Kohler K1124HL0 User Manual
ARCHERTM
Features
Acrylic
•
8 color-matched Kohler hydro-massage jets
•
Integral apron with removable access panel
•
Pump with air switch and grounding-type plug-in cord
•
Integral tile flange
•
In-line heater
•
Left or right drain
•
Slotted overflow for maximum bathing depth
•
Armrests
•
72″ (182.9 cm) x 36″ (91.4 cm) x 19″ (48.3 cm)
•
Codes/Standards Applicable
Specified model meets or exceeds the following:
ADA
•
ICC/ANSI A117.1
•
ANSI Z124.1.2
•
ASME A112.19.7M
•
ASTM E162
•
ASTM E662
•
UL 1795
•
State of Massachusetts
•
Specified Model
6’ (1.8 m) BATH WHIRLPOOL WITH
HEATER
K-1124-HL
ALSO K-1124-HR
Colors/Finishes
0: White
•
Other: Refer to Price Book for additional colors/finishes
•
Accessories
0: White
•
CP: Polished Chrome
•
Other: Refer to Price Book for additional colors/finishes
•
Model Description Colors/Finishes
K-1124-HL Bath whirlpool with heater and integral apron, left drain ❑ 0 ❑ Other_____
K-1124-HR Bath whirlpool with heater and integral apron, right drain ❑ 0 ❑ Other_____
Required Accessories
K-7271 Clearflo slotted overflow brass bath drain OR ❑ CP ❑ Other_____
K-7272 Clearflo slotted overflow bath drain – PVC pipe ❑ CP ❑ Other_____
Optional Accessories
K-9529 Removable bath seat ❑ 0
Product Specification
The acrylic bath whirlpool shall be 72″ (182.9 cm) in length, 36″ (91.4 cm) in width, and 19″ (48.3 cm) in height. Product shall
feature 8 color-matched jets and armrests. Product shall feature a pump with air switch and grounding-type cord. Product shall
have an in-line heater. Product shall feature an integral apron with removable access panel, and integral tile flange. Product
shall be available with left or right drain. Product shall feature a slotted overflow, low threshold height, and integral lumbar
support. Bath whirlpool shall be Kohler Model K-1124-______-______.
Page 1 of 2
1071367-4-
E
USA/Canada: 1-800-4KOHLER
(1-800-456-4537)
www.kohler.com
ARCHERTM
Technical Information
Fixture*:
Bathing well
Basin area, bottom 51-3/8″ (130.5 cm) x 21″ (53.3 cm)
Basin area, top 64-1/2″ (163.8 cm) x 30-1/2″
(77.5 cm)
Weight 140 lbs (63.5 kg)
To overflow
Water depth 15″ (38.1 cm)
Capacity 72 gal (273 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7
Heater: kW V Hz A
1.5 120 60 12.5
Pump is supplied with 24″ (61 cm) grounding-type plug-in
cord.
Required Electrical Service
(2 required)
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control/Heater 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 43 lbs/square foot (210 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
18"
(45.7 cm)
1-1/4"
(3.2 cm)
2-1/2"
(6.4 cm)
1-1/2"
Bath Drain
11-1/4"
(28.6 cm)
72" (182.9 cm)
4-1/8"
(10.5 cm)
No change in measurements if connected
with drain illustrated. (K-7272)
1-1/4"
(3.2 cm)
1/2" (1.3 cm) R.
Integral Flange
Detail
36" (91.4 cm)
19"
(48.3 cm)
3/4" (1.9 cm)
Product Diagram
ARCHERTM 6’ (1.8 m) BATH WHIRLPOOL WITH HEATER
Page2of2
1071367-4-
E
Loading...