Kenwood FP720 User Manual

FP710 series

FP720 series

multi























































l t

i p

r o

lti p

before using your Kenwood appliance

●

Read these instructions carefully and retain for future reference.

●

Remove all packaging and any labels.

safety

●

The blades and discs are very sharp, handle with care. Always hold the knife blade

by the finger grip at the top, away from the cutting edge, both when handling and cleaning.

●

Do not lift or carry the processor by the handle - or the handle may break resulting in injury.

●

Always remove the knife blade before pouring contents from the bowl.

●

Keep hands and utensils out of the processor bowl and liquidiser jug whilst connected to the power supply.

●

Switch off and unplug:

●●

before fitting or removing parts

●●

after use

●●

before cleaning

●

Never use your fingers to push food down the feed tube. Always use the pusher/s supplied.

●

Before removing the lid from the bowl or liquidiser/mill from the power unit:-

●●

switch off;

●●

wait until the attachment/blades have completely stopped;

●●

be careful not to unscrew the liquidiser jug or mill from the blade unit.

●

Allow all liquids to cool to room temperature before placing them in the liquidiser.

●

Do not use the lid to operate the processor, always use the on/off speed control.

●

This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.

●

Never use an unauthorised attachment.

●

Never leave the machine on unattended.

●

Never use a damaged machine. Get it checked or repaired: see ‘service’.

●

Never let the power unit, cord or plug get wet.

●

Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.

●

Do not exceed the maximum capacities stated.

●

Do not let infirm people use the appliance without supervision.

●

Do not let children use or play with the appliance.

●

Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

before plugging in

●

Make sure your electricity supply is the same as the one shown on the underside of your machine.

Important – UK only

●

The wires in the cord are coloured as follows: Blue = Neutral, Brown = Live.

●

The appliance must be protected by a 13A approved (BS1362) fuse.

Note:

●

For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

●

If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable pug is inadvertently inserted into a 13A socket outlet.

●

This appliance complies with European Economic Community Directive 89/336/EEC.

before using for the first time

1 Remove all packaging including the plastic blade covers from the

knife blade. Take care the blades are very sharp. These covers should be discarded as they are to protect the blade

during manufacture and transit only. 2Wash the parts see ‘cleaning’ 3 Push excess cord into the back of the machine.

key processor

 power unit  detachable drive shaft  bowl  lid  feed tube  pushers  safety interlocks  cord storage  speed control

liquidiser

 filler cap  lid  jug  sealing ring  blade unit

to use your food processor

1 Fit the detachable shaft onto the power unit . 2 Then fit the bowl. Place the handle towards the back and turn

clockwise until it locks .

3 Fit an attachment over the drive shaft.

●

Always fit the bowl and attachment onto the machine before adding ingredients.

4 Fit the lid  - ensuring the top of the drive shaft locates into the

centre of the lid.

●

Do not use the lid to operate the processor, always use the on/off control.

5 Switch on and select a speed.

●

The processor won’t work if the bowl and lid are fitted incorrectly.

●

Use the pulse (P) for short bursts. The pulse will operate for as long as the control is held in position.

6 Reverse the above procedure to remove the lid, attachments and

bowl.

●

Always switch off before removing the lid.

important

●

Your processor is not suitable for crushing or grinding coffee beans, or converting granulated sugar to caster sugar.

●

When adding almond essence or flavouring to mixtures avoid contact with the plastic as this may result in permanent marking.

choosing a speed for all functions

Tool/Attachment Function Speed Maximum Capacities

Knife Blade One Stage Cake Mix 1 – 2 1.5Kg/3lb 5oz Total Wt

Pastry - rubbing fat into flour 2 340g/12oz Flour Wt Adding water to combine pastry ingredients 1 – 2 Chopping/pureeing/pates 2 600g/1lb 6oz Meat

Knife Blade with maxi-blend canopy Soups – start at a low speed and move up to 2 1 – 2 1.5 litres/2pts 12fl.oz

Whisk Egg Whites 2 6 Egg Whites

Egg & sugar for fatless sponges 2 Cream 1 – 2 500 mls

Dough tool Yeasted mixes 2 500g/1lb 2oz

Discs – slicing/shredding/chipping Firm food items such as carrots, hard cheese. 2

Softer items such as cucumbers, tomatoes 1

Citrus Press Citrus fruits 1

Liquidiser All processing 2 1.5 litres/2pts 12fl.oz

Mill All processing 2

additional attachments

Not all of the attachments listed below may be included with your food processor. Attachments are dependent upon the model variant.

 knife blade  dough tool  twin beater geared whisk  maxi-blend canopy  thick slicing/coarse shredding disc  thin slicing/fine shredding disc

fine (Julienne style) chipper disc geared citrus press mill KENSTORE™ attachments carousel recipe book spatula

+ 7 hidden pages