Lang Manufacturing ES-COH16C Installation Manual
Star
Manufacturing
International Inc.
10 Sunnen Dr.
St. Louis, MO 63143
Installation
& Operation
Instructions
Phone: (314) 781-2777
FAX: (314) 781-2714
2M-W484 Rev.- 3/1/07
ES-COH16 & ES-COH16C OVEN STAND
STAND ASSEMBLY
LEG / CASTER INSTALLATION
Place the stand upside down on the fl oor.
Screw the leg or caster into the threaded studs at the bottom of the leg tubes.
Screw the leg or caster into the leg tube until no red is visible on the leg or caster.
Turn the stand upright and place it in position with the diagonal holes to the rear of the
stand.
Level the stand front to back and left to right.
Tighten the leg tube set screws onto the leg or caster.
TIGHTEN LEG SET SCREWS AFTER LEG OR CASTER ADJUSTMENT.
CASTORS OR LEGS MUST BE SCREWED IN BEYOND RED MARK.
WARNING
PLACING AN OVEN ONTO THE STAND
Open the oven door and remove the envelope labeled “Stacking Kit” from inside the oven
cavity.
Gently lay the oven onto its back.
Provided inside the Stacking Kit envelope are two 3/8 X 2 inch threaded rods.
Screw these rods into two threaded holes at the rear of the oven bottom.
Lift the oven and place it onto the stand so that the threaded rods nest into the holes at
the rear of the stand.
Note that the oven is fl ush with the stand on all four sides when placed properly onto the
stand.
RED MARK MUST NOT SHOW.
STACKING A SECOND OVEN
Open the oven door and remove the envelope labeled “Stacking Kit” from inside the oven
cavity.
Gently lay the oven onto its back.
Provided inside the Stacking Kit envelope are two 3/8 X 2 inch threaded rods.
Screw these rods into two threaded holes at the rear of the oven bottom.
Remove the black plastic plugs from the top of the lower oven.
Lift the top oven and place it onto the lower oven so that the threaded rods nest into the
holes at the rear of the lower oven.
Loading...