Kettler Coach User Manual [de]

Montageanleitung für Rudergerät

„COACH”

Art.-Nr. 7985-600

Der Umwelt zuliebe: Wir drucken auf 100% Altpapier!

F

D

GB

NL

Eine schwache oder erloschene Computeranzeige macht
einen Batteriewechsel erforderlich. Der Computer ist mit
zwei Batterien ausgestattet. Nehmen Sie den Batterie­wechsel wie folgt vor:

■ Nehmen Sie den Batteriefachdeckel ab und ersetzen

Sie die Batterien durch zwei neue vom Typ AA 1,5 V.

■ Achten Sie beim Einsatz der Batterien auf die Kenn-

zeichnung im Batteriefachboden.

■ Sollte es nach dem Wiedereinschalten zu Fehlfunktio-

nen kommen, klemmen Sie die Batterien noch einmal
kurz ab und wieder an.

Wichtig: Geben Sie die verbrauchten Batterien zum Sondermüll.

Aufgebrauchte Batterien fallen nicht unter die Garantiebestimmun­gen.

3

For Your Safety

■ The rowing machine should be used only for its intended pur-

pose, i.e. for physical exercise by adult persons.

■ Any other use of the equipment is prohibited and may be dan-

gerous. The manufacturer cannot be held liable for damage or
injury caused by improper use of the equipment.

■ The rowing machine has been designed in accordance with the

latest standards of safety. Any features which may have been a
possible cause of injury have been avoided or made as safe as
possible.

■ The unit complies with class H of the standard EN 957. It is

therefore unsuitable for therapeutic use.

■ Incorrect repairs and structural modifications (e.g. removal or re-

placement of original parts) may endanger the safety of the user.

■ Damaged components may endanger your safety or reduce the

lifetime of the equipment. For this reason, worn or damaged
parts should be replaced immediately and the equipment taken
out of use until this has been done. Use only original KETTLER
spare parts.

■ In case of enquiry, please contact your KETTLER dealer.

■ If the equipment is in regular use, check all its components thor-

oughly every 1 – 2 months. Pay particular attention to the tight­ness of bolts and nuts.

■ Instruct persons using the equipment (in particular children) on

possible sources of danger during exercising.

■ Before beginning your program of exercise, consult your doc-

tor to ensure that you are fit enough to use the equipment. Base
your program of exercise on the advice given by your doctor.
Incorrect or excessive exercise may damage your health..

Study these instructions carefully before assembling and ucing the equipment. The lnstructions contain important infor­mation for your safety and for the use and maintenance of the rowing machine. Keep the instructions in a safe place
for your own information, for maintenance work and ordering spare parts.

Handling the equipment

■ Before using the equipment for exercise, check carefully to en-

sure that it has been correctly assembled.

■ Do not set the equipment up in rooms which are frequently used or

close to doors, entries etc.

■ It is not recommended to use or store the apparatus in a damp

room as this may cause it to rust. Please ensure that no part of
the machine comes in contact with liquids (drinks, perspiration
etc.). This may cause corrosion.

■ The rowing machine must be set up on an even impact-resistant

base. To absorb the vibrations, lay a straw or rubber mat under
the machine.

■ The product is designed for use by adults and children should not

be allowed to play with it. Children at play behave unpredictably
and dangerous situations may occur for which the manufacturer
cannot be held liable. If, in spite of this, children are allowed to
use the equipment, ensure that they are instructed in its proper use
and supervised accordingly.

■ On principle, the equipment does not require any special main-

tenance. All bearings are pre-lubricated (further lubrication is
not required) and require little maintenance.

■ A slight production of noise at the bearing of the centrifugal

mass is due to the construction and has no negative effect upon
operation.

■ Do not use corrosive or abrasive materials to clean the equip-

ment. Ensure that such materials are not allowed to pollute the
environment.

■ The rowing machine has a brake system, which requires little

maintenance and does not require any adjusting work.

■ To operate correctly, the pulse function requires a minimum vol-

tage of 2,7 volts.

■ Please ensure that liquids or perspiration never enter the ma-

chine or the electronics.

■ Before use, always check all screws and plug-in connections as

well as respective safety devices fit correctly.

Assembly Instructions

GB

B

tern bis zum spürbaren Widerstand zuerst mit der Hand auf,
anschließend ziehen Sie sie gegen den Widerstand (Klemmsi-
cherung) mit einem Schraubenschlüssel richtig fest. Kontrollie­ren Sie alle Schraubverbindungen nach dem Montageschritt
auf festen Sitz. Achtung: wieder gelöste Sicherheitsmuttern wer­den unbrauchbar (Zerstörung der Klemmsicherung) und sind
durch Neue zu ersetzen.

■ Bewahren Sie die Originalverpackung des Gerätes gut auf, da-

mit sie später u. U. als Transportverpackung verwendet werden
kann.

■ Aus fertigungstechnischen Gründen behalten wir uns die Vor-

montage von Bauteilen (z.B. Rohrstopfen) vor.

Benutzen Sie bei diesem Montageschritt geeignetes Un­terlegmaterial (z. B. Verpackung, Styropor, o. ä.), damit
das Gehäuse nicht verkratzt oder beschädigt wird.

A

4

■ Please keep original packaging of this article, so that it may be

used for transport at a later date, if necessary.

■ For technical reasons, we reserve the right to carry out prelimi-

nary assembly work (e.g. addition of tubing plugs).

Please, use suitable supporting material (such as packing
material, polystyrene or similar material) for this assembly
step in order to avoid a scratching or damaging of the hou­sing.

If the computer is too faint to read or disappears complete­ly, the batteries must be changed. The computer requires
two batteries. They are replaced as follows:

■ Remove the lid of the battery compartment and replace

the batteries with two fresh ones of type AA 1,5 V.

■ Ensure that the batteries are inserted as indicated in the

battery compartment.

■ Should the wrong figures be indicated when the com-

puter is switched onagain, disconnect the battery and
reconnect it immediately.

Important: Do not dispose of used batteries along with household
waste.

Spent batteries are not covered by the guarantee.

List of spare parts

When ordering spare parts, always state the full article number,
spare-part number, the quantity required and the inspection num­ber stamped on the back.
Example order: Art. no. 7985-900 / spare-part no. 33100100/

2 pieces / inspection no. ...

Important: spare part prices do not include fastening material; if
fastening material (bolts, nuts, washers etc.) is required, this

should be clearly stated on the order by adding the words „with

fastening material“.

KETTLER GB Ltd. · Kettler House, Merse Road · North Moons Moat · Red­ditch, Worcestershire B98 9HL
KETTLER International Inc. · 1355, London Bridge Road · USA-Virginia
Beach, Virginia 23450
www.kettler.net

A

B

Instructions for Assembly

■ Ensure that you have received all the parts required (see check

list) and that they are undamaged. Should you have any cause
for complaint, please contact your KETTLER dealer.

■ Before assembling the equipment, study the drawings carefully

and carry out the operations in the order shown by the dia­grams. The correct sequence is given in capital letters.

■ Please note that there is always a danger of injury when wor-

king with tools or doing manual work. Therefore please be ca­reful when assembling this machine.

■ Ensure that your working area is free of possible sources of

danger, for example don’t leave any tools lying around. Al­ways dispose packaging material in such a way that it may not
cause any danger. There is always a risk of suffocation if child­ren play with plastic bags!

■ The equipment must be assembled with due care by an adult

person. If in doubt call upon the help of a second person, if pos­sible technically talented.

■ The fastening material required for each assembly step is sho-

wn in the diagram inset. Use the fastening material exactly as
instructed. The required tools are supplied with the equipment.

■ Bolt all the parts together loosely at first, and check that they

have been assembled correctly. Tighten the locknuts by hand un­til resistance is felt, then use spanner to finally tighten nuts com-
pletely against resistance (locking device). Then check that all
screw connections have been tightened firmly. Attention: once
locknuts have been unscrewed they no longer function correctly
(the locking device is destroyed), and must be replaced.

Pour votre sécurité

■ Rameur ne doit être utilisée que pour les fins auxquelles elle est

destinée, c'est-à-dire pour l'entraînement des adultes.

■ Tout autre emploi est interdit, voire dangereux. Le fabricant ne

pourra être rendu responsable de dommages causés par l'em­ploi inadéquat de l'appareil.

■ Vous vous entraînez avec un appareil dont la technique et la

sécurité correspondent aux exigences modernes. Les sources
possibles de danger qui pourraient entraîner des blessures ont
été soit supprimées, soit sécurisées.

■ L´appareil est conforme à la classe H de la norme EN 957 et

convient donc pour soins thérapeutiques.

■ Les réparations inadéquates et les modifications apportées à la

construction de l'appareil (démontage des pièces d'origine,
montage de pièces non autorisées, etc.) peuvent entraîner des
risques imprévus pour l'utilisateur.

■ Les composants endommagés peuvent affecter votre sécurité et

la durée de vie de l'appareil. On remplacera donc sans tarder
les composants usés ou endommagés et on interdira l'emploi
de l'appareil aussi longtemps qu'ils n'auront pas été rempla­cés. N'utiliser que des pièces de rechange KETTLER d'origine.

■ On cas de doute, on est prié de s'adresser à son concession-

naire KETTLER.

■ En cas d'entraînement régulier et intensif, il y a lieu de contrô-

ler, tous les mois ou tous les 2 mois, toutes les pièces de l'ap­pareil et en particulier les vis et les écrous.

■ Attirer l'attention des personnes présentes, surtout des enfants,

sur les dangers qu'ils courent pendant les exercices.

■ Avant de commencer, consulter son médecin traitant pour s'as-

surer que l'entraînement avec l'appareil n'est pas nuisible à la
santé. Son diagnostic devrait servir de base pour la compositi-

on de son programme de travail. Un entraînement exagéré ou
mal organisé peut être nuisible à la santé.

Lire attentivement les présentes instructions avant le montage et la première utilisation de l'appareil. Elles contiennent des renseigne­ments importants relatifs à la sécurité des personnes ainsi qu'à l'emploi et à l'entretien du rameur. Conserver soigneusement les dites
instructions pour d'éventuels renseignements ainsi que pour effectuer l'entretien de l'appareil ou commander des pièces de rechange.

Instructions de montage

F

8

Checkliste (Packungsinhalt)

Checklist (contents of packaging)

Liste de vérification (contenu de l’emballage)

Checklijst (verpakkingsinhoud)

GB

F

NL

13x410mm

13x310mm

M6x90

M8x45

M5x40

ø12

ø16 (M6)

ø25

110mm

40mm

ø20x10mm

1

2

1

1

2

4

2

2

2

4

1

1

1

1

1

1

1

1

1

M8

M5

M6

1

1

ø16 (M8)

2

ø16

ø6,3

ø16

ø8,3