Land Rover LR3 User Manual

LR3

QUICK START GUIDE

02 VEHICLE ACCESS
04 COMFORT AND SAFETY
08 CLIMATE CONTROL
09 EXTERIOR LIGHTING

10 FACIA OVERVIEW

11 WIPERS AND WASHERS
12 ON-ROAD AND OFF-ROAD
16 AUDIO SYSTEM
18 NAVIGATION AND TELEPHONE SYSTEMS

20 GAS STATION INFORMATION

Some of the information in this guide may not
apply to your vehicle.

You must refer to your Owner's Handbook for
full operating instructions.

Vehicle access

Remote control Tailgate

Dependent upon specification and vehicle
configuration, the operation of the remote
control may differ from the following.

Automatic relock

If the vehicle is unlocked with the remote
control, it will automatically relock and arm the
alarm if a door or the tailgate is not opened
within one minute.

Key blade

Press button (arrowed in illustration) to release
the key blade.

Central locking

• Press once to lock all doors and activate
the alarm.

• Press once to deactivate the alarm and
unlock the driver’s door (Single point
entry).

• A second press will unlock all other
doors.

Customer configurable button. Can be
programmed to remotely operate one of the
following functions:

• Headlamp on (default).

• Panic alarm.

• Air suspension.

Refer to Programming the remote control
in the Owner’s Handbook.

Single point entry

This is a security feature that unlocks only the
driver’s door. It can be disabled on individual
remote controls by simultaneously pressing and
holding the lock and unlock buttons for three
seconds. The vehicle will lock and then unlock in
the currently selected mode to confirm the change.

Master lock and unlock switches

1. Press to unlock all doors and tailgate.

2. Press to lock all doors and tailgate.

1

Opening the upper tailgate

With all the doors unlocked, press the release
switch 1 on the underside of the exterior handle
and pull to open.

Clock setting

The clock displayed on the audio unit and in the
message centre is set via the audio unit menu.

To adjust the time:

1. Press the MENU OK button.

2. Rotate the rotary control clockwise until
Clock is displayed and highlighted.

3. Press the control to select and enter the

clock setting mode.

4. Dependent upon specification of audio unit,
the time display may be changed between

12 and 24 hour modes.

5. Select Set to display the hour setting. Rotate

the control to adjust and press to confirm.

6. The display then shows the minute setting.
Rotate the control to adjust and press to
confirm.

2

Opening the lower tailgate

With the upper tailgate open, press the touch
pad 2 on the lower tailgate waist moulding.

News

Clock

123456

09

Time
Set

123456

AM

09

Speed-related locking

If enabled, the doors and tailgate will automatically
lock when the vehicle's speed exceeds 5 mph.

This feature can be disabled or enabled in the
Settings option accessed via the trip computer.

2

3

Comfort and safety

3

1 2

Driver’s seat adjustment Steering column adjustment

3

1

2

1. Move the lever located under the

steering wheel fully downward.

2. Adjust the height and reach of the
steering wheel to the desired position.

3. Move the lever fully up to lock the
position of the wheel.

1. Seat fore/aft, cushion height and front tilt control switch.

2. Seat recline adjustment switch.

3. Lower backrest lumbar support switch.

Driving position memory

Once you have adjusted the driver's seat and
exterior mirrors for your ideal driving position,
the vehicle can memorise these settings for
future use.

1. Press the memory store button to
activate the memory function for five
seconds.

2. Press one of the preset buttons within five
seconds to memorise the current settings.

MEMORY STORED will be displayed on the
message centre accompanied by an audible
chime to confirm the settings have been
memorised.

12

Operating note

A seat position will only be memorised during
the five second active period.

Any existing settings will be over-written when
programming a memory position.

Windows and door mirrors

Windows

• To open a window, press and hold the
respective switch.

• To close the window, pull and hold the switch.

Window movement can be stopped at any time
by releasing the switch.

The front windows have a one touch facility that
allows them to be fully opened or closed with a
single operation of the switch. Firmly press or lift
the switch and release. Movement can be
stopped by operating the switch again.

Press the right-hand side of switch 1 to inhibit
the operation of the rear window switches.

Resonance with lowered windows

If a resonance/booming sound occurs when
a rear window is open, lowering an adjacent
front window about 25 mm (1 inch) will
eliminate the condition.

2

1

Door mirror adjustment

To adjust the mirrors, rotate the mirror
adjustment knob 2 left or right to select the
appropriate mirror. Move the knob in any
direction to adjust the position of the mirror
glass.

4

5

Comfort and safety

2

To open the sunroof:

• Press and release the rear of the switch 1 to
open the roof to the tilt position.

• Press and release the rear of the switch
again to open the roof fully.

Homelink®transmitter

The buttons (arrowed) can be programmed to
transmit radio frequencies that can operate
external devices i.e. garage doors, entry gates,

security systems, etc....

For more information, refer to Garage

transceiver in the Owner's Handbook.

Seat belts and child restraintsSunroof

A warning light on the instrument pack will
illuminate to alert you that the driver's

Operating note

The sunroof can be operated with the
starter switch in position I or II and for 40
seconds after position 0 has been selected,
providing that neither front door has been
opened.

With the starter switch in position I or 0, the

1

switch will need to be pressed and held
until the roof reaches the desired position.

To close the sunroof:

• Press and release the front of the switch 2 to
close the roof to the tilt position.

• Press and hold the front of the switch again
to close the roof fully.

If the sunroof is moving, it can be stopped by
pressing the switch again.

and/or front passenger's seat belt is
unbuckled.

Automatic Locking Reels (ALR)

All passenger seat belts have ALR fitted for use
with child seats or securing large items.

• To enable: extend belt to maximum length.

• Allow seat belt to retract onto the child
seat/item (a clicking sound will be heard as
the belt retracts). Ensure there is no slack by
pressing the seat/item firmly into the vehicle
seat.

• To disable: unbuckle the belt and allow the
belt to fully retract.

Passenger air bag

PASS

AIRBAG

OFF

PASS

AIRBAG

OFF

With ALR enabled, as the seat belt retracts, it
will automatically lock preventing re-extension.

Ensure passengers do not fully extend the
restraints and inadvertently engage this
feature during normal use.

Recommended child seat

Land Rover strongly recommends the use
of LATCH (Lower Anchors and Tethers for
CHildren) child seats.

LATCH child seats can only be fitted in the
second-row outer seating positions.

The front passenger seat is fitted with an
occupancy sensor system that determines the
state of seat occupancy and sets the air bag
status to suit;

• Seat unoccupied - air bag deactivated and
indicator off.

• Seat occupied - air bag activated and
indicator off.

• Seat occupied by a child seat or low weight
object - air bag deactivated and indicator
on.

For further information, refer to Occupant

detection in the Owner’s Handbook

Operating note

If the indicator becomes permanently
illuminated when the seat is definitely
empty, please contact your Land Rover
Dealer immediately.

6

7