
CIS-225 
February 2002
CURRENT INFORMATION SUMMARY
Opening Instructions for the
 MAX Water & Sport One-Time-Use Camera
Wear eye protection when opening all cameras.
Wind Off
1
E
27
• Do not remove 
• Check frame counter to make sure “E”
is aligned with the arrow.
• If not, grip camera and cover the lens 
with your hand; then press 
button
 and turn 
is fully rewound.
thumbwheel
thumbwheel
shutter button
0
thumbwheel
.
shutter
 until film
Remove Back Cover
3
Break Vacuum Seal
2
• Insert sharp edge of hand tool into the 
vacuum-seal circle on bottom of camera 
to release pressure.
Open Film Door
4
• Insert tool end securely into the 
camera-back slot below the strap post.
• Hold camera steady and lift tool directly 
up to disengage the door snaps.
• Pry off the back cover.
Remove Film
5
• Invert camera to remove film.
• Insert tool end into the film-door slot.
• Pry the film door up to open.
• Place used camera in the Kodak
6
CAUTION: Before you attempt the opening 
tasks, make sure the tool is fully engaged 
with the camera body to prevent tool slippage.
recycle bin.
• Visit our Web site at 
www.kodak.com/go/kes
about Kodak’s recycling program.
• Call Kodak’s advertising distribution 
center at (800) 847-8755 to order 
a Kodak hand-opening tool.
© Eastman Kodak Company, 2002
http://
 for details

Current Information Summaries
 provide information of limited or specific
application. Responsibility for judging the timeliness and applicability of the
information to a specific photographic use rests with the end user .
                                    Consumer Imaging
EASTMAN KODAK COMP ANY • ROCHESTER, NY 14650
CIS-225                     Kodak and Max are trademarks. 
Opening Instructions for the KODAK MAX      New 2-02
Water & Sport One-T ime-Use Camera