Lenovo A320 User Manual

1. Unpack
2. Computer instructions 3. Computer stand 4. Carry the computer
1
4
2
3
5
6
7
2 3
4 5 6 78
9 107
1
The buttons at the bottom of the screen are touch buttons. When you touch these, the indicator lights turn on.
1
2
1 2
Connect the power cords properly to grounded electrical outlets.
Connect the keyboard cable to the appropriate keyboard connector (USB connector).
Connect the mouse cable to the appropriate mouse connector (USB connector).
Adjust the angle for the best viewing experience. It can be rotated from horizontal or vertical. The stand provides stability to the computer; it is not a removable part.
Hold the computer tightly when you carry it.
10 10
3
18
Adjust the panel angle for the best viewing from the vertical.
Do not only use one hand to adjust the panel angle to avoid the computer falling over.
Adjust the panel angle for the best viewing from the horizontal.
Version: 2.1
Connecting the wired keyboard and mouse to your computer (Selected models only)
Press the power button on the top of the base stand to turn on the computer.
Camera
Built-in microphone
Hard Disk Drive Indicator
Bluetooth status indicator
WIFI status indicator
Menu/OK button
Direction buttons
1
8
4
2
7
3
5
6
9
10
Power button
TV tuner connector (Selected models only)
Power connector
Ethernet connector
HDMI-OUT connector (Selected models only)
HDMI-IN connector (Selected models only)
USB ports (4)
Memory card reader (Selected models only)
Microphone connector
Headphone connector
Bluetooth connect button
Mode switch button (Selected models only)
The computer stand must remain installed at all times to ensure maximum system stability.
12
74 63 5
TV
31045828
5. Wireless keyboard and mouse instructions (Only some models are equipped with wireless keyboard and mouse)
The wireless keyboard and mouse are pre-synchronized, for your convenience, to work with your Lenovo PC. The keyboard and mouse should work immediately after you pull the battery tabs to activate the preinstalled batteries(or install the batteries), and then turn on the mouse.
You may need to manually synchronize the wireless keyboard or mouse if they are not functioning. To synchronize them, do the following:
Remove the battery tabs from both the keyboard and the mouse (or install the batteries into the battery compartments).
Make sure the power switch on the back of the mouse is in the ON position (the keyboard does not have a power switch).
Remove the battery tabs from both the keyboard and the mouse.
CONNECT
LASER
OFF ON
CONNECT
OFF ON
CONNECT
Press the wireless connect buttons on the right side of the keyboard and the back of the mouse.
1. Press the wireless connect button.
2. Make sure the indicator lights blink and press the bluetooth connect button.
When the keyboard and mouse wireless indicator lights blink green, press the bluetooth connect button on the base stand for over 5 seconds until the indicator lights of the keyboard and mouse turned off.
If connection is not established successfully, refer to “Wireless keyboard and mouse instructions” in the
User Guide
.
Bluetooth connect button
Mode switch button
CONNECT
LASER
OFF ON
Loading...