This instruction manual is used to describe multiple models listed above.
Model availability and features (functions) may differ depending on the country and
sales area.
Caution : Read this page carefully to ensure safe operation.
XD SERIES (En)
U.S.A. and Canada ................................................. AC 120 V only
Austraria ................................................................... AC 240 V only
CH01
Preparation
Europe and U.K. ...................................................... AC 230 V only
*Other countries............... AC 110-120 /220-240 V switchable
Safety precautions
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS
INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE”
WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE
A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER
TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS
IN THE LITERATURE ACCOMPANYING THE APPLIANCE.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The marking of products using lasers
(Except for some areas)
CLASS 1
LASER PRODUCT
The marking is located on the rear panel and says that the component uses laser beams that have been classified as Class 1. It means
that the unit is utilizing laser beams that are of a weaker class. There
is no danger of hazardous radiation outside the unit.
Contents
3
XD SERIES (En)
PreparationOperation
Before applying power ............................................................... 2
Tree discs can be set. There are various ways for enjoyment at the time of program play back, repeat
playback, random playback, etc.
Double cassette deck
Two tape decks are installed, permitting dubbing from tape to tape and relay playback.
Various Sound Settings
The desired sound type can be selected according to the music being played.
Popular (POP), rock (ROCK), jazz (JAZZ), and extra bass (EX.BASS) can be selected.
Convenient Timer Functions
An ON/OFF timer for listening at the same time each day and a sleep timer are provided.
Demonstration
When the power supply is restored after a power failure or the power cord
is unplugged and plugged in again during use, this unit automatically starts
the demonstration function (display only), During the demonstration, the
display changes in sequence but the audio does not change. The
demonstration can be canceled with the following procedure.
Cancellation of Demonstration Mode
DISPLAY
/DEMO
÷ The setting is remembered even when the power is switched off.
When the power is OFF:
Demonstration mode is cancelled by
pressing this key.
When the power is ON:
Switching as shown below takes place
each time this key is pressed.
1 Demonstration mode (execution)
2 Normal display (CD or tuner display)
3 Time display
Unpacking
Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.
Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit was shipped
to you directly, notify the shipping company without delay. Only the consignee (the person or company receiving the unit) can file a claim against the carrier
for shipping damage.
We recommend that you retain the original carton and packing materials for use should you transport or ship the unit in the future.
Keep this manual handy for future reference.
Accessories
FM indoor antenna (1)
Europe and U.K.Other countries
Remote control unit (1)Remote control unit (1)
CD/TUNER
AM loop antenna (1)
IMPORTANT SAFEGUARDS
Caution : Read this page carefully
to ensure safe operation.
5
XD SERIES (En)
Preparation
6
,
,
,
,
,
,
Preparation
XD SERIES (En)
,,
,,
,,,
,,,
,,
,,
Handling of discs and tapes
7
XD SERIES (En)
Disc handling precautions
Handling
Hold compact discs so that you do not
touch the playing surface.
Label side
÷Do not attach paper or tape to either
the playing side or the label side of
compact discs.
÷The paste left on the label surface after
a sticker has been peeled off is a factor
which may cause malfunction. If the
surface is sticky due to remaining paste,
be sure to clean it with alcohole before
use.
Sticker
Playing
side
Sticky paste
Caution on disc used
Discs which can be played with this unit
Cleaning
If fingerprints or foreign matter become
attached to the disc, lightly wipe the
disc with a soft cotton cloth (or similar)
from the center of the disc outwards,
in a radial manner.
Storage
When a disc is not to be played for a
long period of time, remove it from the
CD player and store it in its case.
Never play a cracked or warped disc.
During playback, the disc rotates at high speed in the player.
Therefore, to avoid danger, never use a cracked or deformed disc or a
disc repaired with tape or adhesive agent.
Do not use cleaning discs.
Please do not use commercially available cleaning discs, they may damage the internal mechanism.
CD (12 cm, 8 cm), CDV (only the audio part)
÷With CD-G (CD Graphics) discs, this unit can play only the audio.
Preparation
Notes on cassette tape
Safety tab (accidental erasure prevention tab)
After an important recording has been finished, break
the safety tab, to prevent the recorded contents from
being erased or recorded on accidentally.
For A side
For B side
Apply tape only to the position
where the tab has been removed.
Note
Note
To re-record
1. Longer tape than 110 minutes cassette tape
Since longer tape than 110 minutes cassette tape is
very thin, the tape could adhere to the pinch roller or be
easily cut. It is recommended that these tapes not be
used with this unit to prevent possible damage.
To store cassette tapes
Do not store the tapes in a place which is subject to direct
sunlight, or near equipment that generates heat. Keep the
cassette tapes away from any magnetic field.
N
S
When there is slack in the tape
In such a case, insert a pencil into the reel hole and wind the
reel hub to remove the slack.
2. Endless tapes
Do not use an endless tape, as this could damage the
mechanism of the unit.
System connection
R L
AUX
INPUT
1
2
BEAT
CANCEL
R
L
–
+
+
–
SPEAKERS
(6–16 Ω)
FM 75 Ω
AM
ANTENNA
GND
AC 220–240VAC 110–120V
R L
AUX
INPUT
12
BEAT
CANCEL
R
L
–
+
+
–
SPEAKERS
(6–16 Ω)
FM 75 Ω
AM
ANTENNA
GND
AC 220–240VAC 110–120V
FM 75 Ω
AM
ANTENNA
GND
FM 75 Ω
AM
ANTENNA
GND
Europe and U.K.
Other countries
FM 75 Ω
AM
ANTENNA
GND
FM 75 Ω
AM
ANTENNA
GND
Europe and U.K.
Other countries
10mm 10mm
8
XD SERIES (En)
123
AM loop antenna connection
AM loop antenna connection
The supplied antenna is for
Preparation
indoor use. Place it as far as
possible from the main system, TV set, speaker cords
and power cord, and set it to
a direction which provides
the best reception.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around
the unit (from the largest outer dimensions including projections) equal to, or greater than, shown below.
Rear panel: 10 cm
Europe and U.K.
ANTENNA
FM 75 Ω
Other countries
FM 75 Ω
GND
ANTENNA
GND
AM
SUPER
ANTENNA
WOOFERPRE OUT
FM 75 Ω
AUX INPUT
R L
1
BEAT
CANCEL
2
SPEAKERS
AM
(6–16 Ω)
+
L
–
–
R
+
AM
GND
AC 220–240VAC 110–120V
FM antenna connection
FM indoor antenna connection
The accessory antenna is for
temporary indoor use only.
For stable signal reception
we recommend using an
outdoor antenna. Remove
the indoor antenna if you
connect one outdoors.
FM outdoor antenna
Lead the 75W coaxial
cable connected to the FM
outdoor antenna into the
room and connect it to the
FM 75W termimal.
Note
Note
Never short-circuit the + and –
•
speaker cords.
If the left and right speakers are
•
connected inversely or if the
speaker cords are connected with
reversed polarity, the sound becomes unnatural with ambiguous
acoustic image positioning. Be
sure to connect the speakers and
speaker cords correctly.
1 Strip the coating from the tip of cord
and twist the conductor.
2 Connect to the antenna terminal.
3 Locate the position providing good
reception condition.
4 Fix the antenna.
Antenna adapter
(optional)
Connection of the speaker systen
AUX
INPUT
R L
1
BEAT
CANCEL
2
SPEAKERS
(6–16 Ω)
System connection
9
XD SERIES (En)
Do not plug the power cord into the power outlet until all of the
required connections have been made.
ANTENNA
FM 75 Ω
AM
GND
AC 220–240VAC 110–120V
+
L
–
–
R
+
+
L
–
–
R
+
Connection of options (Optional parts)
SUPER WOOFER
Preparation
Speaker front view (the front
net can not be removed)
Connect only provided main unit.
Connect separately sold parts as shown in the figure.
Do not plug the power cord into the power outlet until all of the
required connections have been made.
MD PLAYER
Audio output
Only XD-A3
SUPER
WOOFER
PRE OUT
AUX INPUT
RL
SUPER
WOOFER
PRE OUT
AUX INPUT
R L
1
BEAT
CANCEL
2
SPEAKERS
(6–16 Ω)
+
L
–
–
R
+
ANTENNA
FM 75 Ω
AM
GND
Controls and indicators
10
XD SERIES (En)
CD unit
123456
4
¢
DISC
SKIP
DISC 1DISC 2DISC 3
1 Skip (4, ¢) keys&
2DISC SKIP key&
Used to skip discs.
3Disc selection keys&
The disc number is selected directly and playback starts.
Receiver unit
Preparation
0
76
7
4OPEN/CLOSE (0) key^
The disc tray is opened and closed.
5Stop (7) key^
6Play/pause (6) key^
7Disc tray^
Three discs can be stored.
£
¢∞
ON/STANDBY
STANDBY
8
9
0
!
@
INPUT
AUTO/MONOTIMER
MIC 1
MIC VOLUME
MIN.
MAX.
MIC 2
TIMER SET
CLOCK
DISPLAY
/DEMO
^
#$ %
8ON/STANDBY (
9INPUT key$
Key for input switching.
0TIMER key§
Key for timer START/STOP switching.
!MIC 1/MIC 2 jack (except for some areas)¢
@MIC VOLUME knob (except for some areas)¢
#TIMER SET key∞
Used for setting the timer ON/OFF time.
$CLOCK key#
Used to set the present time.
%DISPLAY/DEMO key4%
Switches the display contents.
*Used for demonstration (DEMO) ON/OFF.
^AUTO/MONO key)
Switches the tuning mode.
&MANUAL PRESET key¡
Used to memorize broadcasting stations in the desired order.
*BAND key)
Press to switch the receiving band.
) key$
POP
ROCK
UP
EX.BASS
DOWN
AUTO
MANUAL
PRESET
PRESET
FLAT
JAZZ
BAND
TUNING
PHONES
™
¡
&
(
*
(TUNING/
Used for tuning to broadcasting stations and for time settings.
)PHONES terminal%
For connection of a headphone (optional).
¡AUTO PRESET key¡
Used for automatic presetting of broadcasting stations.0
™VOLUME CONTROL knob$
This is used for volume adjustment.
£Sound selection keys%
Used to select the desired sound type.
FLAT: For listening without changing the sound.
JAZZ: A sound quality curve suitable for jazz.
POP: A sound quality curve suitable for popular
music.
ROCK: A sound quality curve suitable for rock-and-roll.
EX.BASS : For listening with abundant bass. (Can be used
together with other sound selection keys.)
¢Display!%
∞STANDBY indicator (Except for some areas)
)
keys#)∞
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.