Kohler K1122G0 User Manual
ARCHERTM
Features
Acrylic
•
Blower motor with 300 W heater, and electronic user
•
control
Blower motor is supplied with a grounding-type
•
plug-in cord
120 BubbleMassage
•
Drop-in
•
Slotted overflow for maximum bathing depth
•
Low threshold height
•
Integral lumbar support
•
Armrests
•
60″ (152.4 cm) x 32″ (81.3 cm) x 19″ (48.3 cm)
•
TM airjets
Codes/Standards Applicable
Specified model meets or exceeds the following:
ADA
•
ANSI Z124.1.2
•
IAPMO IGC 171
•
ASTM E162
•
ASTM E662
•
UL 1795
•
Specified Model
5’ (1.5 m) BUBBLEMASSAGETM BATH
WITH AIRJETS
K-1122-G
Colors/Finishes
0: White
•
Other: Refer to Price Book for additional colors/finishes
•
Accessories
CP: Polished Chrome
•
NA: None applicable
•
Other: Refer to Price Book for additional colors/finishes
•
Model Description Colors/Finishes
K-1122-G Drop-in rim style ❑ 0 ❑ Other_____
Required Accessories
K-7271 Clearflo slotted overflow brass bath drain OR ❑ CP ❑ Other_____
K-7272 Clearflo slotted overflow bath drain – PVC pipe ❑ CP ❑ Other_____
Recommended Accessories
K-1446 Remote blower/motor installation kit NA
Product Specification
The drop-in acrylic bath with airjets shall be 60″ (152.4 cm) in length, 32″ (81.3 cm) in width, and 19″ (48.3 cm) in height. Bath
shall have a blower motor with 300 W heater, and an electronic user control. The blower motor shall have a grounding-type
plug-in cord. Bath shall have 120 BubbleMassage airjets. Bath shall have slotted overflow for maximum bathing depth and low
threshold height. Bath shall have an integral lumbar support and armrests. The bath with airjets shall be Kohler Model
K-1122-G-_______.
Page 1 of 2
1071360-4-
E
USA/Canada: 1-800-4KOHLER
(1-800-456-4537)
www.kohler.com
ARCHERTM
Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
Basin area, top 52-3/4″ (134 cm) x 25-5/16″ (64.3 cm)
Weight 84 lbs (38.1 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 58 gal (219.5 L)
* Approximate measurements for comparison only.
Drop-in cutout 58-1/2″ (148.6 cm) x 30-1/2″ (77.5 cm)
Blower
motor:
45-1/8″ (114.6 cm) x 19-11/16″
(50 cm)
Heater V Hz A
300 W 120 60 5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor: 120 V, 15 A, 60 Hz
Blower motor is supplied with a 24″ (61 cm)
grounding-type plug-in cord.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 45 lbs/square foot (218 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
A blower motor access panel is required.
This product is designed for a drop-in installation only. It is not
suited for use in a three-wall alcove with an overhead shower.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
No change in measurements if connected
with drain illustrated. (K-7272)
16"
(40.6 cm)
1-1/4"
(3.2 cm)
2-1/2"
(6.4 cm)
1-1/2"
Bath Drain
11-1/4"
(28.6 cm)
60" (152.4 cm)
4-1/8"
(10.5 cm)
1-1/2"
(3.8 cm)
Drop-In Rim
Detail
Blower Motor Access
20" (50.8 cm) W x
15" (38.1 cm) H
32" (81.3 cm)
19"
(48.3 cm)
3/4" (1.9 cm)
Product Diagram
ARCHERTM 5’ (1.5 m) BUBBLEMASSAGETM BATH WITH AIRJETS
Page2of2
1071360-4-
E
Loading...