Kenwood KVA-S300 Owner's Manual
KVA-S300
AUDIO VIDEO SELECTOR
SELECTEUR AUDIO VIDEO
AUDIO-VIDEO-WÄHLER
AUDIO-VIDEO-KIEZER
SELETTORE AUDIO VIDEO
SELECTOR DE AUDIO VÍDEO
SELECTOR AUDIO VÍDEO
©B64-2020-10 (W) (DT)
INSTRUCTION MANUAL
MODE D’EMPLOI
BEDIENUNGSANLEITUNG
GEBRUIKSAANWIJZING
ISTRUZIONI PER L’USO
MANUAL DE INSTRUCCIONES
MANUAL DE INSTRUÇÕES
2-English
Installation
The use of any accessories except for those provided might result in damage to the unit. Make sure
only to use the accessories shipped with the unit, as shown above.
2CAUTION
Safety precautions
Installation procedure
1. Remove the ignition key and disconnect the negative - terminal of the battery to prevent short
circuits.
2. Set the unit according to the intended usage.
3. Connect the input and output cables of the units.
4. Connect the Ignition wire and grounding wire following this order.
5. Install the unit in the car.
6. Connect the negative - terminal of the battery.
• Be sure to turn the power off before changing the setting of any switch.
• If the fuse blows, check cables for shorts, then replace the fuse with one of the same rating.
• Check that no unconnected wires or connectors are touching the car body.
• After installation, check that the brake lamps, winkers, and wipers work properly.
2CAUTION
.........2
q
.........2
w
.........2
e
.........2
r
.........2
t
.........2
y
.........4
u
.........4
i
External view
......... Number of items
Part name
Remote controller
(cable length:5m)
Velcro strips
(
20x60mm)
Velcro strips
(Hook : 12x65mm)
Installation
bracket
Velcro strips
(Loop :
25x70mm)
Double-side
adhesive tape
Tapping screw
(
ø3x6mm)
Tapping screw
(ø4x12mm)
Part name
External view
......... Number of items
Accessories
To prevent injury or fire, take the following precautions:
• Insert the unit all the way in until it is fully locked in place. Otherwise it may fall out of place when
jolted.
• When extending the ignition, battery, or ground wires, make sure to use automotive-grade wires or
other wires with a 0.75mm2 (AWG18) or more to prevent wire deterioration and damage to the wire
coating.
• If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your
Kenwood dealer.
To prevent damage to the machine, take the following precautions:
• Make sure to ground the unit to a negative 12V DC power supply.
• Do not open the top or bottom covers of the unit.
2CAUTION
2WARNING
Loading...