Kodak 5300 User Manual
EasyShare 5300
10
Black Ink Cartridge
10
Color Ink Cartridge
All-in-One Printer
Start Here
EasyShare 5300
All-in-One Printer
Proofsheet
Photo
Scan Copy
Start
Cancel On/Off
Attention
TransferRotate Zoom
HelpMenu
Print
Copy
Scan
Black Ink Cartridge
Color Ink Cartridge
10
10
Note: A USB 2.0 cable is required to connect your Kodak All-in-One Printer to your Windows or Macintosh OS computer.
Identify Main Components
1.
2.
3.
4.
5.
1. Scanner glass
6.
7.
8.
11.
12.
EasyShare 5300
All-in-O
n
e
Pr
inter
10.
13.
All-in-One Printer
Easyshare 5300
16.
9.
14.
15.
9. USB drive/PictBridge port
2
2. Printer access door
3. Output tray
4. Paper-width guide
5. Main tray
6. Photo tray
7. Paper-length guide
8. Photo tray light
10. Memory card light
11. Memory card slots
12. Control panel
13. USB port
14. Power connector
15. Rear access door
16. Scanner lid
www.kodak.com/go/aiosupport
1
E
Unpack Printer and Install Control Panel
IMPORTANT: Do not connect the USB cable to the printer until instructed during
software installation.
a) See box flaps for unpacking instructions.
Remove all orange shipping tape from the printer.
b) If not preinstalled, insert the control panel overlay,
bottom end first.
OK
EasyShare 5300
All-in-One Printer
Zoom
e
Rotat
Photo
Scan Copy
Menu
Cancel
EasyShare 5300
All-in-One Printer
OK
c) Press down on all edges of the overlay until
Transfer
Proofsheet
Help
OK
On/Off
Attention
it snaps into position.
www.kodak.com/go/aiosupport
3
2
Load Paper
a) Load photo paper into the photo tray.
Lift the photo tray lid until it remains standing without
support. Insert the photo paper glossy side down.
IMPORTANT: Do not overload the photo tray.
Max 20 sheets.
b) Push the photo tray in until it clicks into place.
NOTE: You can only print to the photo tray when the
photo tray is pushed in.
Lower the photo tray lid.
c) Load plain white paper into the main tray.
4
www.kodak.com/go/aiosupport
3
Install Printhead
IMPORTANT: The printhead is fragile. Handle
carefully.
a) Lift the printer access door. Make sure the orange
tape is removed from the carriage.
b) Remove the printhead from its bag.
IMPORTANT: Insert the printhead immediately
upon opening sealed bag.
c) Pull on the orange tab to remove the protective retainer.
www.kodak.com/go/aiosupport
5
Install Printhead
d) Carefully remove and discard the black plastic shield
and the orange protective cap.
IMPORTANT: Do not touch the copper-colored
contacts.
e) Place the printhead into the carriage. Insert at the
angle shown.
6
f) Push firmly against the back wall of the printhead
until it clicks into place.
Tip: The printhead requires a firm push and makes
an audible click when locked into place.
www.kodak.com/go/aiosupport
Loading...