LG 47TS50MF-B Owner’s Manual
OWNER’S MANUAL
MONITOR SIGNAGE
Please read this manual carefully before operating the your set and
retain it for future reference.
MONITOR SIGNAGE MODELS
47TS50MF
www.lg.com
2
CONTENTS
ENGLISH
CONTENTS
ENG
3 INSTALLATION PREPARATION
3 Accessories
4 Mounting Holes
5 Portrait Layout
6 Storage Method for Panel Protection
6 - Correct Method
6 - Incorrect Method
7 PRODUCT INSTALLATION
7 Installing an LVDS Cable
8 Lighting Installation
9 Installation in Enclosure
10 Precaution
10 - Correct Method
10 - Incorrect Method
11 TROUBLESHOOTING
12 SPECIFICATIONS
14 LVDS PIN MAP GUIDE
NOTE
The warranty will not cover any damages caused by using the product in an excessively dusty
y
environment.
INSTALLATION PREPARATION
3
INSTALLATION PREPARATION
Accessories
Check your product box for the following items. If there are any missing accessories, contact the local
dealer where you purchased your product. The illustrations in this manual may differ from the actual product
and accessories.
CD (Owner's Manual)/
Easy Setup Guide
ENGLISH
ENG
NOTE
The accessories supplied with your product may vary depending on the model.
y
Product specifications or contents in this manual may be changed without prior notice due to upgrade
y
of product functions.
LVDS cable is optional and not provided with the product. Please refer to
y
pages 14 to 15 for the LVDS cable assembly.
LVDS Pin Map Guide
on
CAUTION
Do not use any unapproved or counterfeit parts or accessories to ensure the safety and product life
y
span.
Any damages or injuries by using unapproved items are not covered by the warranty.
y
INSTALLATION PREPARATION
4
ENGLISH
Mounting Holes
ENG
Use M3 screws to mount the monitor. There are 20 positions for screws on the rear side of the product.
Front of the product
Rear of the product
CAUTION
This product has the front and back sides. Make sure the product is installed with the front side facing
y
forward.
Image is displayed reversely on the back side.
y
INSTALLATION PREPARATION
5
Portrait Layout
To install in portrait mode, rotate the set clockwise 90 degrees when looking at from the front.
The portrait mode is only available on the scaler board. (The scaler board should support portrait mode.)
CAUTION
The scaler board is optional and it is not part of the product.
y
ENGLISH
ENG
Loading...