KitchenAid KEHC309JBT0, KEHC379JSS3, KEHC309JBL0, KEHC309JSS0, KEHC379JBL3 Installation Instructions Manual

27" and 30" Electric

Built-in Microwave/

Oven Combination

Quick Reference

Table of Contents:

Pages

_1-_Product dimensions
[_ Cutout dimensions
[] Before you start
[] Electrical requirements

[_ _ Installation steps

If you need assistance:

Check your Use and Care Guide for a toll-free number to call or call

the dealer from whom you purchased this appliance. The dealer is

listed in the Yellow Pages of your phone directory under
"Appliances -- Household -- Major -- Service and Repair."

Call when you:

Have questions about built-in oven installation or operation.

[_ Need to obtain the name and number of an authorized service

company.

When you call, you will need:

The built-in oven model number.

[_ The built-in oven serial number.

Both numbers are listed on the model/serial rating plate, located on

the microwave oven frame.

27" oven

25-3/8

recessed

41"

recessed

height

23" max.
recessed
depth

,26-314"

41-1/4"
cutout

height

1-1/2"

min.

bottom of

cutout to

top of

cab,net

door

"_ 27"min.

cabinetwidth

25-1/2"

,._----- cutout --

width

27" oven

cabinet ----

23-1/4"min.

q[---- cutout depth

23"recessed

oven depth

recessed

oven

Cabinet side view

J

42-7/16"

overall
height

1"top of cutout
tobottomof

upper cabinet
door

f

19-1/4"

bottom of

cutout to

floor

_3_

oven

"_front

41"

recessed

height

23" max.
recessed
depth

30" oven

28-3J8"

29-314"

42-7/16"

overall
height

J

T

41-I/4"

cutout

height

l,

1-1/2" rnin.

bottom of

cutout to

top of

cabinet

door

"9_'-- 30" mm.

cabinet

J

2S-1/2"

cutout ---_

width

30" oven

1"top
of cutout
to bottom

of upper

cabinet door

i

19-1/4"
bottom

of cutout

tofloor

_I_

Cabinet filler kits are available from your dealer.
Use a matching color kit if oven is smaller than your
cabinet opening.

27" ovenfiller height is 7-13/16"

Black -- 4378950

White -- 4378951

Almond- 4378952

30" oven filler height is 4-13116"

Black -- 4378944
White -- 4378945
Almond- 4378946

Important: Observe all governing codes
and ordinances.

Proper installation isyour responsibility.
Have a qualifiedtechnician installthis oven.

Oven location should be away from strong draft
areas, such aswindows, doors and strong
heating vents.

Cabinet opening dimensions that are shown
must be used. Given dimensions provide
minimum clearance.

Recessedinstallation area must provide

complete enclosure around the recessedportion
ofthe oven.

Electrical ground is required. See "Electrical
requirements."

Electrical supply junction boxshould be located
3 inchesmaximum below the support surface

when oven is installed in a wall cabinet.Cutout
for wiring should be in the right rear or left rear

corner. Forundercounter installation,it is
recommended that the junction box be located
in the adjacentright or left cabinet. If installing
junction box on rear wall behind oven, junction

box mustbe recessedand located in the upper
or lower right or left corner of cabinet.

Oven support surface MUST besolid, level and
flush with bottom of cabinetcutout.

Excessive Microwave Energy Exposure

Do Not attempt to operate the microwave
oven with the door open.

Do Not tamper with ordefeat the safety
interlocks.

Do Not place objects between the microwave
oven front face and door.

Do Not allow soil orcleaner residue to
accumulate on sealing surfaceof the

microwave ovendoor.
Do Not operate the microwave oven if

damaged.
Do Not operate the microwaveoven if:

-- door is bent.

-- hinges and latches are broken or loose.

-- door seals, sealing surfaces or glass are
broken.

The microwave oven door mustclose

properly to provide safe operation.
Havea qualified repair person adjust, repair

and check microwave oven for microwave

leakage after a repair is made.
Do Not use microwavefor commercial

purposes. The microwave oven in this unit is
designed for household use only.

Failure tofollow these instructions could
result inexposure to excessive microwave
energy.

It is the customer's responsibility:

To contact a qualified electrical installer.
To assure that theelectrical installation is
adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 -- latest edition*,

and all local codesand ordinances.

Copies of the standards listed may be obtained from:

* National Fire Protection Association

Batterymarch Park

Quincy, Massachusetts 02269

Tool needed:

Phillips screwdriver

Parts supplied:

Page 1