Kenwood CM176 User Manual

6 Don’t remove the jug until brewing
has finished. The hotplate will keep your coffee hot, but the sooner you drink it, the better it will taste.
7 When the jug’s empty, switch off
by pressing the on/off switch. Let the machine cool down before cleaning.
If you haven’t used the machine for a while, run one lot of water through it (without coffee) to clean it out. Fill the tank to the top cup mark when you do this.
Never put the jug in the microwave.
care & cleaning
Always switch off and unplug before cleaning.
Never put the machine in water or let the cord or plug get wet.
Don’t wash parts in the dishwasher.
jug, lid
Wash, then dry.
permanent filter
Wash, then dry.
filter door
remove it: open and lift off. Wash then dry.
body
Wipe with a damp cloth, then dry. Don’t use abrasives - they’ll scratch the plastic.
descaling
You’ll know when limescale has built up because your coffee will take longer to come through. When this happens it’s time to descale.
to descale
1 Buy a suitable descaler. 2 Descale the machine.
3After descaling, run several lots of
water through the machine to clean it out. Fill the tank to the top cup mark when you do this.
4 Wash the parts.
service
If the cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer.
UK
If you need help with:
using your machine or
servicing, spare parts or repairs (in or out of guarantee)
call Kenwood customer care on
023 92392333. Have your model number ready - it’s on
the underside of the coffee maker.
Eire
See our advertisement in Golden Pages.
other countries
Contact the shop where you bought your machine.
guarantee
If your coffee maker goes wrong within one year from the date you bought it, we will repair it (or replace it if necessary) free of charge provided:
you have not misused, neglected or damaged it;
it has not been modified (unless by Kenwood);
it is not second-hand;
it has not been used commercially;
you have not fitted a plug incorrectly; and
you supply your receipt to show when you bought it.
This guarantee does not affect your statutory rights.
safety
Watch out for steam, never lift the
tank lid during the brewing cycle or touch the hotplate.
Keep children away from the
machine. And never let the cord hang down where a child could grab it. Push excess cord inside the back of the machine (CM170 series only).
Never use a damaged machine.
Get it checked or repaired: see ‘service’.
Never put the machine in water or
let the cord or plug get wet - you could get an electric shock.
Unplug:
before filling with water
before cleaning
after use.
Never leave the machine on
unattended.
Don’t let the cord touch hot parts.
Don’t let infirm people use the
machine without supervision.
Don’t let children play with this
machine.
Only use the machine for its
intended domestic use.
Always make sure there is water in
the tank before switching on.
before plugging in
Make sure your electricity supply is the same as the one shown on the underside of your machine.
Important (UK) only
The wires in the cord are coloured as follows: Green and Yellow = Earth Blue = Neutral Brown = Live.
This machine complies with European Economic Community Directive 89/336/EEC.
before using for the first time
1Remove all packaging. 2 Wash the parts: see ‘care and
cleaning’.
3 Push excess cord inside the back
of the machine (CM170 series only).
4 Run two lots of water through the
machine (without coffee) to clean it out. Fill the tank to the top cup mark when you do this. See ‘to make coffee’.
key
filter doorpermanent coffee filter (or use a
paper filter instead)
water tankcompartment for excess cord
(CM170 series only).
on/off switch with indicator lightmeasuring spoonjughotplate
to make coffee
1 Pour water into the tank. The
water must be between the top and bottom cup marks. Then close the lid.
Use cold water. We recommend using filtered water from a Kenwood Water Filter as it reduces limescale. Never use warm or fizzy water.
If you use the jug to fill the tank, look at the tank marks, not the jug marks. They’re slightly different to allow for the fact that some of the
water gets absorbed by the coffee. 2 Open the filter door. 3 Add either a permanent filter or a
paper filter. Add the coffee, use
the spoon provided (approximately
1 level spoon per large cup). Then
close the filter door. 4 Put the jug on the hotplate. 5 Plug in and switch on, the light will
glow.
Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK
www.kenwood.co.uk
4973/2
CM170 series
CM70 series
Loading...