Lancom R&S UF-900 User Manual

TECHNICAL DATA

MOUNTING AND CONNECTING THE DEVICE

LANCOM R&S® UF-900

4

Quick Reference Guide

Conguration interface RJ45 (Console)

a

This maintenance interface for expert conguration is not required
for rst use.

USB 2.0 interfaces

b

These interfaces for software re-installation are not required for rst

use.

TP Ethernet interfaces eth0 - eth7

c

Connect the eth0 - eth7 TP Ethernet interfaces with the enclosed

Ethernet cable to your conguration PC or other networking
components. Initial setup advice can be found in the supplied quick

install guide.

a
b

c

Slots for extension modules

d

After having removed the faceplates you can optionally insert
up to two modules (RJ45, SFP or SFP+) into the slots.

Power switch (rear side)

e

Power on the device after having connected all power cables.

Power supply modules (rear side)

f

Supply power to the device via both power connectors. Please
use the supplied IEC power cables.

d

a

b c

a LEDs Power / HDD

Power off Device switched off

Power green Device operational

HDD off no HDD read-/write access

HDD orange, ickering HDD read-/write access

b LCD display (two lines) with menu buttons

Menu buttons < and > For displaying the IP address allocations

c LEDs eth0 - eth7 - TP Ethernet

Both off No networking device attached

Left orange ickering

Right orange,
permanently

Left orange, ickering

Right green,
permanently

Left orange, ickering

Right off

Data transfer 1000 Mbps

Data transfer 100 Mbps

Data transfer 10 Mbps

Hardware

Power supply 2 power supply modules (100–240 V, 50–60 Hz)

Power consumption max. 300 W each active power supply module

Environment Temperature range 0–40 °C; humidity 5–90 %; non-condensing

Housing Robust metal housing, 1 HU with mounting brackets for 19“ installation,

network connectors on the front

Fans 3

Dimensions (mm) 431 x 44 x 468 (W x H x D)

Interfaces

ETH 8x 10 / 100 / 1000 Mbps Gigabit Ethernet ports

USB 2x USB 3.0 port

Console RJ45 conguration interface

Declaration of conformity

Hereby, LANCOM Systems declares that this device is in compliance with Directives 2014/30/EU, 2014/35/EU, and
2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.lancom-systems.com/ce/

Package content

Documentation Quick Reference Guide (DE, EN), Quick Install Guide (DE, EN), Service & Support Guide (DE, EN)

Accessories 1 Ethernet cable; 2 IEC power cords 230 V; 1 serial conguration cable;

2 19” brackets for rack mounting, 2 fastening rails, 2 guiding rails

Optional accessories

Extension modules LANCOM R&S 8x 1G RJ45 Module (item no. 55121),

LANCOM R&S 4x 1G SFP Module (item no. 55122),
LANCOM R&S 4x 10G SFP+ Module (item no. 55123)

LANCOM, LANCOM Systems and LCOS are registered trademarks. All other names or descriptions used may be trademarks or registered

trademarks of their owners. Subject to change without notice. No liability for technical errors and/or omissions. 111834/1118

e

Please observe the following when setting up the device

A The mains plugs of the device must be freely accessible.
A Do not rest any objects on top of the device and do not stack multiple devices.

f f

A Keep the device’s ventilation slots clear of obstruction.
A Mount the device into a 19” unit in a server rack using the provided mounting accessories.