Kodak E-2549 User Manual

Using the KODAK PROFESSIONAL READYLOAD Single-Sheet Packet
TECHNICAL DATA /
KODAK PROFESSIONAL READYLOAD Single-Sheet Packets and the KODAK PROFESSIONAL READYLOAD Packet Film Holder provide a very convenient way to expose 4 x 5-inch sheet film.You can use them together as a handy alternative to standard 4 x 5-inch sheet-film holders.
You’ll have less equipment to carry, because you can use a single holder to make as many exposures as you need. The sealed packet also keeps light, fingerprints, and dust safely away from the film.
Each READYLOAD Single-Sheet Packet contains one sheet of 4 x 5-inch film, which is attached on both ends to a leader and trailer. The lighttight outer envelope performs the same function as a dark slide in a conventional sheet-film holder.
REFERENCE
KODAK PROFESSIONAL READYLOAD Single-Sheet Packets
New READYLOAD Single-Sheet Packets offer these features:
• One preloaded 4 x 5-inch sheet of film per packet
• Great ease and convenience of use—no darkroom or loading bags required; lighter and less bulky than standard 4 x 5-inch film holders
• Less time in the dark—no more film holders to load and unload
• Protection against light leaks, dust, and dirt during use
• Protection against abrasions and fingerprints that can occur while loading sheet-film holders
• Easy unloading for processing with standard processing equipment
• Color-coded packet graphics for easy film identification
• Compatibility with the POLAROID Model 545i Film Holder
August 2007 E-2549
Film Availability
The films packaged in KODAK PROFESSIONAL READYLOAD Single-Sheet Packets are listed below. Refer to www.kodak.com/go/readyload for more information on these films.
KODAK Film CAT No.
PROFESSIONAL PORTRA 160VC Film 834 6926
PROFESSIONAL EKTACHROME E100G 840 3545
PROFESSIONAL EKTACHROME E100VS 825 4328
PROFESSIONAL T-MAX 100 / 100TMX 894 9281
KODAK PROFESSIONAL READYLOAD Packet Film Holder
This 4 x 5-inch film holder fits any standard press or view camera, as well as many scientific and recording instruments. The holder can replace or complement your standard 4 x 5-inch sheet-film holders.
Use this holder to expose film packaged in KODAK PROFESSIONAL READYLOAD Single-Sheet Packets. It offers the following features:
• Accurate alignment and positioning in the film plane
• Light weight and easy to use
©Eastman Kodak Company, 2007
INSTRUCTIONS
Using KODAK PROFESSIONAL READYLOAD Single-Sheet Packets in the KODAK PROFESSIONAL READYLOAD Packet Film Holder
To expose the film, follow these steps:
1. Grasp the end of the packet and insert it into the holder until it comes to a firm stop.
2. When you are ready to expose the film, grasp the end of the outer protective envelope as shown and pull it out until it stops. You should see part of the stop zone.
Do not squeeze the release bar during this step.
6. Wrap an “Exposed” sticker around the end of the packet with the metal clip.
Stop Zone
3. Expose the film as you normally do.
4. Push the outer envelope all the way into the holder until it comes to a firm stop. Do not squeeze the
release bar during this step.
5. To remove the packet from the holder, squeeze and hold the release bar. Then grasp the end of the packet as shown, and pull it straight out. Do not bend the packet when you remove it from the holder.
2 Using the KODAK PROFESSIONAL READYLOAD Single-Sheet Packet E-2549
Loading...
+ 2 hidden pages