INSTALLATION INSTRUCTIONS
NOTICE
NOTE
SHIM PROCEDURE
SHIM KIT P/N 171824
WFPD22-36, WFPO22-36,
WFPC22-36 & WFPDS22-36
(WING FLOAT PULVERIZERS)
1. Install the left bearing assembly to the Center Frame
to hold the Center Roller Axle Assembly as per
assembly instructions shown on the Wing Float
Pulverizer Operator’s Manual (2P542).
2. Begin installation of the right hand bearing assembly
similarly.
— As you are lining up the center roller axle up to
the right bore, you should notice if there may be
a gap, either between the flangettes and the
center frame or between the bearing and the
shoulder on the roller axle shaft.
The bearings must be shimmed correctly to avoid
premature failure of the part. Correct installation
is vital to the longevity of the equipment.
Gap Between Flangettes and
Center Frame Hanger Bracket
When the Center Roller Axle Assembly is installed to the
point that the flangette halves are clamped around the
bearing, and there is a gap between the flangettes and
the center frame hanger bracket (as shown in
Figure 1-3), additional shims must be added.
The shim for this type of gap, shown in Figure 1-1, should
be installed between the flangettes and the Center Frame
bracket. See Figure 1-5. In the instance that more than
one shim is needed, put an equal number of shims on
either side of the Center Frame to obtain a proper fit.
Gap Between Bearing and Roller
Axle Shaft Shoulder
When the Center Roller Axle Assembly is installed to the
point that the flagette halves are clamped around the
bearing, and there is a gap between the bearing and the
shoulder on the Roller Axle Shaft (as shown in
Figure 1-4), additional shims must be added.
The shim for this type of gap, shown in Figure 1-2, should
be installed between the bearing and the shoulder on the
Roller Axle Shaft. See Figure 1-5. In the instance that
more than one shim is needed, put an equal number of
shims on either side of the Center Frame to obtain a
proper fit.
Figure 1-1: Outside Shim
Figure 1-2: Inside Shim
After installing the appropriate shims, proceed with
normal installation instructions, including use of
proper fasteners and torque specifications.
F-655 Edition Brillion Farm Equipment 1-1
rev6-12-12 Brillion, Wisconsin 54110
Figure 1-3: Gap Between Flangettes and Center Frame
Figure 1-4: Gap Between Bearing and Roller Axle Shaft Shoulder
1-2 Brillion Farm Equipment F-655 Edition
Brillion, Wisconsin 54110 rev6-12-12
Cent
e
r Hanger BracketFla
n
g
ette Ha
lvesBearing
Out
e
r
Shi
mInnerShi
m
Figure 1-5: Shim Locations
F-655 Edition Brillion Farm Equipment 1-3
rev6-12-12 Brillion, Wisconsin 54110
Loading...