Kidde KN-COB-B-LPM, KN-COB-LP2 Brochure
Battery Operated
Carbon Monoxide Alarm
Model KN-COB-LP2 Part Number: 9CO5-LP2
Battery Operated (2AA’s included)
Provides protection during power outage.
Green Alarm LED
Red Power LED
Test/Reset
Tests CO alarm circuit operation and allows you to
immediately silence the alarm.
Alerts user to replace after
10 years of operation
Description
The Kidde 9CO5-LP2 battery operated carbon monoxide
alarm utilizes sophisticated electronic components to protect you and your family from the dangers of carbon monoxide. This alarm includes a slide-out battery door that gives
immediate access to the batteries and a safety feature that
makes it difficult to close the door without the batteries
being installed. Inside cover of battery door features quick
reference guide for what to do in case of an alarm. This
easy-to-install alarm is suitable for all living areas and has a
10-year life and a 10-year limited warranty.
Consumer Benefits
The Kidde 9CO5-LP2 provides you and your family with a
loud warning signal against the dangers of elevated carbon monoxide levels in your home. The battery operated
CO alarm provides continuous monitoring of CO levels,
even during power outages when AC-only units are not
providing protection. The Low Battery Hush feature temporarily silences the low battery chirp in order to maintain
protection without having to replace the batteries at an
inconvenient time. With the Event Memory feature, if
the unit has detected a CO concentration of 100ppm or
greater the green LED will flash every 10 seconds, which
can be helpful in recognizing a CO event after being away
from home. This carbon monoxide alarm is UL Listed and
offers a 10 year limited warranty.
Features and Benefits
• 2 AA Battery Backup – Provides continuous protection
even during power outages.
• Low Battery Hush – Silences low battery chirp warning
for up to 12 hours in order to maintain protection without
having to replace the batteries at an inconvenient time.
• Event Memory – If the unit has detected CO concentrations of 100ppm or greater, the green LED will flash every
10 seconds.
• Loud 85 Decibel Alarm – Alerts of deadly CO gas.
• Test/Reset Button – Tests the alarm electronics and resets
the unit during alarm.
• Low Battery Signal – Alerts user when the batteries
need to be replaced.
• Green LED – Indicates alarm is receiving power and operating properly.
• Red LED – Illuminates when in alarm mode.
• Quality Design – 10-year limited warranty
• UL Listed – Listed by UL as a Single Station Carbon
Monoxide Alarm
Single Station
Carbon Monoxide
Alarm
Battery Operated
Carbon Monoxide Alarm
Model KN-COB-LP2
Part Number 9CO5-LP2
Architectural and Engineering
Specifications
The carbon monoxide alarm shall be Kidde 9CO5-LP2 or approved
equal. It shall be powered by two (2) AA batteries (included). The unit
has a slide-open door to allow easy access to batteries. The temperature operating range shall be between 40˚F and 100˚F (4˚C and 38˚C)
and the humidity operating range shall be 10% - 95% relative humidity, non condensing.
The CO sensor shall be of a fuel cell design and shall meet the
sensitivity requirements of Underwriters Laboratories UL2034 Single
and Multiple Station Carbon Monoxide Alarms.
The alarm can be installed on the surface of any wall, ceiling or
tabletop following the UL/NFPA/Manufacturer’s recommended placement guidelines. The alarm shall include a battery lockout system that
deters closure of battery door without using two batteries.
The alarm shall include a test button that will electronically simulate the presence of CO and cause the unit to go into alarm. This
sequence tests the unit’s electronics to ensure proper operation.
Per UL 2034 requirements, the CO sensor will not alarm to levels
of CO below 30 ppm and will alarm in the following time range when
exposed to the corresponding levels of CO.
70 ppm CO Concentration 60 – 240 minutes
150 ppm CO Concentration 10 – 50 minutes
400 ppm CO Concentration 4 – 15 minutes
The unit shall incorporate 2 LED’s. A green LED will flash once
every 60 seconds to indicate the alarm is operating properly when
power is present. A red LED will pulse to indicate carbon monoxide
has been detected until the device is reset or CO is eliminated.
The alarm shall include a piezoelectric horn that is rated at 85
decibels at 10 feet. When the unit detects carbon monoxide, the
alarm pattern will be four (4) short beeps – followed by five (5)
seconds of silence – followed by four (4) short beeps with a
corresponding red LED flash. It shall also include a 10-year manufacturer’s limited warranty.
Technical Specifications
Power Source: 2 AA Batteries
Sensor: Electrochemical
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)
Humidity Range: 10%-95% relative humidity (RH),
non-condensing
Size: 4.5”L x 2.75”H x 1.5” D
Weight: .5lb
Wiring: None
Interconnects: No
Warranty: 10 year limited
4.5” 1.5”
2.75”
Ordering Information
Ordering Pack Pack Dimensions Cartons/
Number UPC I 2 of 5 Cong Qty (w x d x h inches) Weight Pallet
21025778 0-47871-08872-0 100-47871-08872-7 Clam 3 6.2 x 7.8 x 11.6 1.8 111
21025807 0-47871-08872-0 700-47871-08872-9 Clam 4 7.4 x 7.9 x 12 2.4 75
21025790 0-47871-08912-3 100-47871-08912-0 Twin Clam 3 10.5 x 10.75 x 6.5 5.34 100
21025788 0-47871-08908-6 100-47871-08908-3 Contractor 6 6.25 x 10.75 x 4 5.34 260
Distributed by:
1016 Corporate Park Drive
Mebane NC 27302
1-800-880-6788
www.Kidde.com
KL-9CO5-LP2 sheet rev. 06-2014
Loading...