When using electrical appliances, basic safety precautions should always be
followed, including the following:
1. Read all instructions.
2. To protect against the risk of electrical shock, do not put Blender in water or
other liquid.
3. This appliance is not intended for use by persons (including children) with
reduced physical, sensory, or mental capabilities, or lack of experience and
knowledge, unless they are closely supervised and instructed concerning the
use of the appliance by a person responsible for their safety. Close supervision
is necessary when any appliance is used by or near children. Children should be
supervised to ensure that they do not play with the appliance.
4. Turn the appliance OFF, then unplug from the outlet when not in use, before
assembling or disassembling parts and before cleaning. To unplug, grasp the
plug and pull from the outlet. Never pull from the power cord.
5. Avoid contact with moving parts.
6. Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions, or is dropped or damaged in any manner. Contact the
manufacturer at their customer service telephone number for information on
examination, repair, or adjustment.
7. Do not use the appliance outdoors.
8. Do not let cord hang over edge of table or counter.
9. Keep hands and utensils out of the container while blending to reduce the risk of
severe injury to persons or damage to the Blender. A scraper may be used but
must be used only when the Blender is not running.
10. Blades are sharp. Handle carefully.
3
W11382494A.indb 38/7/2019 4:26:47 PM
PRODUCT SAFETY
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
11. Always operate Blender with cover in place.
12. The use of attachments, including canning jars, not recommended by KitchenAid
may cause a risk of injury to persons.
13. When blending hot liquids, remove center piece of two-piece cover.
14. Flashing light indicates ready to operate - avoid any contact with blades or
moveable parts.
SAVE THESE INSTRUCTIONS
This product is designed for household use only.
ELECTRICAL REQUIREMENTS
Voltage: 120 V
Frequency: 60 Hz
Amperage: 6.0 A
NOTE: If the plug does not fit in the outlet,
contact a qualified electrician or service
technician. Do not modify the plug in any
way. Do not use an adapter.
Do not use an extension cord. If the power
supply cord is too short, have a qualified
electrician or service technician to install an
outlet near the appliance.
MOTOR HORSEPOWER
Motor horsepower for the Blender motor was measured using a dynamometer, a machine
that laboratories routinely use to measure the mechanical power of motors. Our 0.9 peak
horsepower (HP) motor reference reflects the horsepower output of the motor itself and not
the Blender’s horsepower output in the Blender pitcher. As with any blender, the power output
in the pitcher is not the same as the horsepower of the motor itself.
4
W11382494A.indb 48/7/2019 4:26:47 PM
ENGLISH
GETTING STARTED
First, clean all parts and accessories (see “Care and Cleaning” section).
Be sure the countertop beneath the Blender and surrounding areas are dry and clean.
The Blender pitcher ingredient cup can be used to measure and add ingredients. Remove cup
and add ingredients at 1 Stir, 2 Chop, or 3 Mix speeds. When operating at higher speeds with
a full pitcher or with hot contents, stop the Blender and then add ingredients.
The Soft Start blending feature automatically starts the Blender at a lower speed to draw
ingredients into the blades, then quickly increases to the selected speed for optimal
performance. The Soft Start blending feature only works when a speed is selected and does
not work with the Pulse mode or Crush Ice features.
Sweet crunch topping ...Pulse, 2 Chop
Vegetable-based main dish sauce .1 Stir
Waffle batter ..................3 Mix
White sauce .................. 1 Stir
5
W11382494A.indb 58/7/2019 4:26:47 PM
PRODUCT ASSEMBLY
IMPORTANT: When moving your Blender, always lift from the Blender base. Base will become
disengaged from pitcher if carried by Blender pitcher or Blender pitcher handle only.
1
Adjust the length of the Blender power
cord.
NOTE: When properly positioned, the pitcher will rest completely on the Blender base.
If not, repeat step 2. Make sure the pitcher is properly locked onto the Blender base.
2
Tab
Slot
Align the pitcher tabs with the slots on the
base. Rotate the pitcher, approximately 1/8
turn until it clicks into the place.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
3
Put the ingredients in the pitcher and firmly
place lid.
6
W11382494A.indb 68/7/2019 4:26:48 PM
4
Plug the Blender into a grounded 3-prong
outlet, and press POWER. The Power
indicator light will flash when ready.
ENGLISH
PRODUCT ASSEMBLY
5
Press desired speed (1 to 5) button for
continuous operation at that speed. The
white indicator light by the selected speed
will stay lit.
IMPORTANT: If blending hot foods or liquids, do not fill to the top of the pitcher, and
operate only on 1 Stir speed. Remove center cap and place towel over lid.
While the Blender Power indicator light or the Pulse mode indicator light is blinking:
• Do not interfere with blade movement.
• Do not remove pitcher lid.
6
When finished, press POWER to turn off.
Unplug the Blender before removing the
pitcher.
7
W11382494A.indb 78/7/2019 4:26:48 PM
PRODUCT USAGE
USING THE CRUSH ICE FUNCTION
Blender offers a CRUSH ICE feature. When selected, the Blender will automatically pulse
for 30 seconds at staggered intervals at the optimal speed for crushing ice or other ingredients.
1
Put ice cubes into the pitcher and firmly
place lid. Use up to 1/2 tray of cubed ice.
TIP: Process up to 1/2 standard ice cube tray or 6 to 7 standard ice cubes at a time.
Occasional stirring with a spatula will be helpful only when Blender is off.
The Crush Ice feature has been optimized to crush and chop ice without adding any
liquid ingredients.
2
Press POWER, then press Crush Ice.
The indicator light will stay lit. When
finished, press the Power to stop.
USING PULSE MODE
1
2
Put ingredients in pitcher and firmly place
lid.
8
W11382494A.indb 88/7/2019 4:26:49 PM
Press POWER, then press and hold
the Pulse button for the desired amount of
blending time. Release the button to stop.
ENGLISH
CARE AND CLEANING
NOTE: Do not immerse the Blender base or cord in water. Do not use abrasive
cleansers or scouring pads to avoid scratching. Unplug the Blender before cleaning.
1
2
Fill half of the pitcher with warm water and
add 1 or 2 drops of dish-washing liquid.
Place the pitcher on the base. Secure the
Lid with ingredient cup.
3
Wipe the Base, Power Cord, Clean Touch
pad, lids and ingredient cups with a warm,
damp cloth and dry with a soft cloth.
Put the lid on the pitcher, press the 1 Stir
speed setting, and run the Blender
for 5 to 10 seconds. Remove the pitcher
and rinse with warm water.
4
Dishwasher-safe parts: Pitcher only.
Blender pitcher can also be washed in the
bottom rack. Or handwash with soapy
water, rinse, and wipe dry.
9
W11382494A.indb 98/7/2019 4:26:50 PM
TROUBLESHOOTING GUIDE
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
TIP: The Blender will not operate at any speed unless the POWER button is pressed first.
ProblemSolution
Check to see if the Blender is securely plugged into a
grounded 3 prong outlet. If it is, press POWER.
If Blender fails to start:
If Blender is plugged in, but
nothing happens when POWER
is pressed, and all indicator
lights are flashing:
If the Blender is plugged in, but
will not start and one light is
flashing alternately from all the
other indicator lights,
If Blender stops while blending:
If ingredients are stuck or not
blending:
If the Blender still does not work, check the fuse or circuit
breaker on the electrical circuit the Blender is connected
to and make sure the circuit is closed.
The motor rotor may be locked. Press POWER; then
unplug the Blender. Plug it back in; then press POWER
and select the desired speed.
The Blender may have a stuck key. Press POWER to
turn off the Blender; then unplug the Blender. Plug the
Blender back in and press POWER to turn back on to
reset the stuck key.
When overloaded or jammed, it will automatically shut off
to prevent motor damage. Press POWER to turn off the
Blender; then unplug the Blender. Remove the pitcher
and use a spatula to rearrange ingredients.
Or, divide contents into smaller batches. For certain
recipes, adding liquid in the pitcher may also reduce the
load.
Press POWER to turn off the Blender; then unplug the
Blender. Remove the pitcher from the Base, and use a
spatula to rearrange ingredients in the pitcher.
If the problem is not due to one of the above items, see the “Warranty and Service” sections.
Do not return the Blender to the retailer. Retailers do not provide service.
10
W11382494A.indb 108/7/2019 4:26:50 PM
ENGLISH
WARRANTY AND SERVICE
KITCHENAID® BLENDER WARRANTY FOR THE 50 UNITED STATES,
THE DISTRICT OF COLUMBIA, PUERTO RICO, AND CANADA
This warranty extends to the purchaser and any succeeding owner for Blender operated
in the 50 United States, the District of Columbia, Puerto Rico, and Canada.
Length of Warranty:One Year Full Warranty from date of purchase.
KitchenAid Will Pay
for Your Choice of:
KitchenAid Will
Not Pay for:
DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES
IMPLIED WARRANTIES, INCLUDING TO THE EXTENT APPLICABLE WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXCLUDED
TO THE EXTENT LEGALLY PERMISSIBLE. ANY IMPLIED WARRANTIES THAT MAY
BE IMPOSED BY LAW ARE LIMITED TO ONE YEAR, OR THE SHORTEST PERIOD
ALLOWED BY LAW. SOME STATES AND PROVINCES DO NOT ALLOW LIMITATIONS
OR EXCLUSIONS ON HOW LONG AN IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY
TO YOU.
IF THIS PRODUCT FAILS TO WORK AS WARRANTED, CUSTOMER’S SOLE AND
EXCLUSIVE REMEDY SHALL BE REPAIR OR REPLACEMENT ACCORDING TO THE
TERMS OF THIS LIMITED WARRANTY. KITCHENAID AND KITCHENAID CANADA
DO NOT ASSUME ANY RESPONSIBILITY FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES. This warranty gives you specific legal rights and you may also have other
rights which vary from state to state or province to province.
Hassle-Free Replacement of your Blender. See the next
page for details on how to arrange for service, or call the
Customer eXperience Center
toll-free at 1-800-541-6390.
OR
The replacement parts and repair labor costs to correct
defects in materials and workmanship. Service must be
provided by an Authorized KitchenAid Service Center.
A. Repairs when Blender is used in other than normal
single family home use.
B. Damage resulting from accident, alteration, misuse or
abuse.
C. Any shipping or handling costs to deliver your Blender
to an Authorized Service Center.
D. Replacement parts or repair labor costs for Blender
operated outside the 50 United States, District of
Columbia, Puerto Rico, and Canada.
11
W11382494A.indb 118/7/2019 4:26:50 PM
WARRANTY AND SERVICE
HASSLE-FREE REPLACEMENT WARRANTY – 50 UNITED STATES,
DISTRICT OF COLUMBIA, AND PUERTO RICO
We’re so confident the quality of our
products meets the exacting standards
of KitchenAid that, if your Blender should
fail within the first year of ownership,
KitchenAid will arrange to deliver an
identical or comparable replacement to
your door free of charge and arrange to
have your original Blender returned to us.
Your replacement unit will also be covered
by our one year limited warranty. Please
follow these instructions to receive this
quality service.
If your Blender should fail within the first
year of ownership, simply call our toll-free
Customer eXperience Center
at 1-800-541-6390 Monday through Friday.
Please have your original sales receipt
available when you call. Proof of purchase
will be required to initiate the claim. Give
the consultant your complete shipping
address. (No P.O. Box numbers, please.)
When you receive your replacement
Blender, use the carton and packing
materials to pack up your original Blender.
In the carton, include your name and
address on a sheet of paper along with
a copy of the proof of purchase (register
receipt, credit card slip, etc.).
HASSLE-FREE REPLACEMENT WARRANTY—CANADA
We’re so confident the quality of our
products meets the exacting standards
of the KitchenAid® brand that, if your
Blender should fail within the first year
of ownership, KitchenAid Canada will
replace your Blender with an identical or
comparable replacement. Your replacement
unit will also be covered by our one year
limited warranty. Please follow these
instructions to receive this quality service.
If your Blender should fail within the first
year of ownership, take the Blender or ship
collect to an Authorized KitchenAid
Service Centre. In the carton include your
name and complete shipping address
along with a copy of the proof of purchase
(register receipt, credit card slip, etc.).
Your replacement Blender will be returned
prepaid and insured. If you are unable to
obtain satisfactory service in this manner
call our toll-free Customer eXperience
Centre at 1-800-807-6777.
Or write to us at:
Customer eXperience Centre
KitchenAid Canada
200 - 6750 Century Ave.
Mississauga, ON L5N 0B7
ARRANGING FOR SERVICE AFTER THE WARRANTY EXPIRES, OR
ORDERING ACCESSORIES AND REPLACEMENT PARTS
In the United States and Puerto Rico:
For service information, or to order
accessories or replacement parts, call tollfree at 1-800-541-6390 or write to:
Customer eXperience Center,
KitchenAid Portable Appliances,
P.O. Box 218, St. Joseph, MI 49085-0218