KitchenAid KSM175PSHY INSTALLATION INSTRUCTIONS AND OPERATION MANUAL

K45 Series

KSM45–KSM200 Series

PARTS AND FEATURES

3	2	10
4	1
5		11
9		8
6

7

12	13
	14	15

1Motor Head (locking lever not shown)

2Attachment Knob

3Attachment Hub

4Motor Head

5Speed Control Lever

6Beater Height Adjustment screw (not shown)

7Bowl Clamping Plate

8Bowl**

9Beater Shaft

10Pouring shield*

113 L Stainless Steel Bowl*

12Flat Beater

13Flex Edge Beater*

14Wire Whip

15Dough Hook

*Included with select models only. Also available as an optional accessory. **The bowl design and material depend on the Stand Mixer model.

PRODUCT SAFETY

<![if ! IE]> <![endif]>ENGLISH

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed, including the following:

1.Read all instructions.

2.To protect against risk of electrical shock, do not put Stand Mixer in water or other liquid.

3.This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they are closely supervised and instructed concerning use of the appliance by a person responsible for their safety. Close supervision is necessary when any appliance is used by or near children. Children should be supervised to ensure that they do not play with the appliance.

4.Turn the appliance OFF, then unplug from the outlet when not in use, before assembling or disassembling parts, and before cleaning. To unplug, grasp the plug and pull from the outlet. Never pull from the power cord.

5.Avoid contacting moving parts. Keep hands, hair, and clothing, as well

as spatulas and other utensils, away from beater during operation to reduce the risk of injury to persons and/or damage to the Stand Mixer.

6.Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Contact the manufacturer at their customer service telephone number for information on examination, repair, or adjustment.

7.The use of accessories or attachments not recommended or sold by the manufacturer may cause fire, electric shock or injury.

8.Do not use the Stand Mixer outdoors.

3

PRODUCT SAFETY

9.Do not let the cord hang over the edge of table or counter.

10.Remove the beaters, wire whip, or dough hook from the Stand Mixer before washing.

SAVE THESE INSTRUCTIONS

This product is designed for household use only.

ELECTRICAL REQUIREMENTS

GETTING STARTED

Voltage: 120 V Frequency: 60 Hz

Wattage: 275 Watts MAX for models K45, KSM45-KSM80

300 Watts MAX for models KSM85-KSM110

325 Watts MAX for models KSM120-KSM200

NOTE: The power rating for your Stand Mixer is printed on the serial plate.

Do not use an extension cord. If the power supply cord is too short, have

a qualified electrician or service technician install an outlet near the appliance.

The maximum rating is based on the attachment that draws the greatest load (power). Other recommended attachments may draw significantly less power.

CHOOSING THE RIGHT ACCESSORY

	Accessories	Use to mix	Suggested items
	Flat Beater (12)	Normal	Cakes, creamed frostings, candies, cookies,
	Flex Edge Beater*	to heavy
			biscuits, pie pastry, meatloaf, mashed potatoes
	(13)	mixtures
	Wire Whip (14)	Mixtures	Eggs, egg whites, heavy cream, boiled frostings,
		that need air
			sponge cakes, mayonnaise, some candies
		incorporated
	Dough Hook (15)	Mixing and
		kneading yeast	Breads, rolls, pizza dough, buns
		doughs

*Included with select models only. Also available as an optional accessory.

4

SPEED CONTROL GUIDE

Note: The speed control can be set to obtain speeds 1, 3, 5, 7, and 9 if a finer adjustment is required. Do not exceed Speed 2 when preparing yeast doughs as this may cause damage to the Stand Mixer.

<![if ! IE]>

<![endif]>ENGLISH

Speed	Accessory	Action	Description
Stir	Flat Beater (12)		For starting all mixing procedures, slow
	Flex Edge Beater* (13)	Stir
			stirring, combining, and mashing.
1
2	Flat Beater (12)		For slow mixing, mashing, and faster
	Flex Edge Beater* (13)		stirring.
		Slow mixing
	Dough Hook (15)		To mix and knead yeast doughs,
			heavy batters, and candies; mix thin or
			splashy batters.
4	Flat Beater (12)		For mixing semi-heavy batters, such
	Flex Edge Beater* (13)		as cookies, or to combine sugar and
		Mixing,	shortening. Medium speed for cake
			mixes.
		beating
	Wire Whip (14)		For adding sugar to egg whites for
			meringues.
6	Flat Beater (12)		For medium-fast beating (creaming),
	Flex Edge Beater* (13)		or whipping. Use to finish mixing cake,
		Beating,	doughnut, and other batters. High
			speed for cake mixes.
		creaming
	Wire Whip (14)		For medium-fast whipping of
			ingredients requiring incorporation of
			air, such as egg whites.
8	Wire Whip (14)	Fast	For whipping cream, egg whites,
		beating,	and boiled frostings.
		whipping

NOTE: To move the speed control lever with ease, lift slightly up as you move it across the settings in either direction.

PRODUCT ASSEMBLY

1

2

Unplug and turn the Stand Mixer “OFF/0”.

Unlock and lift the motor head. Then, lock the head to keep it lifted.

*Included with select models only. Also available as an optional accessory.

5

PRODUCT ASSEMBLY

3

Place the bowl on the clamping plate and twist to lock in place.

5

Unlock the motor head and move it down. Then, lock the head to keep it down. Before mixing, test lock by attempting to raise the motor head.

(OPTIONAL) To adjust beater to bowl clearance: Tilt and lock the motor head back. Turn the screw slightly counterclockwise (left) to raise the beater, or clockwise (right) to lower it. NOTE: If you over-adjust the screw, the bowl lock lever may not lock into place.

4

1

2

Slide and rotate the accessory aligning over the pin on the shaft.

(OPTIONAL) Place the pouring shield*:

Slide the pouring shield* from front of the Stand Mixer over the bowl. The bottom rim of the pouring shield* fits inside of the bowl.

*Included with select models only. Also available as an optional accessory.

6

PRODUCT USAGE

1	<![if ! IE]> <![endif]>ENGLISH

Plug it into a grounded 3 prong outlet. Start with lower speed to avoid splashing and increase it gradually.

Refer to the “Speed Control guide”.

2

Do not scrape the bowl while operating. Scraping the bowl once or twice during mixing is usually sufficient.

(OPTIONAL): Pour ingredients into the bowl through the pouring chute.

7

DISASSEMBLING THE PRODUCT

1

Turn the Stand Mixer “OFF/0” and unplug. Unlock and lift the motor head. Then, lock the head to keep it lifted.

(OPTIONAL): Lift the front of the pouring shield* clear of the rim of the bowl. Pull away from the Stand Mixer.

2

Press the accessory upward, turn it and pull it away from the beater shaft.

3

Twist to unlock the bowl from the clamping plate.

OPTIONAL ATTACHMENTS

KitchenAid® offers a wide range of optional attachments such as the Spiralizer, Pasta Cutters, or Food Grinder that may be attached to the Stand Mixer attachment power hub as shown here.

1

2

Unplug and turn the Stand Mixer “OFF/0”.

Remove the attachment hub cover.

*Included with select models only. Also available as an optional accessory. **The bowl design and material depend on the Stand Mixer model.

8

OPTIONAL ATTACHMENTS

3

4

	Insert attachment into attachment hub,	Tighten the attachment knob by turning it
	making certain that attachment power
		clockwise until the attachment is secured
	shaft fits into the square attachment hub
		to the Stand Mixer.
	socket.

<![if ! IE]>

<![endif]>ENGLISH

CARE AND CLEANING

IMPORTANT: Do not immerse the Stand Mixer body in water or other liquids.

1

Unplug and turn the Stand Mixer

“OFF/0”.

3

Wipe the Stand Mixer body with a soft, damp cloth.

2

Dishwasher-safe parts, top rack only: Stainless steel bowl, bowl lid, flat beater, dough hook, Flex Edge beater*, and

pouring shield*.

4

Clean the wire whip thoroughly with hand

wash only.

*Included with select models only. Also available as an optional accessory.

9

TROUBLESHOOTING GUIDE

WARNING

Electrical Shock Hazard Plug into a grounded 3 prong outlet.

Do not remove ground prong. Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

	Problem	Solution
	If Stand mixer warms up	Under heavy loads with extended mixing time periods, you
		may not be able to comfortably touch the top of the unit.
	during use:
		This is normal.
	If the flat beater hits the bowl:	Stop the Stand mixer. See the “Product Assembly” section
		and adjust the beater to bowl clearance.
	The speed control lever does	To move the speed control lever with ease, lift slightly up as
	not move smoothly or easily:	you move it across the settings in either direction.
		Is the Stand Mixer plugged in?
		Is the fuse in the circuit to the Stand Mixer in working
	If your Stand Mixer should fail	order? If you have a circuit breaker box, be sure the circuit
	to operate, please check the	is closed.
	following:	Turn off the Stand Mixer for 10-15 seconds, then turn it back
		on. If the Stand Mixer still does not start, allow it to cool for
		30 minutes before turning it back on.

Note: If the problem cannot be corrected, See the “Warranty and Service” section. Do not return the Stand Mixer to the retailer; retailers do not provide service.

10

WARRANTY AND SERVICE

KITCHENAID STAND MIXER WARRANTY FOR

THE 50 UNITED STATES, THE DISTRICT OF COLUMBIA, PUERTO RICO, AND CANADA

This warranty extends to the purchaser and any succeeding owner for Stand Mixers operated in the 50 United States, the District of Columbia, Puerto Rico, and Canada.

Length of Warranty:	One Year Full Warranty from date of purchase.
KitchenAid Will Pay	Hassle-Free Replacement of your Stand Mixer. See
for Your Choice of:	the next page for details on how to arrange for
	service, or call the Customer eXperience Center
	toll-free at 1-800-541-6390.
	OR
	The replacement parts and repair labor costs to correct
	defects in materials and workmanship. Service must be
	provided by an Authorized KitchenAid Service Center.
KitchenAid Will	A. Repairs when your Stand Mixer is used in other
Not Pay for:	than normal single family home use.
	B. Damage resulting from accident, alteration,
	misuse or abuse.
	C. Any shipping or handling costs to deliver your
	Stand Mixer to an Authorized Service Center.
	D. Replacement parts or repair labor costs for
	Stand Mixer attachments operated outside the
	50 United States, District of Columbia, Puerto
	Rico, and Canada.

DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES

IMPLIED WARRANTIES, INCLUDING TO THE EXTENT APPLICABLE WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXCLUDED TO THE EXTENT LEGALLY PERMISSIBLE. ANY IMPLIED WARRANTIES THAT MAY

BE IMPOSED BY LAW ARE LIMITED TO ONE YEAR, OR THE SHORTEST PERIOD ALLOWED BY LAW. SOME STATES AND PROVINCES DO NOT ALLOW LIMITATIONS OR EXCLUSIONS ON HOW LONG AN IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.

IF THIS PRODUCT FAILS TO WORK AS WARRANTED, CUSTOMER’S SOLE AND EXCLUSIVE REMEDY SHALL BE REPAIR OR REPLACEMENT ACCORDING TO THE TERMS OF THIS LIMITED WARRANTY. KITCHENAID AND KITCHENAID CANADA DO NOT ASSUME ANY RESPONSIBILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. This warranty gives you specific legal rights and you may also have other rights which vary from state to state or province to province.

<![if ! IE]>

<![endif]>ENGLISH

11