Kompernass EBENCH MANICURE AND PEDICURE SET User Manual

Page 1
Landesgewerbeanstalt Bayern
Nürnberg
Operating and safety instructions
Page 2
Kompernaß Handelsgesellschaft mbH Burgstraße 21 · D-44867 Bochum (Germany)
Operating instructions
Page 4 - 9
Page 3


 
Page 4
4
IMPORTANT SAFETY ADVICES
Please read the following safety advice carefully before you use your manicure /pedicure set for the first time.
Your manicure /pedicure set is intended for personal and domestic use only. To maintain the appliance in good working order, we recommend that it is switched off for 15 minutes after each 20 minute period of continuous operation.
01. Before you use the appliance for the first time, please
check that the local mains voltage is the same as the voltage on the adapter.
02. Store the appliance out of children's reach. Close
supervision is necessary when the appliance is used by, on, or near children, invalids or disabled persons.
03. Do not use the appliance when bathing or showering.
Do not place or store the appliance where it could fall into a bath or washbasin. Do not submerge or drop it into water or any other liquid.
04. Do not try to reach the appliance if it falls into water.
Pull out the mains plug immediately.
05. Avoid overheating the appliance - do not use under
a pillow or blanket.
06. Never operate the appliance if it has a defective cable,
is faulty or is damaged or has fallen into water.
07. Do not carry the appliance by the mains cable or use the
mains cable as a handle.
08. Keep the appliance and the cable away from hot surfaces.
09. Should the appliance malfunction, do not attempt to
rectify it yourself. Take it to an electrical service centre to be repaired.
10. Use the appliance for its intended purpose only, as described in this manual.
We hope you enjoy using your manicure /pedicure set.
5
Adapter specification:
Input: 120 V ~ 60 Hz Output: 2.8 V DC 500 mA
MAIN COMPONENTS
Disks for shaping and shortening the nailsPolishing coneThin manicure pointThick manicure pointFine cylindrical skin removerCoarse cylindrical skin removerBrushAdapterAppliance housingPlastic manicure /pedicure boxNail drierOn/Off switch for nail drierAdapter bay
CHARGING THE APPLIANCE
1. For battery powered use, the appliance has to be charged
for at least 24 hours before the first use in order to ensure that the rechargeable batteries are fully charged.
2. The normal recharging time is six hours.
3. To charge, put the switch into the "0" (Off) position. Connect the appliance to the charger and plug the adapter into the mains socket. The charge indicator light should illuminate. Before using the appliance, disconnect the charger from the mains.
USE OF THE APPLIANCE WITH THE MAINS ADAPTER
1. If the batteries are empty, the appliance can also be used with the supplied adapter directly from the mains. No other adapter is to be used.
2. Connect the appliance to the adapter and plug the adapter into the mains socket.
3. Where the adapter is used to drive the unit with empty batteries, allow 30 seconds for the unit to achieve full power.
Page 5
6
OPERATING INSTRUCTIONS
1. Check that the appliance voltage and the main voltage are identical. Then plug the adapter into the mains socket.
2. The manicure /pedicure set is now ready for use.
3. Attach one of the attachments to the appliance and start the manicure or pedicure treatment. There are two speeds available which you select using the switch.
4. A better result is obtained for pedicure if the feet are washed before the treatment begins.
Warning! From time to time in the treatment, stop and check on the results so far. This is recommended particularly for diabetics because sufferers can often experience loss of sensation in the skin and this could lead to injury.
THE MANICURE /PEDICURE SET WITH 7 INTERCHANGEABLE ATTACHMENTS
The individual attachments can be simply pushed on to the appliance and after use pulled off again (see figure).
Next you can see some suggestions on how to use the diffe­rent attachments:
A. DISK FOR FILING NAILS
:
Use this attachment to file and shape thick hard nails. With regular use nails become stronger and less likely to break. Intended for use on finger and toenails.
B. POLISHING DISK
:
Use for polishing and rounding the edges of the nails after filing and for polishing the nail surface.
C. THIN MANICURE POINT
:
Use for removing dead skin and for treating ingrown nails. Always use this attachment working from the outside of the nail towards the centre.
D. THICK MANICURE POINT
:
Use this attachment for treating and filing horny toenails.
E. COARSE CYLINDRICAL SKIN REMOVER :
Use for removing hard skin and corns. Move the attachment carefully and smoothly over the parts being treated. Bath the feet after treatment and massage in some moisturising cream or lotion.
7
F. COARSE CYLINDRICAL SKIN REMOVER :
Use for removing hard skin from the heel and sole.
G. BRUSH :
Use for final cleaning of the nails after treatment.
USE OF THE INTEGRATED NAIL DRIER
1. Plug the cable into the socket at the back of the manicure /pedicure box.
2. Then plug the adapter into the mains socket.
3. Place the hand on the nail drier and push forward so that the finger ends are on the inside.
4. Start the appliance by pressing on the drier on/off switch . Keep the fingers still whilst they are in the air stream. Finally remove the hand from the appliance.
CARE AND CLEANING
1. The supplied adapter was designed especially for use with the manicure /pedicure set and if it becomes damaged it is to be replaced by an original adapter.
2. Do not allow the appliance to drop as this can damage the internal parts.
3. Always make sure that the adapter is out of the socket before cleaning the appliance.
4. Never use solvents or abrasive cleaning agents to clean the appliance housing. Just wipe with a damp cloth instead.
5. From time to time the appliance can be cleaned with alcohol (70% - 90% by volume).
Page 6
8
ENVIRONMENTAL PROTECTION (DISPOSAL OF Ni-Cd BATTERIES)
1. Unscrew the screw protected by plastic cover (remove it with a flat tool) in the bottom of the housing and open the appliance.
2. Open the housing and remove the batteries and dispose of them properly.
3. Before disposing of the whole appliance, be sure to remove the batteries. Note: Any service or repair centre can dispose of the batteries for you. The service centre's staff will be pleased to help you.
4. Before disposal, the batteries should be completely empty. To do this let the appliance operate until the motor no longer runs.
5. This appliance contains nickel-cadmium batteries. For environmental reasons they are not
to be disposed of with normal domestic waste. You can take empty batteries to a service centre or to one of the many special disposal stations.
Illustrations of the attachments:
Disks for shaping and shortening nails
Polishing cone
Thin manicure point
Thick manicure point
Fine cylindrical skin remover
Coarse cylindrical skin remover
Brush
9
STATEMENT OF CONFORMITY
We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, hereby declare that this product conforms with the following EC regulations:
EC low voltage regulations: Electromagnetic compatibility: Applicable harmonised standards:
Test report issued by: LGA / Intertek Testing Service
Type: PSA-112D Description of the machinery: CORD/CORDLESS MANICURE /PEDICURE SET WITH NAIL DRYER
Bochum, 01.05.2002
Hans Kompernaß
- Managing Director -
73/23 EEG, 93/68 EEG 89/336 EEG, 92/31 EEG EN 60742, EN 55014-2, 55014-1, EN 61000-3-2, EN 61000-3-3
Page 7
© design, photos and translations by
ORFGEN Marketing & Communication
Essen · Germany
www.orfgen-nm.de
Loading...