Kenmore 11028974891, 11028974890, 11028972891, 11028944891, 11028944890 Owner’s Manual

...

Owner's Manual and

Installation Instructions

Three-Speed Triple Dispenser

AUTOMATIC WASHERS

IMPORTANT:

Read and follow all safety and operating instructions

before first use of this product.

Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.

PART NO. 395;0143 Rev. A PRINTED IN U.S.A.

Your washer may look different from the washer shown.

BEFORE USING YOUR NEW WASHER

SEARS AUTOMATIC WASHER WARRANTY

IMPORTANT SAFETY INSTRUCTIONS

INSTALLATION INSTRUCTIONS

OPERATING YOUR WASHER

LAUNDRY TIPS

CARING FOR YOUR WASHER

TROUBLESHOOTING

SEARS MAINTENANCE AGREEMENT

Please read this manual. It will help

you install and operate your new

Kenmore washer in the safest and most economical way.

For more information about the care

and operation of Kenmore appliances call your neare,.st Sears store. You will

need the complete model and serial numbers when requesting information.

Your washer's model and serial numbers are located on the Model and Serial

Number Plate.

Use the space below to record the model number and serial number of your new Kenmore Washer.

Model No.

Serial No.

Date of Purchase

-- _ ' ModelandSerial

Keep this book and your Sears

Salescheck (receipt) in a safe

NumberPlate

place for future reference.

FUI_L 1-YEAR WARRANTY ON MECHANICAL AND

ELI-CTRICAL PARTS For one year from the date of purchase,

when the washer is installed and operated in accordance with the instructions in

the Owner's Manual, Sears will repair or replace any mechanical or electrical parts

in this washer, if defective in material or workmanship.

LIMITED 5-YEAR WARRANTY

ON GEARCASE PARTS

After one year and until five years from the date of purchase, Sears will fumish

replacement parts for any defective gear- case parts. You will be charged for labor.

LIMITED 10-YEAR WARRANTY

ON PLASTIC TUB

After one year and until ten years from date of purchase, Sears will furnish a

replacement plastic tub for any' plastic

tub which is defective in material or work-

manship. You will be charged for labor. If the washer is subjected to other than

private family use, the above warranty

coverage is effective for only 90 days. WARRANTY SERVICE IS AVAILABLE

BY CONTACTING THE NEAREST SEARS SERVICE CENTER IN THE UNITED STATES.

This warranty applies only while this

product is in use in the United States.

This warranty gives you specific legal

rights, and you may also have other rights which vary from state to state.

Sears, Roebuck and Co., Dept. 817WA,

Hoffman Estates, IL 60179.

Your safety and the safety of others is very important.,

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol. This symbol alerts; you to hazards that can kill or hurt you and others.

All safety messages will be preceded by the safety alert symbol and the word "DANGER" or "WARNING:'

These words mean:

You will be killed or seriously

injured if you don't follow instructions.

You can be killed or seriously

injured if you don't follow instructions.

All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are

not followed.

YOUR SAFETY IS IMPORTANT TO US.

WAFINING: To reduce the risk of fire,

electric shock, or injury to persons

when using your washer, follow basic

precautions, including the following:

• Read all instructions before using the washer.

• Do not wash articles that have been previously cleaned in, washed in, soaked

in, or spotted with gasoline, dry-cleaning solvents, other flammable or explosive

substances as they give off vapors that co_JIdignite or explode.

• Do not add gasoline, dry-cleaning solvents, or other flammable or explosive

su_)stances to the wash water. These substances give off vapors that could

ignite or explode.

• Under certain conditions, hydrogen gas may be produced in a hot water system

that has not been used for 2 weeks or more. HYDROGEN GAS IS EXPLOSIVE.

If the hot water system has not been used for such a period, before using a

washing machine, turn on all hot water faucets and let the water flow from each

for several minutes. This will release any accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame during this time.

• Do not allow children to play on or in the washer. Close supervision of children

is necessary when the washer is used near children.

• Before the washer is removed from service or discarded, remove the lid.

° Do not reach into the washer if the tub

or agitator is moving.

• Do not install or store this washer where it will be exposed to the weather.

• Do not tamper with controls.

• Do not repair or replace any part of the washer or attempt any servicing unless

specifically recommended in the Owner's Manual or in published user-repair instructions that you understand and have the skills to carry out.

SAVE THESE INSTRUCTIONS

INSTALLATION OVERVIEW

For a complete list of tools and parts needed, see pages 6-8.

A. SELECT LOCATION

FOR YOUR WASHER (pgs. 10-12) Recessed Area/

Closet Installation Instructions (p. 10)

LaundryTub Drain System (p. 11)

3g"

',Standpipe Drain System (p. 12)

Floor Drain System (p. 12)

B. FIEMOVE SHIPPING STRAP (p. 13)

Tools Needed::

Scissors Flashlight (optional

depending on installation)

C. CONNECT DRAIN HOSE (pgs. 14-15)

Tools Needed: Parts Needed:

Pliers that open

to 19/16inches

drain hose

Flashlight (optional

depending on installation)

1 yellow, single-wire

hose clamp (top of

drain hose)

1 silver, double-wire hose clamp (bottom

of drain hose)

D. CONNECT INLET HOSES TO WATER FAUCETS (pgs. 15-16)

Tools Needed: Parts Needed:

Pliers that open to 19/16inches

Bucket _!_ (optional

depending on

installation)

Flashlight (optional depending on installation)

2 flat water fill hose washers

E. SECURE DRAIN HOSE (p. 17)

Tools Needed: Parts Needed:

Flashlight (optional

depending on installation)

Shipping strap with fastener

F. LEVEL WASHER (p. 18)

Tools Needed: Parts Needed:

9/16-Inch

open-end wrench

Flashlight (optional

depending on installation)

Level

2 front leveling legs with nuts

Wood block

Selecting the proper location for your washer will improve its performance and minimize concerns like washer

walk or noise.

ELI-CTRICAt. REQUIREMENTS 120-Volt, 60-Hz., AC-only, 15- or

20-ampere fused electrical supply is

required. (Time-delay fuse or circuit

breaker is recommended.) Connect to

indMdual branch circuit.

Electri(-al Shock Hazard

Plug into a grounded 3-prong

o_utlet.

Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions

can result in death, fire, or electrical shock.

GROUNDING INSTRUCTIONS WARNING: Improper connection of

the equipment grounding conductor can result in a risk of electric shock. Check

with a qualified electrician or serviceman if you are in doubt as to whether the

appliance is properly grounded. Do not modify the plug provided with the appli- ance - if it will not fit the outlet, have

a proper outlet installed by a qualified electrician.

For your personal safety, this washer

must be grounded. In the event of malfunction or breakdown, grounding

will reduce the risk of electric shock by providing a path of least resistance

for electric current. This washer is equipped with a power

supply cord having a 3-prong !grounding

plug. To minimize possible shock hazard,

you must plug the power supply cord

into a mating 3-prong grounding-type

wall receptacle, grounded in accordance with National Electrical Code, ANSl/NFPA

70-latest edition and all local codes and

ordinances.

Grounding-Type

3-Prong

Grounding Plug

Wall Receptacle

3-Prong

_ding

Power Supply

Cord

A. SELECT LOCATION

FOR YOUR WASHER -

RECESSED AREA/

CLOSET INSTALLATION INSTRUCTIONS This washer may be installed in a recessed area or closet.

48 sq.in.

minimum

ventilation

area

24 sq. in. minimum-

ventilation

area

"1"--_ J_--'27"'--'_ ]4F--'1" --_1"_(--251/2"--_ 4" J_--

Front:View Side View FrontView

(Door Not Shown) (Door Shown) (Door With Vent)

*Additional clearance for wall, door and floor moldings may be required.

To reduce transfer of washer sounds,a clearance of I inch onthe sides of thewasher is recommended.

• The installation spacing is in inches and is the minimum allowable.

• Allow additional space if other appli- ances are to be installed in the area.

• If closet door is installed, the mini- mum air openings in top and bottom

are required. Louvered door.,; with

equivalent air openings in top and bottom are acceptable.

LAUNDRY TUB DRAIN SYSTEM Check location where washer will be

installed. This washer can be installed using one of three systems:

• Laundry tub drain system (below)

• Standpipe drain system (p. 12)

• Floor drain system (p. 12)

Grounded receptacle: Must be within 4 feet ,of where the

power cord is attached to the back of the washer.

Hot and cold water faucets: Must provide water pressure

between 20-100 psi and be within 4 feet of the hot and

cold water fill valves attached to the back of the washer. Laundry tub drain system:

Do not store or operate washer at or below 32°F (some water may remain in

washer). See page 33 for Winterizing Information.

Proper installation is your responsibility. Make sure you have everything necessary

for correct installation including the following points:

Needs a minimum 20-gallon

laundry tub.

Support: Floor must be sturdy enough to support a total weight

of 315 pounds ,',including washer, water, and load weight).

Level floor: Maximum least 39 inches above allowable slope under entire floor and no higher

washer - 1 inch. than 96 inches from

bottom of washer.

ALTERNATE LOCATIONS - STANDPIPE AND FLOOR DRAIN SYSTEMS

Siphon break: Must be purchased

separately. See chart below.

Standpipe drain system: Needs a two-inch minimum diameter standpipe with minimum

carry-away capacity of 17 gallons per minute. Top oi=standpipe must be at least 39 inches

above, floor and no higher than 96 inches from bottom of washer.

Floor drain system: Requires a siphon break, see chart below. A minimum carry-

away capacity of 17 gallons per minute is required.

If you have: You will need to buy: Laundry tub or standpipe Sump pump system

taller than 96 inches (if not already available)

1-inch diameter standpipe 2-inch diameter to 1-inch diameter

standpipe adapter, Part No. 336:3920

Overhead sewer Standard 20 gallon, 39-inch tall drain

tub or utility sink and sump pump (available from local plumbing suppliers)

Floor drain Siphon break, Part No. 285320;

additional drain hose, Part No. 3357090; and Connector Kit, Part No. 285442

Parts listed are available from your local Sears store or Sears Service Center.

Call 1-800-366-PART (1-800-366-7278).

+ 28 hidden pages