LG AN-BL100 User Manual

WIRELESS IR BLASTER

If you have the IR blaster installed, you can control the peripheral
devices connected to the TV with the LG TV remote app using the
Magic remote control or a smartphone.

PART DECSRIPTION

LED
Indicator

ENGLISH

IR BLASTER SETTING AND PAIRING

On/Off
switch

OFF ON

Pairing

PAIRING

Button

OJ

63#fp#0#:#p

78俋

83#fp

WARNING: This product contains chemicals known to the State of California
to cause cancer and birth defects or other reproductive harm.

after handling.

2

Wash hands

1. Within 7 meters(22 Feet) from the TV, Press the pairing button
on the IR blaster for about 2 seconds

2. The LED indicator of the IR blaster turns on and the pairing

status is displayed on the TV screen.

* If the paring failure message appears, reboot the IR blaster

and press the pairing button again.

3. When pairing is complete, install the IR blaster within 50 cm (1.5

feet) of the external device(s) within 45 degrees of the of the IR
sensor.
* Do not place any obstacles that may interfere the reception

between the IR blaster and the IR receiver of the external
device.

4. Set the Universal Control using the Magic remote control.

Input List  Set the Universal Control]

[

* Press the pairing button for 5 seconds or more to restart the

pairing.

* Do not throw or roll the IR blaster

.

OPERATING ENVIROMENT

1. If multiple set-top boxes and media devices are used or the
media device is in a place where the IR signal from the remote
cannot be received, the IR blaster transmits the IR signals to the
external devices.

ENGLISH

3