LG GR-B207WVQ, GR-B207WLQ User Manual

Introduction

Installation

Operation

Suggestion on food storage

Care and maintenance

Table of contents

Entry	3
Important safety instruction	3
Identification of parts	4
Where to install	5
Door removal	6
Door replacement	7
Height adjustment	7
when the freezer door does not align with the height of the refrigerator door	7

Starting	8
Adjusting the temperatures and functions	8
Refreshment center (Applicable to some models only)	10
Wine holder	11
Ice making	11
Deodorizer(Applicable to some models only)	11
Egg box	12
Humidity control in the vegetable compartment	12
Convert into a vegetable or meat compartment	12
(Applicable to some models only)
Location of foods	13
Storing foods	14
How to dismantle parts	15
General information	16
Cleaning	16
Trouble shooting	17

2

Introduction

Entry

The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers are unique to this unit and notavailable to oth ers. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your receipt here.

Date of purchase	:
Dealer purchased from	:
Dealer address	:
Dealer phone no.	:
Model no.	:
Serial no.	:

Important safety instruction

This refrigerator must be properly installed and located in accordance with the installation instructions before it is used.

Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet.

When moving your appliance away from the wall, be careful not to roll over or damage the power cord.

After your refrigerator is in operation, do not touch the cold surfaces in the freezer compartment, particularly when hands are damp or wet. Skin may adhere to these extremely cold surfaces.

Unplug the power cord from the power plug for cleaning or other cares. Never touch it with wet hands because you can get an electric shock or be hurt.

Never damage, process, severely bend, pull out, or twist power cord because power cord damage may cause a fire or electric shock. You have doubts on whether the appliance is properly grounded.

Never place glass products in the freezer because they may be broken when their inner matters are frozen.

The appliance is not intended for use by young children or infirm persons without supervision.

Young childeren should be supervised to ensure that they do not play with the appliance.

Never allow anyone to climb, sit, stand or hang on the refreshment center door. These actions may damage the refrigerator and even tip it over, causing severe personal injury.

Don’t use an If possible, connect the refrigerator to its own individual electrical outlet to prevent extension cord it and other appliances or household lights from causing an overload that could

cause a power outage.

Accessibility of The refrigerator-freezer should be so positioned that the supply plug is accessible Supply Plug fo rquick disconnection when accident happens.

Supply Cord If the supply cord is damaged, it must be replaced by the manufacturer or its

Replacement service agent or a similarly qualified person in order to avoid a hazard.

Warning Do not modify or extend the Power Cord length.

• It will cause electric shock or fire.

3

Introduction

Child entrapment

DANGER: Risk of child entrapment.

warning

Before you throw away your old refrigerator or freezer:

Take off the doors

Leave the shelves in place so that children may not easily climb inside.

The appliance is not intended for use by young children or infirm persons without

supervision.

Young children should be supervised to ensure that they do not play with the

appliance.

Don’t store

Don’t store or use gasoline or other flammable vapor and liquids in the vicinity of this

or any other appliance.

Grounding (Earthing)

In the event of an electric short circuit, grounding (earthing) reduces the risk of electric

shock by providing an escape wire for the electric current.

In order to prevent possible electric shock, this appliance must be grounded

improper use of the grounding plug can result in an electric shock. Consult a qualified

electrician or service person if the grounding instructions are not completely

understood, or if you have doubts on whether the appliance is properly grounded.

Identification of parts

Convert into a vegetable or meat compartment

NOTE

•If you find some parts missing from your unit, they may be parts only used in other models.

4

Installation
	Where to insfall
Select a good	1. Place your appliance where it is easy to
location		use.
	2.	Avoid placing the unit near heat sources,
		direct sunlight or moisture.
	3.	To ensure proper air circulation around the
		fridge -freezer, please maintain sufficient
		space on both the sides as well as top
		and maintain at least 2 inches (5 cm) from
		the rear wall.
	4.	To avoid vibrations, the appliance must be leveled.
	5.	Don't install the appliance below 5 . It may cause affect the performance.
Disposal of the	This appliance contains fluid (refrigerant, lubricant)and is made of parts and
old appliance	materials which are reusable and/or recyclable.
	All the important materials should be sent to the collection center of waste
	materialand can be reused after rework (recycling). For take back, please contact
	with thelocal agency.

5

			Installation
Warning	Door removal
	Electric Shock Hazard
	Disconnect electrical supply to refrigerator before installing.
	Failure to do so could result in death or serious
	injury.	serious
	If your access door is too narrow for the
	refrigerator remove the refrigerator door and		Lower
	pass the refrigerator laterally.		cover
Remove lower	Remove the lower cover by lifting upward.		Hinge
			cover
cover
Remove the	1) Loosen the hinge cover screws and remove	he
freezer	the cover.	Upper hinge	Upper
compartment		Keeper	hinge
door

2) Remove the keeper by rotating it to counter clockwise ( ) and then lifting the upper hinge up( ).

NOTE

•When removing the upper hinge, be careful that the door does not fall forwards.

3)Remove the freezer compartment door by

	lifting it upward.
		Lower hinge
Remove the	1) Loosen the hinge cover screws and remove	e
refrigerator	the cover. Remove connection wire,if any,
door	except for the earth line.	nection
		wires
	2) Remove keeper by rotating it clockwise ( )	Upper hinge	Keeper
	and then remove the upper hinge by	g
	lifting it up ( ).

3) Remove the refrigerator compartment door by lifting it up.

Pass the	Pass the refrigerator laterally through access
refrigerator	door as shown in the right figure.
	6

Installation

Door replacement

Mount them in the reverse sequence of removal after they pass through the access door.

Height adjustment

If the height of

lf the freezer compartment

If the freezer compartment

freezer compart-

door is lower than the refrig-

door is higher than the refrig-

ment door is

erator compartment door

erator compartment door

different from the

height of Refrig-

Level the door by inserting flat(-type)

Level the door by inserting flat(-type)

erator compart-

driver into the groove of the left

driver into the groove of the right

ment door

height adjusting screw and rotate it

height adjusting screw and rotate it

clockwise( ).

clockwise( ).

When the freezer door does not align with the height of the refrigerator door

Even if the height can not be aligned by using the height adjustment screw, insert the transparent sheet supplied with the product.

•Separate the door with the lower height, use the (+) type screwdriver to unscrew the screw at the bottom hinge as shown at Figure , insert the transparent sheet between the bottom hinge and the bottom bracket, and then fix it with the screw as shown at Figure .

•Insert more transparent sheets enough to align the height. (4 sheets ard supplied in total.)

	Bottom hinge Transparent sheet
	Bottom bracket
After leveling the	The refrigerator doors will close smoothly by heightening the front side by adjusting the
door height	height adjusting screw.If the doors do not close correctly,performance maybe
Next	1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly.

2.Install accessories such as the ice cube box, cover evaporating tray, etc., in their proper places. They are packed together to prevent possible damage during shipping.

3.Connect the power supply cord (or plug) to the outlet. Don't double up with other appliances on the same outlet.

7