La-Z-Boy Power Bundle Console User Manual [en, es, fr]
operating instructions
__________
la-z-boy.com
instrucciones de operación
__________
instructions
Power Bundle
Console
Consola eléctrica integrada
Console électrique intégrée
La-Z-Boy Incorporated
12 84 N. Telegraph Road
Monroe, MI 4816 2
©2014 La-Z-Boy Incorporate d
DOC006862 Rev. 01/14
Table of Contents
Important Safety Instructions ............................................. 3-4
Console Assembly Instructions......................................5-6
Console Grounding Instructions................................................7
Electrical Outlet & USB Charging
Port Operating Instructions.....................................................8
Console Troubleshooting...........................................................9
Cup Holder Operating and Cleaning Instructions..................10
IMPORTANT
Read the safety and other instructions before using
your Power Bundle Console. Keep this
manual for future reference.
2
Important Safety Instructions:
Important: Read these instructions thoroughly before using.
Important Safety Instructions:
Important: Read these instructions thoroughly before using.
DANGER
• Disconnect the electrical plug from outlet before cleaning, moving, servicing or when not in
use for an extended period of time.
• Do not use this product if it is wet, in water, around water or any liquid. Do not handle the plug or
remote control with wet hands.
• To prevent suffocation keep plastic bags away from children.
• Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check
with a qualified electrician or serviceman if you are in doubt as to whether the product is properly
grounded. Do not modify the plug provided with the product - if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.
• Keep cord out of reach of small children, and do not use where it may be a trip hazard.
• Do not insert into the outlet anything other than a securely fitting plug from a properly operating device
designed for 110-volt electricity. If a plug will not fit completely into the outlet, do not force it in and
instead unplug the device. Use extreme caution with liquids near the outlets. In case of spills into the
outlets, immediately unplug the unit and consult an electrician.
WARNING
• Always keep open flame and lit cigarettes away from upholstered furniture. Upholstered furniture
may burn rapidly with toxic gas and thick smoke.
• Closely supervise children and disabled persons using this product.
• Do not use this product if it is damaged. Do not use attachments or substitute parts.
• This product is intended for indoor residential use only.
• Check the condition of the electrical cord and plug monthly. Keep the electrical cord away from heat
sources. Never operate the unit with a damaged electrical cord or plug. Contact your La-Z-Boy
dealer for service.
• This product is not intended for use as a health care device.
• Do not use this product where aerosol (spray) products are being used or where oxygen
is being administered.
• Do not attempt to disassemble or service the product; no serviceable parts are inside.
Contact your La-Z-Boy
– To reduce the risk of electric shock, serious injury or death:
– To reduce the risk of electric shock or serious injury:
®
dealer for service.
®
• Do not allow electrical cord to be pinched between moving parts or between the frame
and the floor. Do not place cord under carpet or in location where it could become worn.
• Connect this furnishing to a properly grounded outlet only, as indicated by the illuminated green light (see
Table of Contents, Console Grounding Instructions).
• This product must be grounded. If it should malfunction or break down, grounding provides a path of least
resistance for electrical current to reduce the risk of electrical shock. This product is equiped with a cord
having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an
appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
• This product is for use on a nominal 110-volt circuit and has a grounding plug that looks like the plug
illustrated in the Grounding Instructions (see Table of Contents, Console Grounding Instructions). Make sure
that the product is connected to an outlet having the same configuration as the plug. No adapter should be
used with this product.
• Unplug the power cord immediately if you detect strange odors or fumes coming from the unit.
• Do not attempt to disconnect the power plug by pulling the power cord. Always hold the power
plug and pull it out.
• Electrical outlets in the console are intended for use with small office devices only.
• If you give this product to someone else, include this Operating Instructions manual.
NOTICE
• To prevent damage to the power transformer, do not plug in until instructed.
• Do not move the units while connected together. The purpose of the bracket system is to
connect the units and prevent them from being separated while on the floor. The bracket
system does not provide adequate structural support for the movement of connected units.
• Units contain cup holders. Take care to prevent spilling of beverages, which could result
in damage to cover.
• Surge suppression is not available on USB charging ports.
• Unplug devices from the unit if a power failure occurs. Devices may be plugged in after
power is restored.
– To reduce the risk of product damage:
Save These Instructions Save These Instructions
3
4
Console Assembly Instructions
Console Assembly Instructions
NOTICE: Do not plug in until instructed.
The power console has one rear side mount bracket and one front side mount “U” bracket on the
right side (sitting), and two threaded studs on the left side (sitting), (F
1. Use a T-30 torx driver to loosen the threaded studs to approximately 1"; this measurement may
vary depending on the fabric and style (F
2. To start, place the units to be attached next to each other, about 2" apart. Position the unit with the
threaded studs slightly behind the unit with the attachment brackets. Separate the fronts of the units
to be connected, about 6" apart. Slide the rear of the unit with the threaded studs toward the unit
with the attachment brackets, aligning the threaded studs to the rear bracket. Pull the unit with
the threaded studs forward to engage the rear bracket.
WARNING
• The front of the unit must be raised to engage the front bracket. Please seek assistance
if you are unable to lift at least 57 pounds.
• Keep feet clear of the unit when lowering it into position.
– To reduce the risk of injury:
IGURE 2).
IGURE 1).
NOTICE: To reduce the risk of product damage:
• Lift from the base rail. Do not lift from the upholstery or the bottom of the legrest.
3. Lift the front of the unit with the threaded stud approximately 3" off the ground, aligning it to the
unit with the attachment bracket. Gently lower the threaded stud into the front attachment bracket
(F
IGURE 3). Keep feet clear of the unit when lowering it into position.
Note: Due to variations in upholstery and style, the threaded stud length may need to be adjusted to
fit into the attachment brackets or control gaps between units. Loosen or tighten the threaded studs
to provide adequate clearance.
4. Continue connecting the modular units until all have been securely joined.
NOTICE: To reduce the risk of product damage:
• Do not move the units while connected together. The purpose of the bracket system is to
connect the units and prevent them from being separated while on the floor. The bracket
system does not provide adequate structural support for the movement of connected units.
5. All modular units must be disconnected to safely move the modular group. To disconnect the units,
lift up the left side (sitting) modular unit (with threaded studs) approximately 3" to clear the front
attachment bracket, move the front of the unit over and return it to the floor. Slide the unit with the
threaded studs backward to disengage the rear bracket.
FIGURE 1
Rear Side
Mount Bracket
Front Side Mount
“U” Bracket
IGURE 2FIGURE 3
F
Front Side Mount
“U” Bracket
Threaded
Stud
Threaded
Stud
5
6
Console Grounding Instructions
Electrical Outlet & USB Charging
Port Operating Instructions
DANGER
• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.
• Improper connection of the equipment-grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or serviceman if you are in doubt as to whether
the product is properly grounded. Do not modify the plug provided with the product - if it
will not fit the outlet, have a proper outlet installed by a qualified electrician.
WARNING
• Check the condition of the electrical cord and plug monthly. Keep the electrical cord away
from heat sources. Never operate the unit with a damaged electrical cord or plug. Contact
your La-Z-Boy
• Connect this furnishing to a properly grounded outlet only, as indicated by the illuminated
green light.
• This product must be grounded. If it should malfunction or breakdown, grounding provides
a path of least resistance for electrical current to reduce the risk of electric shock. This
product is equipped with a cord having an equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
• This product is for use on a nominal 110-volt circuit and has a grounding plug that looks
like the plug illustrated below. Make sure that the product is connected to an outlet having
the same configuration as the plug. No adapter should be used with this product.
This product is equipped with a 3-prong, grounding plug. Plug directly into a properly grounded
outlet, as shown in the illustration below.
3-PRONG, GROUNDING PLUG
– To reduce the risk of electric shock, serious
injury or death:
– To reduce the risk of electric shock
or serious injury:
®
dealer for service.
GROUNDING OUTLET BOX
DANGER
• Disconnect the electrical plug from outlet before cleaning, moving, servicing or when
not in use for an extended period of time.
• Do not insert into the outlet anything other than a securely fitting plug from a properly
operating device designed for 110-volt electricity. If a plug will not fit completely into the
outlet, do not force it in and instead unplug the device. Use extreme caution with liquids
near the outlets. In case of spills into the outlets, immediately unplug the unit and
consult an electrician.
WARNING
• Connect this furnishing to a properly grounded outlet only, as indicated by the
illuminated green light.
• Electrical outlets in the console are intended for use with small office devices only.
– To reduce the risk of electric shock, serious
injury or death:
– To reduce the risk of electric shock
or serious injury:
NOTICE: To reduce the risk of product damage –
• Surge suppression is not available on USB charging ports.
1. Consoles with the Power Bundle Option include a black molded storage compartment, one or two
lighted cup holders, two electrical outlets and two USB charging ports. The storage console also
includes a drawer.
2. Lift the padded flip top to access the storage compartment, electrical outlets and USB charging ports.
3. The red light indicates the internal surge suppression is functional. The green light indicates the unit
is grounded. Do not use the electrical outlets or USB charging ports unless both lights are
illuminated. (See Console Troubleshooting Instructions.)
4. Plug in small office devices to the electrical outlets and USB charging ports. Note: USB ports are for
charging only and do not have data transferring capabilities.
Grounded
Outlet
Power Bundle Specifications:
AC Input: 125 VAC 60 Hz
USB Output: 2.1 AMP Max. 5 VDC
Grounding
Pin
7
AC Output: 125 VAC 60 Hz 12 AMP Max.
Built-in 720 Joules Surge Suppression
Surge Ground
Electrical
Outlets
Charging Only
Charging
USB Ports
8
Loading...