Landoll 1P153 User Manual

1P153 - Electric Clutch Kit for Seeders

Note: Chain included in box assembly for conversion only. It is not used
with factory assembled transmissions.

1. Check that clutch case has proper
clearance between rubber bumper stop.
Improper clearance may prevent the clutch from

Bumper Bolt

Clutch

1/8” GAP

Clearance from
Bumper Stop

engaging or cause it to disengage.

Clutch Wiring Harness

Clutch Lead

Clutch

2. Connect clutch wiring harness
to clutch lead.

Adhesive Mount

Cable tie

Hoses &

Hose Clamps

Clutch Wiring

Warning Light Harness

Harness

3. Route wire along frame and drawbar. Secure to frame and drawbar or with
hydraulic hoses and warning light harness by cable ties or adhesive mounts.

4. Install switch on tractor in a convenient location with the velcro included or other type of mount
(not included).

5. Attach wire lead to power source and secure wire.

6. Check clutch operation. Clutch will disengage when power is applied.

(Clutch will make a clicking
sound). Set seeder on the ground and drive a short distance whole turning switch on and off.
The seed cup shaft will stop rotating when switch is turned to “OFF” position.

7. Turn switch to “ON” position when seeder is not used to shut off power to prevent possible over
heating of clutch coil.

506

1P153

-