Lang Manufacturing LG Installation Manual

Lang Griddle

Start-Up

1) Verify connections at plug in outlet are tight.

2) Incoming Volt - Single Phase L1______

3) Gas pressure is set for 4.5" WC (Natural Gas), (9" WC (Propane)
Ensure that the regulator is installed in the correct direction.

4) Ensure griddle body is tilted 1/ 8" lower in front.
Confirm there is 4" clearance below griddle

5) Burner flame is not lifting and is stable.
Flame should light around the "U" of each burner with no hesitation.
Height of flame should be 1 1/4" to 1 1/2".

Flames must not lift off of burner ports.

6) Ensure spark electrode does not continue to spark .
The tip of the spark electrode and sensor electrodes must have flame on them
and glowing red.

Model #____________ Date_______ Serial #___________

Store #__________________ Tech Name____________________________

Contact__________________ Company _____________________________

Store Phone #______________ Service Company Phone #________________

Address_____________________

______________________

______________________

Please fax to Lang Manufacturing @ 425-349-2483