Page 1
INST-CCWB-001
® electrical systems conform to and should
Typical CCWB Series Wall Box
INSTALLATION INSTRUCTIONS
Products Covered:
Wall Box Cat. No.: CCWB
Wiremold/Walker
be properly grounded in compliance with requirements of the
current National Electrical Code or codes administered by
local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold/Walker
electrical products may bear the mark as UL Listed and/or
Classified and should be installed in conformance with
current local and/or the National Electrical Code.
IMPORTANT: Please read all instructions before beginning.
CAUTION: Do not operate resurfacing equipment over surface of covers. This may result in damage to the surface finish of the
product.
CAUTION: Box has no after set adjustment.
Step 1 Build and position wall box frame in accordance with wall
plans or blueprint.
Note: Wall box frame size will depend on wall box
dimensions. Please consult factory for correct dimensions.
Page 2
Step 2 Install wall box into wall box frame and secure using #10
wood screws.
Step 3 Remove electrical and data panels.(If supplied with
Box) Remove knockouts where required. Attach conduit for
power and data cables using UL Listed components. All
openings and unused knockouts must be closed or sealed off
during final installation with UL Listed components. Re-install
electrical and data panels.
Step 4 Install cover assembly over wall covering using spacer/latch plate and supplied hardware.
Loading...