Kenmore 110C62332511, 110C62332510, 110C60242510, 110C60222510, 110C60122511 Owner’s Manual
...
Use & Care Guide
Manual de uso y cuidado
Guide d’utilisation et d’entretien
English / Español / Français
Table of Contents......2 / Índice......14 / Table des matières......26
Models/Modelos/Modèles: 6012, 7012, C60122, 60222, 70222, C60222, C60242, 62332, 72332, C62332
Kenmore®
Electric or Gas Dryer
Secadora eléctrica o a gas
Sécheuse électrique ou à gaz
P/N W10738930B
Sears Brands Management Corporation
Hoffman Estates, IL 60179 U.S.A.
www.kenmore.com
www.sears.com
Sears Canada Inc.
Toronto, Ontario, Canada M5B 2C3
www.sears.ca
TABLE OF CONTENTS
DRYER SAFETY ........................................................................... 2
CHECK YOUR VENT SYSTEM FOR GOOD AIR FLOW .....4
USE AUTO DRY CYCLES FOR BETTER FABRIC CARE
AND ENERGY SAVINGS .......................................................... 4
CONTROL PANEL AND FEATURES ........................................ 5
CYCLE GUIDE ............................................................................. 6
DRYER SAFETY
USING YOUR DRYER ................................................................ 7
DRYER CARE ............................................................................... 9
TROUBLESHOOTING ................................................................11
PROTECTION AGREEMENTS .................................................13
WARRANTY ............................................................................... 13
ASSISTANCE OR SERVICE .....................................................40
IMPORTANT: When discarding or storing your old clothes dryer, remove the door.
2
3
CHECK YOUR VENT SYSTEM FOR GOOD AIR FLOW
Good Air Flow
Along with heat, dryers require good air ow to eciently
dry laundry. Proper venting will reduce your drying times
and improve your energy savings. See Installation
Instructions.
The venting system attached to the dryer plays a big role
in good air ow.
Service calls caused by improper venting are not covered
by the warranty and will be paid by the customer, regardless
of who installed the dryer.
Maintain good air ow by:
n
Cleaning your lint screen before each load.
n
Replacing plastic or foil vent material with 4" (102 mm)
diameter heavy, rigid vent material.
n
Using the shortest length of vent possible.
n
Using no more than four 90° elbows in a vent system;
each bend and curve reduces air ow.
Good Better
n
Removing lint and debris from the exhaust hood.
n
Removing lint from the entire length of the vent system
at least every 2 years. When cleaning is complete,
be sure to follow the Installation Instructions supplied
with your dryer for nal product check.
n
Clearing away items from the front of the dryer.
USE AUTO DRY CYCLES FOR
BETTER FABRIC CARE AND ENERGY SAVINGS
Use the Auto Dry cycles to provide the most energy savings and enhanced fabric care from the dryer. During Auto Dry cycles,
drying air temperature and moisture level are sensed in the load. This sensing occurs throughout the drying cycle and the dryer
shuts o when the load reaches the selected dryness. Choose Normal cycle to save energy.
With Timed Dry cycle, the dryer runs the amount of time set and sometimes results in shrinkage, wrinkling, and static due to
overdrying. Use Timed Dry cycle for the occasional damp load that needs a little more drying time or when using the drying rack.
4
CONTROL PANEL AND FEATURES
1
1
2
3
3
Not all features and options are available on all models.
DRYER CYCLE KNOB
1
Turn the knob to select a cycle for your laundry load.
See “Cycle Guide” for detailed descriptions of cycles.
Timed Dry
Will run the dryer for the specied time on the control.
On models with a selectable temperature knob, you may
choose a setting based on the fabrics in your load. Drying
time and temperature will depend on your dryer model.
Auto Dry
Auto Dry cycles give the best drying in the shortest time.
Drying time will vary based on fabric type, load size, and
dryness setting.
Air Only
Use the Air Only setting to dry foam, rubber, plastic,
or heat-sensitive fabrics.
Wrinkle Guard™ function (on some models)
When you are unable to remove a load of clothes
from the dryer as soon as it stops, wrinkles can form.
The Wrinkle Guard™ function periodically tumbles,
rearranges, and us the load without heat to help
keep wrinkles from forming, for up to 40 minutes
at the end of a cycle.
Appearance may vary.
Dry Temp (on some models)
2
Select a drying temperature based on the fabrics in
your load. If you are unsure of the temperature to select
for a load, select the lower setting rather than the higher
setting. See “Cycle Guide.”
3
Cycle Signal/Push to Start
The Cycle Signal produces an audible sound when the drying
cycle is nished. On some models, this knob is combined with
the Push to Start button. Promptly removing clothes at the
end of the cycle reduces wrinkling.
Turn the CYCLE SIGNAL knob to select the desired setting
(On or O). With combined buttons, press and hold the
CYCLE SIGNAL/PUSH TO START button to start the dryer.
On models without the cycle signal, press the PUSH TO
START button to start the dryer.
NOTE: During the Wrinkle Guard™ function and when
the Cycle Signal is on, the tone will sound every 5minutes
until the clothes are removed or the Wrinkle Guard™
function ends.
5
CYCLE GUIDE – AUTO DRY CYCLES
Not all cycles and settings are available on all models. Settings and options shown in bold are default settings for that cycle.
AUTO DRY – Senses moisture in the load or air temperature and shuts o when the load reaches the selected dryness level.
Depending on model, temperature may be selected on cycle knob or be a separate control. Choose Normal to save energy.
Items to dry:
Jeans, heavy work
clothes, towels
Work clothes, medium
weight fabrics, sheets
Casual, shirts, pants,
lightweight items,
synthetics, delicates,
athletic wear
NOTE: If loads do not seem as dry as you would like, select More next time you dry a similar load. If loads seem drier than you like, select Less next
time you dry a similar load.
Dry
Temp:
High Cotton More
Medium Casual More
Low Delicates More
Dryness
Level:
Normal
Less
Normal
Less
Normal
Less
Available
Options:
Cycle Signal
Dry Temp
Cycle Signal
Dry Temp
Cycle Signal
Dry Temp
Cycle Details:
Automatic cycles give the best drying in the
shortest time. Drying time varies based on
load size and dryness setting.
Select a drying temperature based on the
fabrics in your load. If you are unsure of the
temperature to select for a load, select the
lower setting rather than the higher setting.
CYCLE GUIDE – TIMED DRY CYCLES
Not all cycles and settings are available on all models.
TIMED DRY – Will run the dryer for the specied time on the control. Depending on model, temperature may be selected on cycle
knob or be a separate control.
Items to dry:
Any load Timed Dry High Heat Dry Temp
Any load Touch up Any N/A This is the last step in a cycle that uses
Rubber, plastic, heat
sensitive fabrics
Cycle:
Air Only No heat Time Adjustment Use a Air Only (no heat) setting for foam,
Dry
Temp:
Available
Options:
(on some models)
Cycle Details:
Select a drying temperature based on the
fabrics in your load. If you are unsure of the
temperature to select for a load, select the
lower setting rather than the higher setting.
heat. The load is cooled slowly to reduce
wrinkling and make it easier to handle.
Use this cycle to smooth wear or packing
wrinkles.
rubber, plastic, or heat-sensitive fabrics.
Setting the Drying Temperature
If your dryer has multiple temp settings:
A High Cotton temp setting may be used for drying heavyweight items such as towels and work clothes.
A Low Delicates or Medium Casual temp setting may be used for drying medium-weight items such as sheets, blouses, dresses,
underwear, permanent press fabrics, and some knits.
Use a Air Only (no heat) setting for foam, rubber, plastic, or heat-sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures for various loads, refer to the care label directions.
6
USING YOUR DRYER
WARNING: To reduce the risk of fire, electric shock, or injury
to persons, read the IMPORTANT SAFETY INSTRUCTIONS
before operating this appliance.
1. Clean the lint screen
Clean the lint screen before each load. Pull the lint screen out of
its holder. Roll lint o the screen with your ngers. Do not rinse or
wash screen to remove lint. Push the lint screen rmly back into
place. For additional cleaning information, see “Dryer Care.”
2. Load the dryer
Place laundry in the dryer. Close the door. Do not tightly pack
the dryer; clothes should be able to tumble freely.
NOTE: Your model may have a dierent door than the one
shown. Some models have drop down doors.
7
3. Select the desired cycle
5. Select Cycle Signal, if desired
(on some models)
Appearance may vary.
Select the desired cycle for your load. See the “Cycle Guide”
for more information about each cycle.
Auto Dry cycles
You can select a dierent dry level, depending on your load,
by turning the knob to More, Normal, or Less.
Selecting More, Normal, or Less automatically adjusts the
dryness level at which the dryer will shut o. Once a dry level
is set, it cannot be changed without stopping the cycle.
Auto Dry cycles give the best drying in the shortest time. Drying
time varies based on fabric type, load size, and dryness setting.
NOTE: More Dry removes more load moisture. Normal Dry is
used for a starting point for Auto Dry cycles. Choose normal
to save energy. Less Dry removes less moisture and is used for
loads you may want to put on a hanger to complete drying.
4. Set temperature (on some models)
Turn the CYCLE SIGNAL knob to select the desired setting
(On or O). The Cycle Signal produces an audible sound when
the drying cycle is nished. Promptly removing clothes at the
end of the cycle reduces wrinkling.
NOTE: During the Wrinkle Guard™ function and if the Cycle
Signal is on, the tone will sound every 5minutes until the clothes
are removed or the Wrinkle Guard™ function ends.
6. Press and hold PUSH TO START
to begin cycle
Appearance may vary.
Turn the DRY TEMP knob to change the drying temperature
setting. See “Setting the Drying Temperature.”
8
Press and hold the PUSH TO START button to begin the cycle.
Promptly remove garments after cycle has completed to
reduce wrinkling. The Wrinkle Guard™ function at the end of
the cycle avoids wrinkling when you are unable to remove a load
from the dryer as soon as it stops.
Loading...