Kenmore 11029852990 Owner's Manual And Installation Instructions
90 Series
PUSH & TURN CLOCKWISE TO SET PULL TO START PUSH TO STOP
Heavy Duty Super Capacity Plus Quiet Pak
SPEEDSRINSE OPTIONS
ONE
RINSE
2ND
RINSE
PERMANENT
PRESS
RINSE
ULTRA CLEAN
6
10
14
10
6
2
2ND RINSE
PAUSE
COOL DOWN
PREWASH
OFF
OFF
OFF
SPIN
RINSE
SPIN
SPIN
SPIN
SOAK
OFF
4
OFF
2ND
RINSE
SUPER
SHORT
OFF
WATER LEVEL
SMALL
LOAD
RESET
MEDIUM
LOAD
LARGE
LOAD
WATER TEMPERATURE
HOT
COLD
COLD
COLD
AUTO
TEMPERATURE
CONTROL
COLD
COLD
WARM
COLD
WARM
COLD
WARM
WARM
WARM
WARM
REGULAR
SLOW / FAST
HEAVY DUTY
FAST / FAST
HANG DRY
FAST / SLOW
EXTRA
DELICATE
EX SLOW / SLOW
HAND
WASHABLES
INTERMITTENT
EXTRA SLOW / SLOW
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
PART NO. 3950144 Rev. A PRINTED IN U.S.A.
Your washer may look different
from the washer shown.
Three-Speed
AUTOMA TIC WASHERS
Owner’ s Manual and
Installation Instructions
IMPORTANT:
Read and follow all safety
and operating instructions
before first use of this product.
WARRANTY/SAFETY
INSTALLATION OPERATION
LAUNDRY TIPS
MAINTENANCE
TROUBLESHOOTING
SERVICE
ESPAÑOL
2
TABLE OF CONTENTS
BEFORE USING YOUR NEW WASHER __________________ 2
SEARS AUTOMATIC WASHER W ARRANTY_______________ 3
IMPORTANT SAFETY INSTRUCTIONS ___________________ 4
INST ALLATION INSTRUCTIONS ________________________ 5
OPERA TING YOUR WASHER _________________________ 20
LAUNDR Y TIPS _____________________________________ 29
CARING FOR YOUR WASHER_________________________ 31
TROUBLESHOOTING ________________________________ 32
SEARS MAINTENANCE AGREEMENT __________________ 36
BEFORE USING YOUR NEW WASHER
Use the space below to record the model
number and serial number of your new
Kenmore Washer.
Model No. ________________________
Serial No. ________________________
Date of Purchase __________________
Please read this manual. It will help
you install and operate your new
Kenmore washer in the safest and
most economical way.
For more information about the care
and operation of Kenmore appliances
call your nearest Sears store. You will
need the complete model and serial
numbers when requesting information.
Your washer’s model and serial numbers
are located on the Model and Serial
Number Plate.
U
92559900
9255
9255
CDFB92553421
Model and Serial
Number Plate
Keep this book and your Sears
Salescheck (receipt) in a safe
place for future reference.
3
SEARS AUTOMA TIC WASHER WARRANTY
FULL 1-YEAR WARRANTY
ON MECHANICAL AND
ELECTRICAL P ARTS
For one year from the date of purchase,
when the washer is installed and operated
in accordance with the instructions in
the Owner’s Manual, Sears will repair or
replace any mechanical or electrical parts
in this washer, if defective in material or
workmanship.
LIMITED 5-YEAR WARRANTY
ON GEARCASE PARTS
After one year and until five years from
the date of purchase, Sears will furnish
replacement parts for any defective gearcase parts. You will be charged for labor.
LIMITED 10-YEAR WARRANTY
ON PLASTIC TUB
After one year and until ten years from
date of purchase, Sears will furnish a
replacement plastic tub for any plastic
tub which is defective in material or workmanship. You will be charged for labor.
If the washer is subjected to other than
private family use, the above warranty
coverage is effective for only 90 days.
WARRANTY SERVICE IS AVAILABLE
BY CONTACTING THE NEAREST
SEARS SERVICE CENTER IN THE
UNITED STATES.
This warranty applies only while this
product is in use in the United States.
This warranty gives you specific legal
rights, and you may also have other
rights which vary from state to state.
Sears, Roebuck and Co., Dept. 817WA,
Hoffman Estates, IL 60179.
Your safety and the safety of others is very important.
We have provided many important safety messages in this manual
and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol. This symbol alerts
you to hazards that can kill or hurt you and others.
All safety messages will be preceded by the safety
alert symbol and the word “DANGER” or “W ARNING.”
These words mean:
Y ou will be killed or seriously
injured if you don’t follow
instructions.
WARNING
Y ou can be killed or seriously
injured if you don’t follow
instructions.
All safety messages will identify the hazard, tell you how to reduce the
chance of injury, and tell you what can happen if the instructions are
not followed.
DANGER
WARRANTY/SAFETY
4
IMPORT ANT SAFETY INSTRUCTIONS
YOUR SAFETY IS IMPORTANT TO US
W ARNING: To reduce the risk of fire,
electric shock, or injury to persons
when using your washer, follow basic
precautions, including the following:
• Read all instructions before using
the washer.
• Do not wash articles that have been
previously cleaned in, washed in, soaked
in, or spotted with gasoline, dry-cleaning
solvents, other flammable or explosive
substances as they give off vapors that
could ignite or explode.
• Do not add gasoline, dry-cleaning
solvents, or other flammable or explosive
substances to the wash water. These
substances give off vapors that could
ignite or explode.
• Under certain conditions, hydrogen gas
may be produced in a hot water system
that has not been used for 2 weeks or
more. HYDROGEN GAS IS EXPLOSIVE.
If the hot water system has not been
used for such a period, before using a
washing machine, turn on all hot water
faucets and let the water flow from each
for several minutes. This will release any
accumulated hydrogen gas. As the gas is
flammable, do not smoke or use an open
flame during this time.
• Do not allow children to play on or in
the washer. Close supervision of children
is necessary when the washer is used
near children.
• Before the washer is removed from
service or discarded, remove the lid.
• Do not reach into the washer if the tub
or agitator is moving.
• Do not install or store this washer where
it will be exposed to the weather.
• Do not tamper with controls.
• Do not repair or replace any part of the
washer or attempt any servicing unless
specifically recommended in the Owner’s
Manual or in published user-repair
instructions that you understand and
have the skills to carry out.
IMPORTANT: Observe all governing codes and ordinances.
SA VE THESE INSTRUCTIONS
5
INST ALLATION INSTRUCTIONS
U
39"
U
39"
U
INST ALLA TION OVERVIEW
A. SELECT LOCATION
FOR YOUR WASHER (pgs. 10-12)
Standpipe Drain System (p. 12) Floor Drain System (p. 12)
For a complete list of tools and parts
needed, see pages 6-8.
INSTALLATION
Laundry Tub Drain System (p. 11)
Recessed Area/
Closet Installation Instructions (p. 10)
6
B. REMOVE SHIPPING STRAP (p. 13)
Tools Needed:
Scissors
Tools Needed: Parts Needed:
C. CONNECT DRAIN HOSE (pgs. 14-15)
TWIST
AND
PUSH
Pliers that open
to 19/16 inches
OR
Flashlight (optional
depending on installation)
1 silver, double-
wire hose clamp
(bottom of drain
hose)
1 yellow, single-wire
hose clamp (top of
drain hose)
1 drain hose
Flashlight (optional
depending on installation)
7
Tools Needed:
Parts Needed:
E. CONNECT INLET HOSES TO W ATER FAUCETS (p. 16)
Parts Needed:Tools Needed:
D. CONNECT INLET HOSES TO WASHER ( pgs. 15-16)
Flashlight (optional
depending on installation)
Bucket
(optional
depending on
installation)
OR
2 water inlet hoses
OR
Pliers that open
to 19/16 inches
2 water inlet hoses
Flashlight (optional
depending on installation)
Pliers that open to 19/16 inches
4 flat water inlet hose washers
INSTALLATION
8
G. LEVEL WASHER (p. 18)
Parts Needed:
U
Tools Needed:
Tools Needed:
Parts Needed:
2 front leveling legs with nuts
Flashlight (optional
depending on installation)
Wood block
Level
Shipping strap with fastener
Flashlight (optional
depending on installation)
9
/16-Inch
open-end wrench
F. SECURE DRAIN HOSE (p. 17)
9
for your
Benefit
Selecting the proper location for your
washer will improve its performance
and minimize concerns like washer
walk or noise.
ELECTRICAL REQUIREMENTS
120-Volt, 60-Hz., AC-only, 15- or
20-ampere fused electrical supply is
required. (Time-delay fuse or circuit
breaker is recommended.) Connect to
individual branch circuit.
GROUNDING INSTRUCTIONS
W ARNING: Improper connection of
the equipment grounding conductor can
result in a risk of electric shock. Check
with a qualified electrician or serviceman
if you are in doubt as to whether the
appliance is properly grounded. Do not
modify the plug provided with the appliance – if it will not fit the outlet, have
a proper outlet installed by a qualified
electrician.
For your personal safety, this washer
must be grounded. In the event of
malfunction or breakdown, grounding
will reduce the risk of electric shock
by providing a path of least resistance
for electric current.
This washer is equipped with a power
supply cord having a 3-prong grounding
plug. To minimize possible shock hazard,
you must plug the power supply cord
into a mating 3-prong grounding-type
wall receptacle, grounded in accordance
with National Electrical Code, ANSI/NFPA
70-latest edition and all local codes and
ordinances.
WARNING
Electrical Shock Hazard
Plug into a grounded 3-prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
3-prong
grounding-type
wall receptacle
Power supply
cord
3-prong
grounding plug
Grounding
prong
INSTALLATION
10
Front View
(Door With Vent)
Side View
(Door Shown)
*Additional clearance for wall, door and floor moldings may be required.
Front View
(Door Not Shown)
19"
*1"
1"
4"
*1"
3"
3"
14" max.
48 sq. in.
minimum
ventilation
area
24 sq. in.
minimum
ventilation
area
To reduce transfer of washer sounds, a clearance of 1 inch on the sides of the washer is recommended.
27"
25
1
/2"
A. SELECT LOCATION
FOR YOUR WASHER –
RECESSED AREA/
CLOSET INSTALLATION INSTRUCTIONS
This washer may be installed in a recessed area or closet.
• The installation spacing is in inches
and is the minimum allowable.
• Allow additional space if other appliances are to be installed in the area.
• If closet door is installed, the minimum air openings in top and bottom
are required. Louvered doors with
equivalent air openings in top and
bottom are acceptable.
11
U
39"
LAUNDRY TUB DRAIN SYSTEM
Check location where washer will be
installed. This washer can be installed
using one of three systems:
• Laundry tub drain system (below)
• Standpipe drain system (p. 12)
• Floor drain system (p. 12)
Support: Floor must be sturdy
enough to support a total weight
of 315 pounds (including washer,
water, and load weight).
Level floor: Maximum
allowable slope under entire
washer – 1 inch.
Laundry tub drain system:
Needs a minimum 20-gallon
laundry tub.
Hot and cold water faucets:
Must provide water pressure
between 5-100 psi and be
within 4 feet of the hot and
cold water fill valves attached
to the back of the washer.
Grounded receptacle: Must
be within 4 feet of where the
power cord is attached to the
back of the washer.
Top of tub must be at
least 39 inches above
floor and no higher
than 96 inches from
bottom of washer.
INSTALLATION
Do not store or operate washer at or
below 32°F (some water may remain in
washer). See page 31 for Winterizing
Information.
Proper installation is your responsibility.
Make sure you have everything necessary
for correct installation including the
following points:
12
U
39"
U
If you have: You will need to buy:
Laundry tub or standpipe Sump pump system
taller than 96 inches (if not already available)
1-inch diameter standpipe 2-inch diameter to 1-inch diameter
standpipe adapter, Part No. 3363920
Overhead sewer Standard 20 gallon, 39-inch tall drain
tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain Siphon break, Part No. 285320;
additional drain hose, Part No. 3357090;
and Connector Kit, Part No. 285442
ALTERNATE LOCATIONS –
STANDPIPE AND FLOOR DRAIN SYSTEMS
Siphon break: Must be purchased
separately. See chart below.
Floor drain system: Requires a siphon
break, see chart below. A minimum carryaway capacity of 17 gallons per minute
is required.
Standpipe drain system: Needs a two-inch
minimum diameter standpipe with minimum
carry-away capacity of 17 gallons per minute.
Top of standpipe must be at least 39 inches
above floor and no higher than 96 inches
from bottom of washer.
Parts listed are available from your local Sears store or Sears Service Center.
Call 1-800-366-PART (1-800-366-7278).
Loading...