Lenco DF-831 User Manual

DF-831

8” Digital photo frame

User manual

For information and support, www.lenco.eu

1. Getting started: Checking the appearance:

Sensor for remote control

2. Understanding interface and on-board buttons:

(1). Menu／Back;

(2) .

Confirm

(3) . Down;
(4) . Up;
(5) . Right.
(6) . Left;

(7) .

On/Off

⑻

. mini USB port
(9). USB port;
(10). SD/MMC reader
(11). Sockets for AC power adaptor;
(12). Frame stand port

;

3. Installing and recharging your unit:

Open the package and remove the protective sleeve from the unit. Screw in the stand

to the stand screw hole on the back of the photo frame, Adjust the frame position for

vertical or horizontal placement, Plug in the AC adapter into power outlet. Plug the

other end into the unit. Insert your memory card and the unit starts the slideshow digital

photos automatically.

4. Understanding the remote:

1. Power On / OFF

2. Clock

3. Calendar

4. Go up

5. Go Left / Previous Picture

6. Confirm

7. Go Right

8. Zoom in/out

9. Go Down

10. Rotate

11. Exit / go to previous menu

12. Slideshow

13. Setup

Understanding the MENU:

1. Function Navigation
Power on the unit, the unit will display the following menu if there is no card inserted.

Figure 1

You can use the function navigation above to change all aspects of your photo frame from the
transitions sytle of your slideshows to the colour balance of the display. To bring up the menu on
screen just press the MENU button on board or the ESC button on the remote to go to the above
interface.