Kontron NSN2U User Manual

Kontron IP Network Server NSN2U

Document Revision 1.2

www.kontron.com

» Table of Contents «

1 Introduction ..................................... 6

1.1 About this Manual ............................................................ 6

1.2 Manual Organization .......................................................... 6

1.3 What Your Server Includes .................................................... 7

1.4 Product Accessories .......................................................... 7

1.5 Additional Information and Software .......................................... 8

2 Features ......................................... 9

2.1 Server Components ........................................................... 11

2.2 NSN2U Server Front Panel .................................................... 12

2.3 NSN2U Server Back Panel ..................................................... 14

2.4 Front Panel Board ........................................................... 14

2.5 LED/Switch Board ............................................................ 15

2.6 Hard Disk Drives ............................................................ 15

2.7 Optical Drive ............................................................... 15

2.8 Server Board (Baseboard) .................................................... 15

2.9 Riser Card Assembly ......................................................... 16

2.10 Ethernet NIC Ports .......................................................... 17

2.11 Remote Management Module 3 .................................................. 18

2.12 Power Supply Subsystem ...................................................... 18

2.13 System Cooling .............................................................. 18

2.14 Processors and Memory DIMMs ................................................. 19

Processors ............................................................... 19

Memory ................................................................... 19

3 Standard Component Installations and Upgrades ... 20

3.1 Before You Begin ............................................................ 20

Tools and Supplies Needed ................................................ 20

System References ........................................................ 20

3.2 General Installation Procedures ............................................. 20

Removing the Chassis Covers .............................................. 20

Re-installing the Chassis Covers ......................................... 21

Removing the Front Bezel ................................................. 22

Re-Installing the Front Bezel ............................................ 22

Removing the Riser Card Assembly ......................................... 22

Re-Installing the Riser Card Assembly .................................... 23

Removing the Processor Air Duct .......................................... 24

www.kontron.com

www.kontron.com

Re-Installing the Processor Air Duct ..................................... 24

3.3 Internal System Components Configuration and Installation Procedures ........ 25

Configuring Memory DIMMs ................................................. 25

Supported Memory ......................................................... 25

Publishing System Memory ................................................. 25

Memory Map and Population Rules .......................................... 26

Memory RAS ............................................................... 26

Memory Upgrade Rules ..................................................... 28

Installing Memory DIMMs .................................................. 29

Replacing or Removing Memory DIMMs ....................................... 30

Adding or Replacing a Processor .......................................... 31

Configuring Jumpers on the Server Board .................................. 34

4 Optional Component Installation Procedures ...... 37

4.1 Before You Begin ............................................................ 37

Tools and Supplies Needed ................................................ 37

System References ........................................................ 37

Cable Routing Reference .................................................. 37

4.2 Installing or Replacing Hard Disk Drives .................................... 39

Removing an HDD Carrier or Filler Panel from the Chassis ................. 39

Installing a Hard Drive in a Carrier ..................................... 40

4.3 Installing a SAS/SATA Control Module ........................................ 41

4.4 Installing a Hardware RAID Module ........................................... 43

4.5 Installing a RAID Intelligent Battery Backup Unit (IBBU) .................... 44

4.6 Adding a Second Power Supply Module ......................................... 45

4.7 Installing a PCI Riser Card ................................................. 46

4.8 Installing PCI Add-in Cards ................................................. 47

4.9 Installing an I/O Expansion Module .......................................... 48

4.10 Installing a Remote Management Module ....................................... 49

4.11 Installing an Optical Device ................................................ 50

4.12 Installing a Z-U130 Solid State Drive ....................................... 52

Installing a Solid State Drive on the Front Panel Board .................. 52

Installing a Solid State Drive on the Server Board ....................... 53

4.13 Installing the Server into a Rack ........................................... 54

Connecting the Power Cord ................................................ 54

Equipment Rack Precautions ............................................... 54

5 Server Component Replacements ................... 56

5.1 Before You Begin ............................................................ 56

Tools and Supplies Needed ................................................ 56

www.kontron.com