FCC compliance and advisory ...................................................................... 47
ivwww.kodak.com/go/support
1Getting started
Welcome to your Kodak EasyShare digital picture frame. Viewing your pictures and
videos couldn’t be simpler!
Installing the software
See the
wireless network.
Wireless Setup Guide
to install the software and to set up your frame and
Using the remote control
Activating the remote control
An activation tab protects the remote control’s battery during shipment.
■ Remove the tab to start using the remote.
There is no need to open the battery compartment
or remove the battery.
Storing the remote control
1Install the remote control holder on the back of the
1
2
frame (page i).
www.kodak.com/go/support 1
2Slide the remote into the holder for convenient,
out-of-the-way storage.
Getting started
Replacing the remote control battery
NOTE: Replace with a CR2025, 3V lithium cell battery.
1Push and hold the release tab while pulling the
release
tab
battery holder out of the remote. Follow the graphic
on the back of the remote control.
2Place the new battery in the holder with the plus
sign (+) facing up as shown.
3Slide the battery and holder into the remote until it
clicks into place.
2www.kodak.com/go/support
Getting started
Using the remote control buttons
Some buttons are also on the back of the frame (page ii). They operate identically.
ButtonPress to:
power*turn on/off the picture frame.
homereturn to the home screen.
back
OK
menu
music/picstoggle between viewing pictures and selecting
music.
menudisplay the menu choices.
backreturn to the previous screen.
stop a slide show, display thumbnails.
OKaccept the current selection.
4-waynavigate through pictures or menus.
zoom magnify the picture.
rotate rotate the picture, 90
° clockwise each press.
select mark pictures for an operation.
slide showplay a slide show.
play/pauseplay/pause a video or slide show.
rewind rewind a video.
www.kodak.com/go/support
fast forward fast forward a video.
stopstop a video, display the first frame.
stop a slide show, display thumbnails.
volumedecrease (-) or increase (+) the volume.
mute mute audio.
* First, turn on the power switch on the frame.
3
Getting started
Setting up your picture frame
Buttons and controls
All buttons and controls described in this guide (for
example: press ) are on the remote control
backOKmenu
unless otherwise noted.
Connecting the power cable
1Pull out and extend the stand on the frame back and place the frame on a flat,
stable surface.
2Plug in the power cable.
Your power cable (included with the frame) may be different from the one
pictured. Use the plug that accommodates your type of power outlet.
4www.kodak.com/go/support
Inserting a card or camera
Getting started
CompactFlash
MicroDrive
Secure Digital
Memory Stick
xD
MultiMedia Card
Connecting a digital camera or other USB device
b)
a) USB cable included with your USB
device.
b) USB adapter cable included with
your EX model picture frame.
a)
www.kodak.com/go/support
5
Getting started
Turning on the frame
■ Press the power switch to On.
Setting your language
NOTE:
You can leave the power switch On, and use the
remote control to turn the frame off and on.
The language screen appears the first time you turn on
your frame.
■ Press to select your language, then press OK.
A slide show starts from sample pictures pre-loaded in
internal memory.
■ To change the language at a later time, press Home
, Settings
→Language. See page 20.
6www.kodak.com/go/support
Viewing your first slide show!
■ To play a slide show, insert a memory card or USB
device (see page 5).
The pictures/videos are displayed in the order they
appear on the card or other device.
– If a slide show is already playing (for example,
from the pre-loaded sample pictures), your
pictures begin playing automatically.
– If you are at the Home screen, press to
highlight your picture source, then press to
start the slide show.
Getting started
■To play music with your pictures or slide shows, see page 12.
■To view pictures from your computer over your wireless network, see page 25. For
setting up your network, see the
Wireless Setup Guide
.
Changing the frame orientation
Your frame is set up to display pictures in landscape orientation . You can turn it
to portrait but you must also change the setting. Here’s how.
1 Press Home , Settings .
2Press to select Viewing options, then press OK.
3Press to select Frame orientation, then press OK.
See page 19.
www.kodak.com/go/support
7
2Viewing pictures and videos
Home screen—picture sources and settings
Go to the Home screen to access pictures from all connected sources and to change
frame settings.
1On the remote control, press Home .
All connected sources and the Settings icon are
displayed.
2Press to highlight a picture source, then:
■Press to start a slide show.
■Press OK to display thumbnails, folders, albums.
Possible picture sources:
My Frame—the frame’s internal memory. Copy your special pictures into My Frame
from a memory card or other device (page 14).
Memory card—appears when you insert a card (page 5). The label and icon
indicate the type of card.
Camera—appears when you connect a digital camera via USB cable (page 5).
USB drive—appears when you insert a USB flash drive (page 5).
Network computer —appears if you are connected to a wireless network. Lets you
display pictures that are stored on your computer. See the
Chapter 5 in this guide.
Kodak
to a wireless network. Lets you display your albums from the Gallery. See the
Wireless Setup Guide
Kodak
with you at the Gallery! See page 27.
Gallery—appears if you have set up your Gallery account and are connected
or Chapter 5 in this guide.
Gallery, with new picture notification —someone has shared pictures
Wireless Setup Guide
or
8www.kodak.com/go/support
Viewing pictures and videos
Settings—customize and configure your frame. See Changing frame settings,
page 18.
Running a slide show
There are three ways to start a slide show on your frame:
■ Insert a memory card or connect a USB device, then turn on the frame.
■ Turn on your frame, then insert a card or connect a USB device—a new slide show
starts automatically, replacing a currently running slide show or single view
picture.
■ Select a picture in thumbnail view or select a picture source on the Home screen,
then press or .
Other slide show information
–A slide show plays continuously until you stop it or turn off the frame.
–You can change the slide duration and transition style (see page 19).
Viewing thumbnails
There are two ways to view your pictures as thumbnails:
■ Press , select a picture source (see page 8), then
press OK.
■ Press or from a slide show or single view.
To navigate through the thumbnails, press .
www.kodak.com/go/support
9
Viewing pictures and videos
Viewing a single picture
■ To view a single, full-screen picture, highlight it in thumbnails view and press OK.
■ To magnify a picture up to 8X, press repeatedly. To view other parts of the
picture, press . Press repeatedly to return.
■ To rotate a picture, press .
Playing a video
■ To play a video from thumbnails view, highlight it and press OK.
■ Videos in thumbnail view:
–MOV videos are indicated with .
–AVI, MPEG, and MPG videos display the first frame.
■ During a slide show, videos play automatically. When the video ends, the slide
show resumes.
■ Video buttons on the remote control:
PressTo
play, pause, and resume the video.
rewind / fast forward.
adjust the volume.
or stop the video and return to thumbnails.
10www.kodak.com/go/support
Viewing pictures and videos
Viewing pictures by date or filename
By default, the pictures and videos on your frame are arranged and played by date,
starting with the oldest. You can change the arrangement, or sort order, by date or
alphabetically by filename.
To change the sort order:
1Press , then select Sort by.
2Press OK.
3Select a sort order:
–Date, oldest to newest (default)
–Date, newest to oldest
–Filename, A to Z
–Filename, Z to A
4Press OK.
www.kodak.com/go/support
11
3Doing more with your frame
Playing music
Play your MP3 files from any connected source (see page 8).
1Press .
Your picture or slide show is paused.
2Press to highlight your music source, then press
OK.
3Press to locate your music files, then press OK.
4Press to go to the next or previous song, or select
Play all songs. Then press OK.
Your music starts playing.
5Press to return to your picture or slide show.
Your selected music continues to play as the slide show resumes. When music is playing,
videos play without their related audio.
6To turn off music, press , then .
7Press again to return to your pictures.
Notes on playing and copying music:
■ A headphone jack is available on the side of the frame (page ii).
■ Adjust the volume with the buttons. Press to mute the music.
■ To copy music files (MP3) to internal memory, drag and drop them from your
computer. See Copying pictures to/from your computer, page 15.
12www.kodak.com/go/support
Loading...
+ 42 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.