Page 1
LANCOM R&S®UF-500
4
eth0 eth1 eth2 eth3 eth4 eth5
Console
Power
HDD
Status Reset
Quick Reference Guide
Power
Status Reset
HDD
4
Conguration interface RJ45 (Console)
a
Maintenance interface for expert conguration
USB 2.0 interfaces
b
Interfaces for software re-installation
TP Ethernet interfaces eth0 - eth5
c
Connect the eth0 - eth5 TP Ethernet interfaces with the enclosed
Ethernet cable to your conguration PC or other networking
components. Initial setup advice can be found in the supplied quick
install guide.
Console
a b
eth0 eth1 eth2 eth3 eth4 eth5
c d
TP Ethernet interfaces
d
Connect the TP Ethernet interfaces to your PC or other
network components.
Power switch (rear side)
e
Power on the device after having connected the power cable.
Power connector (rear side)
f
Supply power to the device via the power connector.
Please use the IEC power cable supplied.
a
a LEDs Power / HDD
Power off Gerät switched off
Power green Device operational
HDD off no HDD read-/write access
HDD orange ickering HDD read-/write access
b LEDs eth0 - eth5 - TP Ethernet
Both off No networking device attached
Left orange ickering
Right orange,
permanently
Left orange, ickering
Right green,
permanently
Left orange, ickering
Right off
Left off
Right orange,
permanently
Data transfer 1000 Mbps
Data transfer 100 Mbps
Data transfer 10 Mbps
Device switched off
b c
c LEDs TP Ethernet module
Both off No networking device attached
Left orange ickering
Right orange,
permanently
Left orange, ickering
Right green,
permanently
Left orange, ickering
Right off
Data transfer 1000 Mbps
Data transfer 100 Mbps
Data transfer 10 Mbps
Hardware
Power supply Internal power supply unit (100–240 V, 50–60 Hz)
Power consumption 150 W max.
Environment Temperature range 0–40 °C; humidity 20–90 %; non-condensing
Housing Robust metal housing, 1 HU with mounting brackets for 19“ installation,
network connectors on the front
Fan 1
Dimensions (mm) 431 x 44 x 305 (W x H x D)
Interfaces
ETH 14x 10 / 100 / 1000 Mbps Gigabit Ethernet ports
USB 2x USB 2.0 ports
Console RJ45 conguration interface
Declaration of conformity
Hereby, LANCOM Systems GmbH | Adenauerstrasse 20/B2 | D-52146 Wuerselen, declares that this device is in compliance with Directives 2014/30/EU, 2014/35/EU, and 2011/65/EU. The full text of the EU declaration of conformity is
available at the following internet address: www.lancom-systems.com/ce/
Package content
Documentation Quick Reference Guide (DE, EN), Quick Install Guide (DE, EN), Service & Support Guide (DE, EN)
Accessories 1 Ethernet cable; 1 IEC power cord 230 V; 1 serial conguration cable;
2 19” brackets for rack mounting
e f
Cloud-ready
Please observe the following when setting up the device
A The mains plug of the device must be freely accessible.
A Do not rest any objects on top of the device and do not stack multiple devices.
Before initial startup, please make sure to take notice of the information regarding the intended use in the enclosed installation guide!
Operate the device only with a professionally installed power supply at a nearby power socket that is freely accessible at all times.
A Keep the device’s ventilation slots clear of obstruction.
A Mount the device into a 19” unit in a server rack using the provided mounting accessories.
MOUNTING AND CONNECTING THE DEVICE
LANCOM, LANCOM Systems, LCOS, LANcommunity and Hyper Integration are registered trademarks. All other names or descriptions used may be trademarks or registered trademarks of their owners. This document
contains statements relating to future products and their attributes. LANCOM Systems reserves the right to change these without notice. No liability for technical errors and / or omissions. 111833/0720
TECHNICAL DATA
Loading...