Unplug this device during lightning storms or
when unused for long periods of time.

14. Refer all servicing to qualified service personnel.
Servicing is required when the device has been
damaged in any way, such as power-supply cord
or plug is damaged, liquid has been spilled or
objects have fallen into the device, the device
has been exposed to rain or moisture, does not
operate normally, or has been dropped.

1

Getting Started

Getting Started4

FCC Compliance Statement

This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

1

and

Getting Started

(2) This device must accept any interference received,
including interference that may cause undesired
operation.

NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:

yReorient or relocate the receiving antenna.

yIncrease the separation between the equipment

and receiver.

yConnect the equipment into an outlet on a

circuit different from that to which the receiver is
connected.

yConsult the dealer or an experienced radio/TV

technician for help.

CAUTION : Any changes or modications not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
this equipment.

FCC WARNING: This equipment may generate or
use radio frequency energy. changes or modications
to this equipment may cause harmful interference
unless the modications are expressly approved
in the instruction manual. The user could lose
the authority to operate this equipment if an
unauthorized change or modication is made.

FCC RF Radiation Exposure Statement : This

equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This equipment should be installed and operated
with minimum distance 20 cm (7.8 inches) between
the antenna and your body. Users must follow the
specic operating instructions for satisfying RF
exposure compliance.

CAUTION: Regulations of the FCC and FAA prohibit
airborne operation of radio-frequency wireless
devices because their signals could interfere with
critical aircraft instruments.

Responsible Party :

LG Electronics USA, Inc. 1000 Sylvan Avenue
Englewood Cliffs, NJ 07632
TEL. : [phone]

Table of Contents

Table of Contents 5

1 Getting Started

2 Safety Information
6 Unique features
6 – Auto power down
6 – Portable In
6 Introduction
6 – Symbols used in this manual
6 Accessories
7 Remote control
8 Front panel
8 Rear panel
9 Installing the sound bar
10 Mounting the main unit on a wall

2 Connecting

12 Connecting to your TV
12 – Using an OPTICAL cable
13 Optional equipment connection
13 – OPTICAL IN connection
13 – PORT. IN connection

3 Operating

14 Operations
14 – DRC (Dynamic range control)
14 – Turn off the sound temporarily
14 – Using your TV remote control
15 – AUTO POWER On/Off
15 – Auto function change
16 Using BLUETOOTH® technology
16 – Listening to music stored on the

BLUETOOTH devices
17 Sound adjustment
17 – Setting the surround mode

4 Troubleshooting

18 Troubleshooting
18 – General
19 – NOTES to use wireless

5 Appendix

20 Trademarks and licenses
21 Specifications
22 Maintenance
22 – Handling the unit

1

2

3

4

5

Getting Started6

Unique features

Auto power down

1

Getting Started

This unit supports to turn off by itself for saving
energy consumption.

Portable In

Listen to music from your portable device. (MP3
player, Notebook, Smart phone, etc..)

Introduction

Symbols used in this manual

Note

,

Indicates special notes and operating features.

Caution

>

Indicates cautions for preventing possible damages
from abuse.

Accessories

Please check and identify the supplied accessories.

Remote control (1) Batteries (2)

Wall Bracket Install
guide (1)

Optical cable (1)

Wall bracket (1)

Getting Started 7

Remote control

Replacement of battery

• • • • • • • • • • • • • •a • • • • • • • • • • • • •

(Power): Switches the unit ON or OFF.

1

F : Changes input sources.

STANDARD : Selects STANDARD sound effect

VOICE : Selects VOICE sound effect

CINEMA : Selects CINEMA sound effect

(Mute) : Mutes the sound.

VOL o/p : Adjusts speaker volume.

• • • • • • • • • • • • • •b • • • • • • • • • • • • •

DRC ON/OFF : Turns on or off DRC function. (Refer
to the page 14.)

AUTO POWER ON/OFF: Turns on or off AUTO
POWER function. (Refer to the page 15.)

: This button is not used.

*

1

Getting Started

Remove the battery cover on the rear of the Remote
Control, and insert two (size AAA) battery with
and matched correctly.