Kohler K1122HL0 User Manual
ARCHERTM
Features
Acrylic
•
8 color-matched Kohler hydro-massage jets
•
Integral apron with removable access panel
•
Pump with air switch and grounding-type plug-in cord
•
Integral tile flange
•
In-line heater
•
Left or right drain
•
Slotted overflow for maximum bathing depth
•
Integral lumbar support
•
Armrests
•
60″ (152.4 cm) x 32″ (81.3 cm) x 19″ (48.3 cm)
•
Codes/Standards Applicable
Specified model meets or exceeds the following:
ADA
•
ICC/ANSI A117.1
•
ASME A112.19.7M
•
ANSI Z124.1.2
•
ASTM E162
•
ASTM E662
•
Specified Model
5’ (1.5 m) BATH WHIRLPOOL WITH
HEATER
K-1122-HL
ALSO K-1122-HR
Colors/Finishes
0: White
•
Other: Refer to Price Book for additional colors/finishes
•
Accessories
CP: Polished Chrome
•
Other: Refer to Price Book for additional colors/finishes
•
Model Description Colors/Finishes
K-1122-HL Bath whirlpool with integral apron and heater, left drain ❑ 0 ❑ Other_____
K-1122-HR Bath whirlpool with integral apron and heater, right drain ❑ 0 ❑ Other_____
Required Accessories
K-7271 Clearflo slotted overflow brass bath drain OR ❑ CP ❑ Other_____
K-7272 Clearflo slotted overflow bath drain – PVC pipe ❑ CP ❑ Other_____
Product Specification
The acrylic bath whirlpool shall be 60″ (152.4 cm) in length, 32″ (81.3 cm) in width, and 19″ (48.3 cm) in height. Bath whirlpool
shall have 8 color-matched jets and pump with air switch and grounding-type plug-in cord. Bath whirlpool shall have an in-line
heater. Bath whirlpool shall have an integral apron with removable access panel and integral tile flange. Bath whirlpool shall
have left or right drain. Bath whirlpool shall have slotted overflow for maximum bathing depth, low threshold height, and integral
lumbar support. Bath shall have armrests. Bath whirlpool shall be Kohler Model K-1122-______-______.
Page 1 of 2
1071359-4-
D
USA/Canada: 1-800-4KOHLER
(1-800-456-4537)
www.kohler.com
ARCHERTM
Technical Information
Fixture*:
Bathing well:
Basin area, bottom 45-1/8″ (114.6 cm) x 19-11/16″
(50 cm)
Basin area, top 52-3/4″ (134 cm) x 25-5/16″
(64.3 cm)
Weight 140 lbs (63.5 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 58 gal (219.5 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7
Heater: kW V Hz A
1.5 120 60 12.5
Required Electrical Service
(2 required)
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 49 lbs/square foot (240 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
No change in measurements if connected
with drain illustrated. (K-7272)
16"
(40.6 cm)
1-1/4"
(3.2 cm)
2-1/2"
(6.4 cm)
1-1/2"
Bath Drain
11-1/4"
(28.6 cm)
60" (152.4 cm)
4-1/8"
(10.5 cm)
1-1/4"
(3.2 cm)
1/2" (1.3 cm) R.
Integral Flange
Detail
32" (81.3 cm)
19"
(48.3 cm)
3/4" (1.9 cm)
Product Diagram
ARCHERTM 5’ (1.5 m) BATH WHIRLPOOL WITH HEATER
Page2of2
1071359-4-
D
Loading...