KTC-V300P
TV TUNER
INSTRUCTION MANUAL
© B64-3321-00/00 (MV)
Accessories
1 |
6 |
.......... |
1 |
(3.0m) ..........1 |
2 |
7 |
..........1 .......... |
2 |
3 |
8 |
(4.0m) .......... |
1 |
(M4X8mm) .......... |
4 |
4 |
9 |
(5.5m) .......... |
1 |
(ø4x16mm) .......... |
4 |
5 |
0 |
..........6 .......... |
1 |
Installation the TV Tuner Unit
■Securing to audio board
Use screws (Accessory 8and 9) to fix TV Tuner onto an audio board or another.
Accessory 9
Accessory 8
Accessory 7
2 | English
Installing the Antenna
■ Before installing the antenna
2WARNING
•Mounting and wiring this product requires skills and experience. For safety's sake, leave the mounting and wiring work to professionals.
2CAUTION
•Incar antennas have a lower reception sensitivity than antennas intended for outside mounting. The picture may not appear or may be disturbed if the signal in your area is weak.
•The film antennas are designed specially for use in car.
•Do not attach the film antennas in the following places:
–A place where the driver’s view is blocked
–A place where safety parts such as an airbag are prevented from operating normally
–On the surface of a glass such as a rear hatch glass which is frequently moved.
•The reception sensitivity lowers in the following places:
–A place where a heat reflection glass or mirror-type glass film is affixed
–A place where the film antenna of the factory-supplied radio already exists
–On the window where the heating wire already exists
–On the side of the vehicle (door, front quarter window, etc.)
–On the rear window
–On a glass (heat reflecting glass, heat insulating glass, etc.) that blocks radio waves
•Using the cleaner (Accessory 0), remove oil and dirt from the glass surface to which the film antennas are to be affixed.
•If the ambient temperature is low, warm the glass before starting the work.
•Before starting the work, confirm well the places where the film antennas (Accessory 1 and 2) and the cables (Accessory 3 and 4) are to be installed.
Once peeled off, the film antennas and double-stick tape lose adhesion.
•Do not fold or damage the film antennas.
•Noise generated by the air conditioner or monitor can cause poor TV reception.
•The film antennas cannot be installed depending on the vehicle model.
•The reception sensitivity can vary with the windshield wiper operation depending on the vehicle model.
•The reception sensitivity can vary depending on the relationship between the traveling direction of the vehicle (the pointing direction of the antennas) and the location of the broadcast station.
English | 3