Kohler K1122GRA0 User Manual
ARCHERTM
Features
Acrylic
•
Integral apron with removable access panel
•
Blower motor with 300 W heater, and electronic user
•
control
Blower motor is supplied with a grounding-type
•
plug-in cord
Left or right drain
•
120 BubbleMassage
•
Integral tile flange
•
Slotted overflow for maximum bathing depth
•
Low threshold height
•
Integral lumbar support
•
Armrests
•
60″ (152.4 cm) x 32″ (81.3 cm) x 19″ (48.3 cm)
•
TM airjets
Codes/Standards Applicable
Specified model meets or exceeds the following:
ANSI Z124.1.2
•
IAPMO IGC 171
•
Specified Model
5’ (1.5 m) BUBBLEMASSAGETM BATH
WITH AIRJETS
K-1122-GRA
ALSO K-1122-GLA
Colors/Finishes
0: White
•
Other: Refer to Price Book for additional colors/finishes
•
Accessories
CP: Polished Chrome
•
Other: Refer to Price Book for additional colors/finishes
•
NA: None applicable
•
Model Description Colors/Finishes
K-1122-GLA Integral apron, left drain ❑ 0 ❑ Other_____
K-1122-GRA Integral apron, right drain ❑ 0 ❑ Other_____
Required Accessories
K-7271 Clearflo slotted overflow brass bath drain OR ❑ CP ❑ Other_____
K-7272 Clearflo slotted overflow bath drain – PVC pipe ❑ CP ❑ Other_____
Recommended Accessories
K-1446 Remote blower installation kit NA
Product Specification
The acrylic bath with airjets shall be 60″ (152.4 cm) in length, 32″ (81.3 cm) in width, and 19″ (48.3 cm) in height. Bath shall
shall have an integral apron and removable access panel. Bath shall have a blower motor with 300 W heater, and an electronic
user control. The blower motor shall have a grounding-type plug-in cord. Bath shall have left or right drain. Bath shall have 120
BubbleMassage airjets. Bath shall have an integral tile flange. Bath shall have slotted overflow for maximum bathing depth, low
threshold height, and integral lumbar support. Bath shall have armrests. The bath with airjets shall be Kohler Model
K-1122-_______-_______.
Page 1 of 2
1071361-4-
D
USA/Canada: 1-800-4KOHLER
(1-800-456-4537)
www.kohler.com
ARCHERTM
Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
Basin area,
top
Weight 100 lbs (45.4 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 58 gal (219.5 L)
* Approximate measurements for comparison only.
Blower
motor:
45-1/8″ (114.6 cm) x 19-11/16″ (50 cm)
52-3/4″ (134 cm) x 25-5/16″ (64.3 cm)
Heater V Hz A
300 W 120 60 5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor: 120 V, 15 A, 60 Hz
Blower motor is supplied with a 24″ (61 cm)
grounding-type plug-in cord.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 46 lbs/square foot (223 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
16"
(40.6 cm)
2-1/2"
(6.4 cm)
1-1/2"
Bath Drain
1-1/4"
(3.2 cm)
11-1/4"
(28.6 cm)
60" (152.4 cm)
4-1/8"
3/4" (1.9 cm)
(10.5 cm)
No change in measurements if connected with
drain illustrated. (K-7272)
1-1/4"
(3.2 cm)
1/2" (1.3 cm) R.
Integral Flange
Detail
32"
(81.3 cm)
19"
(48.3 cm)
Product Diagram
ARCHERTM 5’ (1.5 m) BUBBLEMASSAGETM BATH WITH AIRJETS
Page2of2
1071361-4-
D
Loading...