KERN & SOHN THM 1000N100 User Manual
Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: info@sauter.eu
Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www. sauter.eu
Instruction Manual
THM
attached at the instrument. The measuring value can be
read off after a stable measuring value has been obtained.
Thank you for buying a SAUTER test stand. We hope you
are pleased with your high quality test stand with its big
functional range. If you have any queries, wishes or helpful
suggestions, do not hesitate to call our service number.
1. Included in delivery
- SAUTER THM
- Various hooks
2. Drawing and measures (in mm)
3. Warning
Intended use
The instrument you have acquired serves to determine the
measuring value of the material to be measured. It is
intended to be used as a “non-automatic“ instrument, i.e.
the material to be measured is manually and carefully
Be careful about the limit load of test stand and force
gauge. Do not go over the maximum force.
4. Technical Specifications
Capacity: depends on device
Maximum Travel (Y): 200 mm
Travelspeed depends on device (look on
device label)
Work Voltage Single phase 110 V
Rate flow 1,5 A
Fuse of main Circuit 3 A
Fuse of control Circuit 0,5 A
Work temperature 10 bis 30 °C
5. Operation
Turn on the power switch
Adjust the upper and lower limited position block to
suitable position
Choose between „Spot Motion“ (Manual) und „Continoues
Motion“ (Automatic)
Choose perfect measuring speed with „Speed dial“.
6. Attaching of force gauge
With four M 6 Screws
THM-BA-e-1211 1
Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: info@sauter.eu
Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www. sauter.eu
Instruction Manual
THM
550 mm
240 mm
170 mm
Ø: 20 mm
Min: 30 mm
51 mm
250 mm
50 mm
DETAILED DIMENSOINS
Unit net weight: 35 kg
Packing: Wooden box
THM-BA-e-1211 2
Loading...