Kenmore 11079737800, 11079732800, 11079727800, 11069737800, 11069732800 Owner’s Manual

...

We have taken great care to give your new dryer the most convenient and easy-to-use features. Use this guide to help optimize the use of your dryer. Consult the Use and Care Guide for more detailed instructions. To contact the Sears Service Center, call 1-800-4-MY-HOME ®(1-800-469-4663).

Models/Modelos 100.7/6972#, 7/6973_, 7/6974#

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Do not dry anything that has ever had anything flammable on it (even after washing).

Failure to follow these instructions can result in death, explosion, or fire.

Clean the lint screen.

Place laundry indryer.

Shut the door. Select Auto Moisture Sensing Cycle,

• Turn cycle knob to recommended Auto Moisture Sensing Cycle for type of load being dried.

• Use Normal Dry to dry most heavy to medium-weight fabrics.

• Select temperature setting using Fabric Care selector.

Fire Hazard

No washer can completely remove oil. Do not dry anything that has ever had any type of

oil on it (including cooking oils).

Items containing foam, rubber, or plastic must be

dried on a clothesline or by using an Air Cycle.

Failure to follow these instructions can result in

death or fire.

or select Timed Dry Cycle.

• Turn cycle knob to Timed Dry.

• Turn cycle knob to desired drying time.

• Select temperature setting using Fabric Care selector.

Select the End of Cycle Signal. Select the WRINKLE GUARD ®feature.

Press and hold the START button.

The End of Cycle Signal sounds when a cycle is complete. This signal is helpful when you are drying permanent press, synthetics, and other

items that should be removed from the dryer promptly at the end of a cycle.

The End of Cycle Signal is selectable. The signal stops when you open the door or turn the End of Cycle Signal on the Start button to Off.

Ifthe WRINKLE GUARD ®feature is on, the End of Cycle Signal sounds every few minutes. If the End of Cycle Signal is turned off, you will not hear

WRINKLE GUARD ®sound every few minutes.

W10035734A

Continued on back

FaBRI88aR£8/ITR@B

For models with a Fabric Care control knob, you may use this control to select the drying temperature that matches the fabrics in your load.

The following table lists suggested auto moisture sensing or timed dry settings for various loads. This is only a guide.

FABRIC CARE/ LOAD TYPE CYCLES SETTING TIMED DRY

TEMPERATURE SETTING* AIR FLUFF Rubber, plastic, heat-sensitive fabrics Timed Dry 20-50

NO HEAT minutes ULTRA DELICATE Lightweight items - lingerie, blouses, dresses, Auto Moisture Sensing Plus 20-40

EXTRA LOW synthetics, and blends Less Dry minutes CASUAL Medium-weight items - synthetics (polyester, Auto Moisture Sensing Plus 30-50

MEDIUM acrylic), skirts, sweaters, slacks Normal Dry minutes NORMAL Medium-weight items - shirts, sheets, slacks, Auto Moisture Sensing Plus 30-50

MEDIUM HIGH play clothes, cloth diapers Normal Dry minutes COTTON/TOWELS Heavyweight items - quilts, towels, jeans, Auto Moisture Sensing Plus 50-70

HIGH cottons, bedspreads More Dry minutes *Reset time as needed to allow items to dry completely.

IYIII IIIIITII (TIIII} IIITIII N

Auto Moisture Sensing

When you are using the Auto Moisture Sensing Cycle, the dryness of the load is determined by two metal strips (sensors) located on the inside of the dryer. The metal strips help "feel" the amount of

moisture left in the clothes as they pass. When there is moisture

left in the clothes, the Cycle Control knob will not advance. As clothes begin to dry, the amount of water left in the clothes decreases, and the timer advances through the remainder of the cycle. When the selected dryness level is reached, the dryer goes

into a cool down period of up to 10 minutes.

Ifthe load is drier than you like, you may select a setting closer to

Less Dry the next time you dry a similar load. If a load is not as dry as you like, you may complete drying using a Timed cycle. You

may also select a setting closer to More Dry the next time you dry a similar load.

WRINKLE GUARD ®Ill helps smooth out wrinkles that may form when clothes are not removed promptly at the end of a cycle.

WRINKLE GUARD ®III periodically tumbles the load, without heat, for 90 minutes unless you open the dryer door.

ring WRINKLE GUARD ®Ill, the End of Cycle Signal will sound every 5 minutes unless the signal is turned off.

TE: WRINKLE GUARD ®Ill may be turned off by setting the WRINKLE GUARD .®knob to Off. The End of Cycle Signal will not sound

ry five minutes when WRINKLE GUAREP is turned off.

Timed Dry

This cycle may be used to get up to 90 minutes of heated drying time. The heating cycle is followed by a cool down period of up to

10 minutes.

Touch Up

This cycle may be used to help smooth synthetic and permanent press clothes that are clean but wrinkled from being crowded in a closet or suitcase. This setting provides about 20 minutes of heated tumbling followed by a cool down period of up to 10 minutes.

TIIIILESIIITINI - LIII IIY TIMES,LIAI 111"IIYINI

Before you call service...check for the following.

Is the lint screen clogged with lint?

• Clean the lint screen before each load.

Is the exhaust vent or outside exhaust hood clogged with lint?

• Lint should be cleaned out of the exhaust vent at least once every 2 years.

See the Use and Care Guide for complete details.

W10035734A 8/o8

+ 2 hidden pages