CASSETTE DECK SECTION
INPUT OUTPUT CASSETE TAPE ALIGNMENT
ALIGN FOR
SETTINGS SETTINGS DECK SETTINGS POINT
0dB = 400mV
1. Cassette mechanism section (REC/PB head adjustment)
Power OFF REC/PB head, Demagnetize the REC/PB head by head
Demagnetization demagnetization, erase head. eraser.Clean the REC/PB head,erase
and cleaning cleaning play capstan,pinch head capstan and pinch roller with a
roller cotton awab immersed in alcohol.
Adjust the output to maximum and
azimuth MTT-114 Azimuth adjust the azimuth adjustment screw
REC/PB Head TCC-153 adjustment for the Lissajours waveform pattern of
azimuth 10KHz,-10dB screw the oscilloscope to become close to a
45' straight line.
2.PC board adjustment
MTT-111 Adjust the tape speed so that 3kHz is
[1] Tape speed TCC-100
AUX OUTPUT
PLAY VR901 obtained at the center of the tape.
3KHz, -4dB (Frequency of 3KHZ +/- 40Hz)
[2]
PLAY BACK
MTT-130
AUX OUTPUT
PLAY – Playback output to 400mV +/- 50mV
LEVEL
CN902 Pin1 and Pin2(GND)
[3] REC BIAS REC/PB
AUX OUTPUT
REC T901 Ensure that the Frequency Counter
Frequency TEST TAPE Adjust T901 to obtain this of 105KHz
AC-224 +/- 5KHz
Record 400Hz and 10.0kHz alternately,
REC/PB and adjust the bias current adjustment
1.TP1(+) and TP2(GND)
REC BIAS TEST TAPE VR903(L) Adjust VR903(L-CH) to obtain this of 3.5mV
[4] Current AC-224 AUX OUTPUT
REC/PLAY
2.TP3(+) and TP4(GND)
VR904(R)
Adjust VR904(R-CH) to obtain this of 3.5mV
AUX IN: 50mV * potentiometer for the playback levels to
400Hz become the same. (Spec.: +/-5dB)
AMPLIFIER SECTION
INPUT OUTPUT AMPLIFIER ALIGNMENT
NO ITEM
SETTING SETTING SETTING POINT
ALIGN FOR
1.R234 Side Pin1 and Pin3
IDLE NO SIGNAL
AUX VR201(L)
Adjust VR201 to obtain this of +8 mV
[1]
CURRENT VR(Min.)
–
FUNCTION VR202(R)
1.R301 Side Pin1 and Pin3
Adjust VR202 to obtain this of +8 mV
(Spec.: +8mV +/-3mV)
# Idle Current: 20mA