<![endif]>ENGLISH
OWNER’S MANUAL
MONITOR SIGNAGE
Please read this manual carefully before operating the your set and retain it for future reference.
MONITOR SIGNAGE MODELS
26TS30MF
47TS30MF
www.lg.com
2 CONTENTS
CONTENTS
<![if ! IE]> <![endif]>ENGLISH |
3 |
INSTALLATION PREPARATION |
|
||
|
3 |
Accessories |
|
4 |
Mounting Holes |
|
6 |
Unpacking and Cabling |
|
8 |
Portrait Layout (Only supported for 47TS30MF) |
|
9 |
Storage Method for Panel Protection |
|
9 |
- Correct Method |
|
9 |
- Incorrect Method |
10 PRODUCT INSTALLATION
10Lighting installation
11Installation in Enclosure
12Precaution
12- Correct Method
12- Incorrect Method
13TROUBLESHOOTING
14SPECIFICATIONS
1426TS30MF
1547TS30MF
16LVDS PIN MAP GUIDE
1626TS30MF
1747TS30MF
INSTALLATION PREPARATION 3
Check your product box for the following items. If there are any missing accessories, contact the local dealer where you purchased your product. The illustrations in this manual may differ from the actual product and accessories.
CD (Owner's Manual)/
Card/ Easy Setup Guide
CAUTION
yyDo not use any unapproved or counterfeit parts or accessories to ensure the safety and product life span.
yyAny damages or injuries by using unapproved items are not covered by the warranty.
NOTE
<![endif]>ENGLISH
yyThe accessories supplied with your product may vary depending on the model.
yyProduct specifications or contents in this manual may be changed without prior notice due to upgrade of product functions.
<![endif]>ENGLISH
4INSTALLATION PREPARATION
26TS30MF
Use M3 x 4 mm screws to mount the monitor. There are 16 screw holes on the rear side of the product.
< Front side of the product >
< Rear side of the product >
INSTALLATION PREPARATION 5
47TS30MF
Use M3 x 4 mm screws to mount the monitor. There are 20 screw holes on the rear side of the product.
< Front side of the product >
< Rear side of the product >
CAUTION
<![endif]>ENGLISH
yy product has the front and back sides. Make sure the product is installed with the front side facing forward.
yyImage is displayed reversely on the back side.
<![endif]>ENGLISH
6INSTALLATION PREPARATION
26TS30MF
1 Lift up the cover of the box. |
2 Remove the top packaging. |
3 Hold both sides of the product and lift it up. |
4 Remove the poly bag. |
5Place a soft cloth on the table and put the product down with the screen facing downward.
6Connect the LVDS cable(Additional assembly is required). A scaler board or LVDS cable is optional and not provided with the product.