Kenwood FPP220, FPP230 User Manual
FPP210 series, FPP220 series
FPP230 series
instructions
-
a
b
efore using your Kenwood appliance
b
●
Read these instructions carefully and retain for future reference.
●
Remove all packaging and any labels.
safety
●
he blades and discs are very sharp, handle with care. Always
T
hold by the finger grip at the top, away from the
utting edge, both when handling and cleaning.
c
●
o not lift or carry the processor by the handle - or the handle
D
may break resulting in injury.
●
Always remove the knife blade before pouring contents from the
owl.
b
●
Keep hands and utensils out of the processor bowl and liquidiser
goblet whilst connected to the power supply.
●
witch off and unplug:-
S
●●
before fitting or removing parts;
●●
when not in use;
●●
before cleaning.
●
Never use your fingers to push food down the feed tube. Always
use the pusher/s supplied.
●
Never fit the blade unit to the power unit without the
liquidiser or mini chopper/mill jar fitted.
●
Before removing the lid from the bowl, liquidiser or mini
chopper/mill from the power unit:-
●●
switch off;
●●
wait until the attachment/blades have completely stopped;
●●
be careful not to unscrew the liquidiser goblet or mini
chopper/mill jar from the blade assembly.
●
Liquids should be allowed to cool to room temperature before
blending.
●
Do not use the lid to operate the processor, always use the
on/off speed control.
●
This appliance will be damaged and may cause injury
if the interlock mechanism is subjected to excessive
force.
●
Always unplug your food processor when not in use.
●
Never use an unauthorised attachment.
●
Never leave the appliance unattended when it is operating.
●
Never use a damaged appliance. Get it checked or repaired: see
‘service & customer care’.
●
Never let the power unit, cord or plug get wet.
●
Don’t let excess cord hang over the edge of a table or worktop
or touch hot surfaces.
●
Do not exceed the maximum capacities stated in the
recommended speed chart.
●
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
●
Children should be supervised to ensure that they do not play
with the appliance.
●
Only use the appliance for its intended domestic use. Kenwood
will not accept any liability if the appliance is subject to improper
use, or failure to comply with these instructions.
●
Misuse of your processor/liquidiser can result in injury.
●
The maximum rating is based on the attachment that draws the
greatest load. Other attachments may draw less power.
Refer to the relevant section under “using the attachments” for
additional safety warnings for each individual attachment.
efore plugging in
b
●
Make sure your electricity supply is the same as the one shown
on the underside of your appliance.
Important – UK only
●
he wires in the cord are coloured as follows:
T
Blue = Neutral, Brown = Live.
●
The appliance must be protected by a 13A approved (BS1362)
use.
f
Note:
●
For non-rewireable plugs the fuse cover MUST be refitted when
eplacing the fuse. If the fuse cover is lost then the plug must not
r
be used until a replacement can be obtained. The correct fuse
cover is identified by colour and a replacement may be obtained
rom your Kenwood Authorised Repairer (see Service).
f
●
If a non-rewireable plug is cut off it must be DESTROYED
IMMEDIATELY. An electric shock hazard may arise if an
nwanted non-rewireable plug is inadvertently inserted into a
u
13A socket outlet.
●
This appliance conforms to EC directive 2004/108/EC on
Electromagnetic Compatibility and EC regulation no. 1935/2004
of 27/10/2004 on materials intended for contact with food.
before using for the first time
1 Remove the plastic blade covers from the knife blade. Take
care the blades are very sharp. These covers should be
discarded as they are to protect the blade during manufacture
and transit only.
2 Wash the parts see ‘care & cleaning’
key
processor
pusher
feed tube
lid
detachable drive shaft
bowl with drive shaft
power unit
speed/pulse control
safety interlocks
cord storage (at back)
liquidiser (if supplied)
blade unit
sealing ring
goblet
filler cap
lid
mini chopper/mill (if supplied)
jar
sealing ring
blade unit
2
attachments
Not all of the attachments listed below may be included with your
ood processor. Attachments are dependent upon the model
f
ariant.
v
knife blade
dough tool (if supplied)
emulsifying tool
thick slicing/coarse grating disc
citrus juicer (if supplied)
patula
s
recipe book (if supplied)
to use your food processor
Fit the bowl by aligning the on the bowl with the on the
1
power unit, turn clockwise until it locks .
2 Fit an attachment over the bowl drive shaft.
Note: Detachable drive shaft should only be fitted
when using the disc or citrus juicer.
●
Always fit the bowl and attachment onto the processor before
adding ingredients.
3 Fit the lid - ensuring the top of the drive shaft/tool locates into
the centre of the lid.
●
Do not use the lid to operate the processor, always
use the on/off speed control.
4 Plug in, switch on and select a speed. (Refer to the
recommended speed chart).
●
The processor will not operate if the bowl or lid are
not fitted correctly into the interlock. Check that the
feed tube and bowl handle are situated to the right
hand side.
●
Use the pulse (P) for short bursts. The pulse will operate for as
long as the control is held in position.
5 Reverse the above procedure to remove the lid, attachments and
bowl.
●
Always switch off and unplug before removing the lid.
important
●
Your processor is not suitable for crushing or grinding coffee
beans, or converting granulated sugar to caster sugar.
●
When adding almond essence or flavouring to mixtures avoid
contact with the plastic as this may result in permanent marking.
to use your liquidiser (if supplied)
1 Fit the sealing ring into the blade unit - ensuring the seal is
located correctly in the grooved area.
●
eaking will occur if the seal is damaged or
L
incorrectly fitted.
2 Hold the underside of the blade unit and insert the blades into
he goblet - turn anti-clockwise until it clicks . Refer to the
t
graphics on the underside of the blade unit as follows:
- unlocked position
locked position
-
he liquidiser will not operate if incorrectly
T
assembled.
Put your ingredients into the goblet.
3
Fit the lid onto the goblet and turn clockwise until it clicks. Fit
4
the filler cap.
5 Place the liquidiser onto the power unit, align the on the
liquidiser with the on the power unit and turn
clockwise to lock .
●
The appliance will not operate if the liquidiser is
incorrectly fitted to the interlock.
6 Select a speed (refer to the recommended speed chart) or use
the pulse control.
safety
●
Liquids should be allowed to cool to room
temperature before blending.
●
Always take care when handling the blade assembly and avoid
touching the cutting edge of the blades when cleaning.
●
Only operate the liquidiser with the lid in place.
●
Only use the goblet with the blade assembly supplied.
●
Never run the liquidiser empty.
●
To ensure the long life of your liquidiser, do not run it for longer
than 60 seconds.
●
Smoothie recipes - never blend frozen ingredients that have
formed a solid mass during freezing, break it up before adding to
the goblet.
hints
●
When making mayonnaise, put all the ingredients, except the oil,
into the liquidiser. Remove the filler cap. Then, with the appliance
running, add the oil slowly through the hole in the lid.
●
Thick mixtures, e.g. pâtés and dips, may need scraping down. If
the mixture is difficult to process, add more liquid.
●
Ice crushing - operate the pulse in short bursts until crushed to the
desired consistency.
●
The processing of spices is not recommended as they may
damage the plastic parts.
●
The appliance will not work if the liquidiser is incorrectly fitted.
●
To blend dry ingredients - cut into pieces, remove the filler cap,
then with the appliance running, drop the pieces down one by
one. Keep your hand over the opening. For best results empty
regularly.
●
Don’t use the liquidiser as a storage container. Keep it empty
before and after use.
●
Never blend more than 1.2 litres - less for frothy liquids like
milkshakes.
3
Loading...