Lancer 810, 815 Service manual
TECHNICAL MANUAL
810 LX - 815 LX
LANCER RESERVES THE RIGHT TO MAKE CHANGES IN THIS MANUAL.
INTRODUCTION
INTRODUCTION
The goal of this manual is to provide assistance in the custom programming, operations,
and repair of your washer.
The manual is intended for use by engineers and technicians authorized to work on the
washer.
Before performing any work, please carefully read the advice and recommendations
contained herein, which have been written for your benefit.
This manual contains the steps to access to the programming, the common times, the
preprogramming, and the machine test. Access codes are required to enter all levels of
the programming. In order to protect the security of the access codes, they are supplied
in a separate document.
NT_810_815_LX_ANG_0707 3
CONTENTS
CONTENTS
INTRODUCTION...............................................................................................3
CONTENTS.........................................................................................................5
CHAPTER 1 BASIC FUNCTIONS OF KEYPAD........................................ 7
CHAPTER 2 PROGRAMMING OF A WASHING CYCLE.....................11
CHAPTER 3 THE MACHINE TEST...........................................................17
CHAPTER 4 THE COMMON TIMES ........................................................23
CHAPTER 5 PREPROGRAMMING...........................................................29
CHAPTER 6 THE FAULT ALARMS..........................................................33
CHAPTER 7 APPENDICES.......................................................................... 39
NT_810_815_LX_ANG_0707 5
CHAPTER 1 BASIC FUNCTIONS OF KEYPAD
CHAPTER 1 BASIC FUNCTIONS OF KEYPAD
NT_810_815_LX_ANG_0707 7
CHAPTER 1 BASIC FUNCTIONS OF KEYPAD
Legend :
-1- "START" BUTTON
111111111111
1111
33333333333333
3
3
//////////////
/
/
-
-
---------------
-
-
2222
2222222222
2
2
44444444444444
4
4
//////////////
/
/
++++++++++++++
+
+
-2- ENTER KEY (FOR PROGRAMMING) / TIME KEY (DURING CYCLE) / DOOR
UNLOCK*
-3- WASHER POWER ON/OFF BUTTON
-4- PROGRAMME 3 / "-" FUNCTION BUTTON
-5- PROGRAMME 4 / "+" FUNCTION BUTTON
-6- LIQUID CRYSTAL DISPLAY UNIT
-7- PROGRAMME 1
-8- PROGRAMME 2
* This only applies to 810LX washers equipped with door locking system.
NT_810_815_LX_ANG_0707 9
CHAPTER 2 PROGRAMMING OF A WASHING CYCLE
CHAPTER 2 PROGRAMMING OF A WASHING CYCLE
In this chapter, you can modify the wash cycle programming of the machine. The LEVEL 1
/ USER Access code is required.
NT_810_815_LX_ANG_0707 11
CHAPTER 2 PROGRAMMING OF A WASHING CYCLE
Switch on the appliance by pressing
The display indicates the number of the last cycle performed.
P R O G R A M M E n ° 0 1
L ANCER
Select the cycle number to be modified with
Press and hold button for 3 seconds to validate.
.
44444444444444
4
or
4
//////////////
/
/
++++++++++++++
+
+
buttons.
33333333333333
3
111111111111
1111
,
3
2222
2222222222
2
2
,
//////////////
/
/
-
-------------
-
-
V A L I D A T I O N
----
Enter the access code - LEVEL 1 / USER -.
If an incorrect code is entered, the following error message is displayed.
V A L I D A T I O N
I N CORRECT
Press and hold button for 3 seconds to validate.
You must reenter the correct access code.
Note :
If the access code is not entered within 1 minute, the display unit returns to its
initial state.
NT_810_815_LX_ANG_0707 13
Loading...