Kenwood EW210 User Manual

Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK

www.kenwoodworld.com

18005/1

EW210

UNFOLD

before using your Kenwood
appliance

●

Read these instructions carefully and
retain for future reference.

●

Remove all packaging and any
labels.

safety

●

Do not immerse the supply cord or
power supply connector in water or
other liquid.

●

Never use a damaged appliance,
cord or plug. Get it checked or
repaired: see ‘service’.

●

Do not let the cord hang over the
edge of the table or worksurface or
touch hot surfaces.

●

Never use the wok empty.

●

The wok and contents will remain
hot after use.

●

The wok should not be used near or
below curtains and other
combustible materials.

●

Do not place this appliance on or
near a naked flame, electric burner,
hot plate or in a heated oven.

●

Do not touch hot surfaces - use
handles or knobs.

●

Always unplug and remove the
power supply connector from the
wok when not in use and before
cleaning.

●

Take care when removing the power
supply connector as the probe may
be hot.

●

Never leave the wok unattended
when in use.

●

Always attach the power supply
connector to the appliance first, then
plug into the power supply. To
disconnect, remove the plug from
the power supply first before
removing the power supply
connector from the appliance.

●

Only the appropriate power supply
connector must be used with this
appliance.

●

Do not use the appliance outdoors.

●

This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.

●

Children should be supervised to
ensure that they do not play with the
appliance.

●

Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.

before plugging in

●

Make sure your electricity supply is
the same as the one shown on the
underside of your wok.

Important – UK only

●

The wires in the cord are coloured
as follows:
Blue = Neutral,
Brown = Live.

●

The appliance must be protected by
a 13A approved (BS1362) fuse.

Note:

●

For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).

2



















