Before using the device for the first time, read these operating instructions
carefully and keep them for later reference. Hand the instructions over
when transferring the device to a third party.
This documentation is copyright protected. Every duplication resp. every
copying, also as extracts, as well as any reproduction of images, even in an
altered state, is only permitted with the written consent of the manufacturer.
Intended use
This device is designed to receive generally approved radio transmissions
in all countries (world receiver) and only for domestic use.
Utilisation other than as described here is not permitted and it could lead
to damages and injuries. No liability will be accepted for damages resulting
from misuse or improper handling, the application of force or unauthorised
modifications.
Technical Data
This appliance fulfills, in regard to conformity with, the fundamental requirements and other relevant provisions of the EMC Directive 2004/108/EC,
the Low Voltage Directive 2006/95/EC and the Ecodesign Directive
2009/125/EC (Commission Regulation 1275/2008 Annex II, No .1).
- 2 -
Power consumption:5 watts
Power consumption Standby: 1.4 W
Operating temperature:+5 ~+35°C
Humidity:5 ~90% (no condensation)
Dimensions (W x H x D): 181 x 111 x 39 mm
Appliance weight:375 g approx.
Power transformer weight:185 g approx.
The technical features of the device enable the frequency ranges stated
above to be set. Various countries may have different national rules on the
radio frequency ranges assigned. Please note that you may not sell, transfer
to third parties or abuse information received outside the assigned radio
frequency ranges.
Tuning ranges (NORMAL/FINE):
FM (VHF) 100 kHz /50 kHz
SW 5 kHz /1 kHz
MW (AM) Europe9 kHz /1 kHz
MW (AM) USA 10 kHz /1 kHz
LW 1 kHz
Sensitivity:SW can be set to 2 intervals
- 3 -
General
Memory positions :1600 (400 for each frequency range)
Headphones
Model:E105
Impedance:32 Ω
Wideband characteristic
Voltage (WBCV):approx. 206 mV
Headphone socket
max. Output voltage:approx. 80 mV
Power transformer
Manufacturer:S&S MFG. LTD.
Model:A400-75
Primary:230 V ~50 Hz / 30 mA
Secondary:7.5 V DC 400 mA / 3VA
Symbols used
These symbols bring to your attention that here a warning notice
follows in regard to one of the following matters:
- Risk of injury,
- Risk of electric shocks,
- Risk of fire,
- Risk of explosion,
plus bringing your attention to important matters such as:
- Information regarding the handling of batteries,
- Information about voltage surges,
- Information about mains-power disconnection.
- 4 -
This symbol warns about submersing the appliance in water or
other liquids.
This symbol warns you about hearing damage.
Note:
With this symbol you are given tips about interaction with the appliance.
Safety information
•This device has not been designed for use by people (including children)
with restricted physical, sensory or intellectual abilities or lack of experience and/or knowledge, unless they are supervised by a responsible
person (for their own safety) or have received instructions on how to
use the device.
•Children should be supervised to ensure that they do not play with
the device.
•In order to avoid the device being switched on unintentionally, remove
the adapter from the mains socket after each use and before cleaning.
•Check the device and all parts for visible damage. The device’s safety
concept can only work if the device is in perfect condition.
•A mains adapter connected to the device must always be easily
accessible so that the device can be quickly disconnected from the
mains power in an emergency.
- 5 -
Risk of electric shock!
•Connect the mains-power adapter only to correctly installed and
earthed mains sockets. Ensure that the rating of the local power
supply tallies completely with the details given on the rating plate of
the appliance.
•Damaged adapters or mains cables should be exchanged immediately
by an authorised technician or the Customer Service in order to
avoid risks.
•Connection cables or devices that do not work perfectly or have been
damaged should be repaired or exchanged immediately by Customer
Services.
Never immerse the device in water! Simply wipe it with a slightly
damp cloth.
•Do not expose the wall wart to rain or use it in a damp or wet
environment.
•Ensure that the connection cable is never wet or damp when in use.
•You must not open or repair the device’s housing. This can be dangerous
and renders the warranty null and void.
•Protect the device from moisture and sprayed water. Therefore do not
place any objects filled with water (e.g. vases) on or near the device.
Risk of fire!
•Do not use the device near hot surfaces.
•Do not set the device up where it is exposed to direct sunlight.
This could cause it to overheat and damage it beyond repair.
•Never leave the device unattended during operation.
•Never cover the device’s ventilation slots when it is switched on.
•Do not place open flames, such as candles, on or near the device.
- 6 -
Risk of injury
•Keep children away from the connection cable and device.
Children frequently underestimate the danger of electrical devices.
•If the device has fallen down or is damaged it must no longer be used.
Have the device checked by a qualified specialist and, if necessary,
repaired.
•Batteries must not be handled by children.
Children can put batteries in their mouths and swallow them.
If a battery has been swallowed, obtain medical assistance immediately.
Thunder storms!
Devices connected to mains power can be damaged during a thunder
storm. If there is a thunder storm, always remove the mains plug from
the socket.
Information on voltage surges (EFT/electrical fast
transient) and electrostatic discharges:
If the product does not work properly due to electrical fast transient
processes (voltage surges) or electrostatic discharge, it must be
reset to restore normal operation. If necessary, remove the plug from
the power socket and insert it again. The batteries (if used) must be
removed and reinserted.
Information on separating the device from
mains power
The POWER button on this device does not completely separate it from
the mains network. In addition, the device uses power when in standby
mode. In order to completely separate the device from the mains supply
the plug must be removed from the mains socket.
- 7 -
Notes on handling batteries
The device uses batteries. Please note the following on handling batteries:
Risk of explosion!
Do not throw batteries into a fire. Do not recharge batteries.
•Never open, solder or weld batteries. There is a risk of explosion and injury!
•Check batteries regularly. Leaking batteries can damage the device.
•If the appliance is not going to be used for long periods, remove the
batteries.
•If batteries leak, put on protective gloves.
•Clean the battery compartment and contacts with a dry cloth.
Caution!
No liability/warranty applies to damage to the device caused by
moisture due to water penetrating the device or overheating!
- 8 -
Operating elements
Front panel
Save buttons M.0/5 - M.4/9
q
Display
w
Button SNOOZE
e
Waveband selector switch (LW/SW/MW/FM)
r
POWER button
t
FINE button
y
PAGE button
u
UP/DOWN buttons
i
VOL+(AL-1)/VOL-(AL-2) buttons
o
MODE button
a
BASS button
s
MEMORY SCAN button
d
MEM button
f
Loudspeakers
g
Back
Stand
h
Aerial
j
Carrying strap
k
switch SW SEN. (DX/LX)
l
Headphone output
;
EXT. DC 7.5 V 400 mA: Mains adapter connection
2)
- 9 -
Loading...
+ 23 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.