Kenwood FP734 User Manual

mult
i p
ro
FP734 FP735
instructions
m
l t
i p
ro
m
ult
i
pro
efore using your Kenwood appliance
b
Read these instructions carefully and retain for future reference.
Remove all packaging and any labels.
safety
he blades and discs are very sharp, handle
T
ith care. Always hold the knife blade
w
by the finger grip at the top, away
rom the cutting edge, both when
f
andling and cleaning.
h
Do not lift or carry the processor by the handle - or the handle
ay break resulting in injury.
m
lways remove the knife blade before pouring contents from the
A bowl.
eep hands and utensils out of the processor bowl and liquidiser
K
oblet whilst connected to the power supply.
g
Switch off and unplug:
before fitting or removing parts
after use
before cleaning
Never use your fingers to push food down the feed tube. Always use the pusher/s supplied.
Never fit the blade unit to the power unit without the liquidiser or mini chopper/mill jar fitted.
Before removing the lid from the bowl or liquidiser or mini chopper/mill from the power unit:-
switch off;
wait until the attachment/blades have completely stopped;
be careful not to unscrew the liquidiser goblet or mini chopper/mill from the blade assembly.
Liquids should be allowed to cool to room temperature before blending.
Do not use the lid to operate the processor, always use the on/off speed control.
This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.
Never use an unauthorised attachment.
Never leave the machine on unattended.
Never use a damaged machine. Get it checked or repaired: see ‘service and customer care’.
Never let the power unit, cord or plug get wet.
Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.
Do not exceed the maximum capacities stated in the recommended speed chart.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
Misuse of your processor/liquidiser can result in injury.
Refer to the relevant section under “using the attachments” for additional safety warnings for each individual attachment.
efore plugging in
b
Make sure your electricity supply is the same as the one shown on the underside of your machine.
Important – UK only
The wires in the cord are coloured as follows:
lue = Neutral,
B Brown = Live.
The appliance must be protected by a 13A approved (BS1362)
use.
f
Note:
or non-rewireable plugs the fuse cover MUST be refitted when
F replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse
over is identified by colour and a replacement may be obtained
c
rom your Kenwood Authorised Repairer (see Service).
f
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable pug is inadvertently inserted into a 13A socket outlet.
This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.
before using for the first time
1 Remove all packaging including the plastic blade covers from the
knife blade. Take care the blades are very sharp. These covers should be discarded as they are to protect the blade
during manufacture and transit only. 2 Wash the parts see ‘cleaning’ 3 Push excess cord into the back of the machine.
key processor
power unitdetachable drive shaftbowllidfeed tubepusherssafety interlockscord storagespeed control
liquidiser
filler caplidgobletsealing ringblade unit
2
additional attachments
Not all of the attachments listed below may be included with
our food processor. Attachments are dependent upon the
y model variant.
knife blade
  dough tool
twin beater geared metal whisk
maxi-blend canopy
  thick slicing/coarse shredding disc
thin slicing/fine shredding disc
ine (Julienne style) chipper disc
f geared citrus press (if supplied) mini chopper/mill mini processor bowl (if supplied) centrifugal juicer (if supplied)
choosing a speed for all functions
Tool/Attachment Function Speed Maximum Capacities
Knife Blade One Stage Cake Mix 1 – 8 1.5Kg/3lb 5oz Total Wt
Knife Blade with maxi-blend canopy Soups – start at a low speed and move up to 8 1 – 8 1.5 litres/2pts 12fl. oz
Whisk Egg Whites 8 6 Egg Whites
Dough tool Yeasted mixes 8 500g/1lb 2oz
Discs – slicing/shredding/chipping Firm food items such as carrots, hard cheese. 5 – 8
Citrus Press Citrus fruits 1
Mini Bowl & knife All processing 8 200g/8oz
Liquidiser All processing 8 1.5 litres/2pts 12fl.oz
Mini chopper/mill All processing 8
Centrifugal juicer Fruit & Vegetables 8 450g/1lb
Pastry - rubbing fat into flour 5 – 8 340g/12oz Flour Wt Adding water to combine pastry ingredients 1 – 5 Chopping/pureeing/pates 8 600g/1lb 6oz Meat
Egg & sugar for fatless sponges 8 Cream 5 – 8 500 mls
Softer items such as cucumbers, tomatoes 1 – 5
3
Loading...
+ 9 hidden pages