Kohler K-1179, K-1491, K-772-N1, K-9696, K-772-H2 User Manual

...

PRISTINE



FEATURES

BATH WHIRLPOOL

• 60” (152.4cm) x 42” (106.7cm) x 20--3/8” (51.8cm)

• Cast iron with Safeguard



slip--resistant finish

• K--772--N1 -- 2 hp variable speed pump with 1.5 kW

heater, back--lit user control, and pulsating neckjets pillow

• K--772--H2 -- 1.5 hp variable speed pump with 1.5 kW

heater, and back--lit user control

• 6 Flexjets

• UL Listed

• LESS ALL TRIM

K-772-H2, K-772-N1

CODES/STANDARDS APPLICABLE

Specified model meets or exceeds the following:

• ASME/ANSI A112.19.1M

• ASME/ANSI A112.19.7M

• IAPMO/UPC

• Underwriters Laboratories (UL)

COLORS/FINISHES

• 0White

• Other Refer to Price Book for additional colors

Accessories:

• CP Polished Chrome

• PB Polished Brass

• Other Refer to Price Book for additional finishes

• NA None Applicable

SPECIFIED MODEL:

Model Description Colors/Finishes

K-772-H2 Bath whirlpool K-772-N1 Bath whirlpool with neckjets and pillow (shown)

V0White VOther______ V0White VOther______

Required Accessories

K-9696 Jet trim kit

Recommended Accessories

K-7161-AF Drain

Optional Accessories

K-583 Undermount installation kit (template and installation instructions) K-1179 Vinyl tiling-in bead (use when wall material contacts any top surface of bath) K-1491 Pillow K-1601 Footstop K-1703 Remote control (for K-772-H2) OR K-1705 Remote control (for K-772-N1)

VCP VPB VOther______

VNA

VNA V0White VOther______ V0White VOther______

VNA

PRODUCT SPECIFICATION:

The bath whirlpool shall be 60” (152.4cm) in length, 42” (106.7cm) in width, and 20-3/8” (51.8cm) in height. Bath whirlpool shall be made of cast iron with Safeguard

1.5 kW heater, back-lit user control, and pulsating neckjets with pillow. K-772-H2 bath whirlpool shall have 6 Flexjets, 1.5 hp variable speed pump, 1.5 kW heater, and back-lit user control. Bath whirlpool shall be UL listed. Bath whirlpool shall be less all trim. Bath whirlpool shall be Kohler Model K-772-_______-_______.

We reserve the right to make revisions without notice in the design of fixtures or in packaging unless this right has specifically been waived at the time the order is accepted.



finish. K-772-N1 bath whirlpool shall have 6 Flexjets, 2 hp variable speed pump,

Page1of2 1019471-4-A

PRISTINE



PRODUCT INFORMATION

Fixture*: basin area top area weight Bathing

well

To overflow

* Approximate measurements for comparison only.

Product Pump Heater Voltage Frequency Amperage

Neckjets 2HP 1.5 kW 240 V 50/60 Hz 15 A w/o

Neckjets

42” (106.7cm) x 26” (66cm)

water depth capacity 15” (38.1cm) 70 gal. (265L)

1.5 HP 1.5 kW 240 V 50/60 Hz 11 A

21” (53.3cm)

54” (137.2cm) x 32” (81.3cm)

460 lbs. (208.7kg)

REQUIRED ELECTRICAL SERVICE

Dedicated circuit required, protected with Class A Ground-Fault Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB):

Pump/control 220/240 V, 20 A, 50/60 Hz

INSTALLATION NOTES

Install this product according to the installation guide. Floor support under whirlpool must provide for a minimum

of 1500 lbs. (680.4kg) Hot water supply should be 70% of capacity or greater.

Installations will vary.

No change in measurements if connected with drain illustrated. (K-7161-AF or K-7161M-AF)

Drop-in cut-out 58-1/2” (148.6cm) x 40-1/2” (102.9cm) Cut-out for undermount K-583 template

Minimum access panel: Pump/control 34” (86.4cm) W x

15” (38.1cm) H

required

1-7/8” (4.8cm)

8-7/8”(22.5cm)

60” (152.4cm)

3-1/4” (8.3cm)

2-7/8”(7.3cm) 3” (7.6cm)

1/4” (6mm)

PRODUCT DIAGRAM

K-772-H2, K-772-N1 PristineBath Whirlpool

Page2of2 1019471-4-A

PUMP/CONTROL ACCESS

3/4” (1.9cm)

20-3/8” (51.8cm)

1-1/2” O.D.

42” (106.7cm)