LG AN-TP300 User Manual
OWNER’S MANUAL
Touch Pen
www.lg.com
(Brazil : www.lge.com)
AN-TP300
Please read this manual carefully before operating your set and retain it for future reference.
This owner's manual is only applicable to the PN57**, PH66**, PH/PN47** and PH/PN67** series.
For other models, see the TV owner's manual.
2
Touch Pen
Accessories
Power Button/Indicator LED
USB Charging Port
Touch Home Button
Touch pen tip switch
HomeHome
TouchTouch
1. Powering on
Press the Power button once.
The indicator LED of the pen will turn green.
2. Powering off
Press and hold the Power button for over 3 seconds and release it.
The indicator LED will turn off.
3. Power-saving
Idle for one minute (LED: green), after idle period (LED: turned off)
4. Charging Mode
Charging (LED: red), charging completed (LED: green)
If the Touch Pen needs charging, the red light will blinks.
5. After the Touch Pen has been charged for 1.5 hours, you can use it for approximately two hours.
This product can be connected to a TV or PC. You cannot connect this product to both the
TV and PC simultaneously, so please remove either of their wireless dongles. If a wired pen is
connected to the TV, please remove it.
In order to use this product on a PC, you must install the Pentouch program as described in
this manual. (If using a TV, the Pentouch program is not applicable.)
Pairing is connecting the Touch Pen and a dongle. After pairing, insert the dongle into the USB
port of a TV or PC to use the Touch Pen.
NOTE
Before Using
The picture may differ from the actual product.
AN-TD200
Indicator LED
Pentouch Dongle
(Separate purchase is needed.)
HomeHome
TouchTouch
AN-TP300
CD
Specifi cations, Precautions for Using Pentouch
Pentouch Software, Owner's Manual
New Tip (2EA) Charging Cable Touch Pen
USB Charging Port
Cradle
고
객
지
원
3
For a newly purchased or replaced Touch Pen, you need to pair it with the dongle again.
If the indicator LED is turned off, pairing has not been successful. Please try pairing again.
Once paired, the indicator LED will turn green when you press the Touch Home button.
Pairing is not possible when the battery is low.
If the Touch Pen does not work, reset the Touch Pen (see page 8) and try pairing again.
NOTE
Using The Touch Pen With A TV
XVE#LQ#4 XVE#LQ#5
Dongle
1
Connect the dongle to the USB port of the TV.
2
If the dongle is connected correctly, the dongle's indicator LED will turn on and a message will appear on the TV to indicate that the dongle is connected.
3
Follow the steps below to pair the dongle with the Touch Pen.
Check whether the red LED of the paired dongle is turned on.
Place the Touch Pen within 10 cm of the dongle.
Press the Power button of the Touch Pen once.
The indicator LED of the Touch Pen will turn green when pairing is complete.
Loading...