Kodak 5300 User Manual

TransferRotate Zoom

Attention

Cancel On/Off

Help

Menu

Scan Copy

Photo

Proofsheet

OK

EasyShare 5300

All-in-One Printer

*1K1194*
*1K1194*

1K1198

Troubleshooting

If you have additional questions about troubleshooting this device, please
visit www.kodak.com/go/5300aiosupport

PROBLEM:

I cannot get a calibration sheet to print.

SOLUTION:

Where necessary, you can force a calibration sheet to print by following these
steps:

1. Press Menu, select Calibrate Printer and press OK.

2. Select Print Calibration Page and press OK.

3. When the print comes out, place it at the front, right corner of the scanner
glass.

4. Close the scanner lid and press START.

PROBLEM:

I cannot print to my desired paper type.

SOLUTION:

Check to see if the photo tray is pushed in. You can do this by checking if the
green photo tray light is illuminated. If it is, all prints will be produced from
this tray. If you want to print from the main tray, pull out the photo tray by
lifting the photo tray lid and sliding the paper tray towards you (see step 6d).

PROBLEM:

I have a paper jam.

SOLUTION:

1. Press in the tabs on the rear access door to remove the door.

2. Gently pull the paper out of the rollers.
IMPORTANT: If the paper tears while removing it, check inside the
printer for torn pieces of paper and remove them. Additional jams are
likely to occur if all of the torn pieces are not removed.

3. Replace the rear access door. Gently push the door forwards until it snaps
into place.

Is further troubleshooting required?

If you need further information to help answer your questions, please contact
Technical Support and have your KSN number ready. Your KSN number can
be found on the unit after lifting the printer access door as shown.

Helpful tips

Pull out the output tray extender
to help collect your 216 x 297 mm
(8.5 x 11.7") prints.

The photo tray light illuminates
when the photo tray is pushed in.
To use the main paper tray,
disengage the photo tray by
pulling it towards you.

Identify main components

a) Remove the black ink

cartridge from its bag.

b) Carefully remove and
discard the orange cap.
Handle ink cartridges
carefully to avoid ink
transfer.

Install ink cartridges

IMPORTANT: Insert ink

cartridges immediately
upon opening sealed bag.

4

c) Insert the black ink

cartridge into the
printhead.

10

Bla

c
k in

k c

ar

trid

ge

10

Black in

k
car

trid

g
e

C

ol

o

ur

i

n

k

car

tridg

e

1

0

f) Press down firmly on the

ink cartridge until you
hear it click into position.

It is normal for the printhead
to flex when inserting the
cartridge. You will not
damage the printer.

g) Close the printer access door.

d) Press down on the ink

cartridge until you hear
it click into position.

10

B
la

c
k i

n
k

c

ar

t
r

i
d

g
e

10

e) Open and uncap the colour
ink cartridge. Insert it into
the printhead.

10

Bla

c
k

in

k
c

a

rt
r

id

g
e

1

0

C

o

l

o

ur

i

n

k

c

a

r

t

r

i

d

ge

10

Bla

ck

ink

ca

rtr

idg

e

f) Push firmly against the top

of the white label on the
printhead until it clicks into
place.

e) Place the printhead into
the carriage. Insert at the
angle shown.

Tip: The printhead requires a
firm push and makes an audible
click when locked into place.

IMPORTANT: Insert the
printhead immediately
upon opening sealed bag.

IMPORTANT: The printhead
is fragile. Handle carefully.

a) Lift the printer access door.
Make sure the orange tape
is removed from the carriage.

b) Remove the printhead from
its bag.

c) Pull on the orange tab to
remove the protective
retainer.

Install printhead

3

d) Carefully remove and discard

the clear plastic shield and the
orange protective cap.

IMPORTANT: Do not touch
the copper-coloured contacts.

PU

LL

IMPORTANT: The blue arrow in the corner of the calibration sheet
must point to the registration marks as shown.

a) Press Start. Wait two minutes
for the calibration sheet to print.

b) Remove the calibration sheet
from the output tray. Place it
face down and align to the front,
right corner of the scanner glass,
as shown.

c) Lower the scanner lid and
press Start. The ON/OFF
light will turn solid green
when the calibration is complete.
Remove the sheet from the
scanner glass.

Calibrate printer

Tip: If the calibration sheet

does not print properly, see
the Troubleshooting section
in this set-up poster.

6

IMPORTANT: Make sure that the photo tray is pushed in. The photo

tray light should be lit.

b) Remove the plastic film from the LCD
display. Position the LCD display
and press ON.

a) Connect the power supply
and adaptor.

Connect power

5

d) Lift the photo tray lid, then slide the

photo tray towards you to return to
main tray operation. The photo tray
light will turn o.

Control panel features

Unpack printer

a) See box flaps for unpacking

instructions.

b) Remove all orange shipping
tape from the printer.

IMPORTANT: Do not connect the USB cable to the printer until
instructed during software installation.

Install Macintosh software

b) Download the EasyShare

AiO software from

www.kodak.com/go/5300aiosupport.

c) Double-click the .dmg file to
open it.

d) Wait for the Kodak EasyShare
Installer icon to appear on your
desktop and double-click on it.

a) Connect the USB cable to
the printer and your
computer.

e) Click on the
Install Software.app
icon and follow
the on-screen prompts.

More accessories
More options
More convenience

Kodak's inkjet photo paper

Get prints that look great the first
time with Kodak's unique backprint
technology that automatically
enables optimised prints.

Two-sided printing accessory

It's easy to print both sides of your
document with the Kodak EasyShare
5000 Series two-sided printing
accessory.

Wireless adaptor

Go wireless with the Kodak wireless

2.0 USB Bluetooth adaptor.

Value packs

Save up to 50% on everything you
print and pay as little as 7p per print
with our ink and paper value packs.

Note: A USB 2.0 cable is required to connect your Kodak All-in-One printer
to your Windows or Macintosh OS computer. Available in the Kodak online
store or see your local retailer.

The KODAK EasyShare All-in-One Printer gives you more. Be sure to visit
our online store to select from our full line of supplies and accessories at

www.kodak.com/go/AiO.

Ea
s
y
S

h
a

re
5
3

0
0

Al
l

-

in-One
P
ri
n

ter

Rear access
door

Power connector

USB port

Control panel

Scanner lid

A
ll

­i
n

­O
n

e
P

r
i
nte

r

Eas
ySh

ar
e

53

00

Memory card
light

Memory card
slots

USB drive/
PictBridge port

Photo tray light

Photo tray

Paper-length
guide

Paper-width
guide

Main tray

Output tray

Printer access
door

Scanner glass

A

ll

­i
n

-O
n

e

P
r

i
n

t
e

r

E
asy

S

h

a
r

e

5
3

0
0

4x6

4x6

4

x6

Rotates the picture on the display

Zooms in or out in .05X increments

Displays the proofsheet menu when
there are pictures on an inserted memory
card or connected USB host device

Transfers images from a device
connected to a USB host port, PictBridge
or Picture Transfer Protocol (PTP)

Indicates attention is needed. When
illuminated, see LCD screen for further
instruction

Displays photos, messages, status
and menus

Displays the Main menu on the LCD
screen

Displays the Help menu on the LCD
screen

E

a
s
y

S

h
a
r

e 5

30

0

All

-

in­On

e

P
rin
te

r

*E*
*E*

E

You can access and use the AiO Home Centre by double-clicking on the
icon on your desktop.

Getting started

The AiO Home Centre will enable
you to copy, scan and configure
your AiO printer from the
computer. You can also launch
Kodak EasyShare software for
transferring, viewing and working
with your digital pictures and
videos.

Windows

Macintosh

The AiO Home Centre will enable
you to configure your AiO printer
from the computer. You can also
order supplies and launch Kodak
EasyShare software for
transferring, viewing and working
with your digital pictures and
videos. Use the Kodak EasyShare
AiO drivers to print and scan to
your AiO printer.

Eastman Kodak Company
Rochester, NY 14650 U.S.A.
© Eastman Kodak Company, 2007
MC/MR/TM: Kodak, EasyShare.

The Bluetooth® trade marks are
owned by the Bluetooth SIG, Inc.

Printed in the U.S.A.

www.kodak.com/go/5300aiosupport

Need more help? Look here for answers:

KODAK SERVICE NUMBER

F330065

*F330065*
*F330065*

a) If not pre-installed, insert
the control panel overlay,
bottom end first.

b) Press down on all edges of
the overlay until it snaps
into position.

Install control panel

1

Load paper

2

IMPORTANT: Do not overload

the photo tray. Max 20 sheets.

1) Lift the photo tray lid. Insert
the photo paper glossy side

down.

3) 4)

1)

2)

b) Load plain white paper into the main tray.

a) Load photo paper into the photo tray.

2) Push the photo tray in

until it clicks into place.

NOTE: You can only print to
the photo tray when the photo
tray is pushed in.

3) Lower the photo tray lid.

T

ra

ns

fe

r
R

o

t

at

e

Zo

o

m

A

t

t

e

n

t

io

n

C

an

c

e

l

O

n

/O

ff

H

el

p
M

en

u

S

can

Copy

P

ho

to

Pr

o

o

f

s

h

e

et

E

a

sy

S

hare

530

0

All-in-

O

ne

Pr

inter

O

K

Eas

y

Sh

ar

e

530

0

All-in-O

n

e Pri

n

ter

O

K

O

K

Vista XP

a) Load the Kodak EasyShare

CD into the CD-ROM drive.
If instructions do not appear,
click Start, then Run. Select
CD-ROM drive and type
setup.exe, then press ENTER.

b) If connected to the Internet,
select Web Install to get the
latest upgrades for your
printer.

c) Follow the on screen prompts
to install the AiO software.

Install Windows Software

IMPORTANT: Do not connect the USB cable to the printer until

instructed during software installation.

d) Connect the printer to
the USB port. Click Next
and follow the on screen
prompts.

e) When the EasyShare AiO dialog box appears, close the window.

If prompted, re-boot your
computer.

7

W

i
r
e

l
es

s

2
.

0

U

S

B
B
l

u
e

t
o

o
t
h

a

d

a
p

t

o

r

Windows

Start All Programs Kodak

Macintosh

Library Documentation Kodak AiO Printers

The User Guide is installed with your Kodak AiO software and is located:

User guide

10

B
l
a
c
k
i
n
k
ca
r
t
r
i
dg
e

10

B
l
a
c
k
i
n
k
ca
r
t
r
i
dg
e

Windows® is a registered trade mark
of Microsoft Corporation

Macintosh® is a registered
trade mark of Apple Computer, Inc.

Print
Copy
Scan

All-in-One Printer

EasyShare 5300

Start here

Box contents

TransferRotate Zoom

Attention

Cancel On/Off

HelpMenu

Scan Copy

Photo

Start

Proofsheet

A
ll

­in

­O

n
e

P

r
i

nt

e
r

E

a
s

y
S

ha

r
e

5
3

0
0

Software CD
and brochure

Power supply

and adaptor

Printhead

Control panel overlay

(may be pre-installed)

Sample paper

packs

Black and colour

ink cartridges

1

0

B
la
ck
ink
car

tr
id
g
e

1

0

B
la
ck
ink
car

tr
id
g
e

10

C
o

l
ou

r
i

nk

c
a

r
tri

d

g
e

10

C
o

l
ou

r
i

nk

c
a

r
tri

d
g

e